wheel torque YAMAHA YFZ450 2006 Notices Demploi (in French)
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2006, Model line: YFZ450, Model: YAMAHA YFZ450 2006Pages: 444, PDF Size: 5.69 MB
Page 356 of 444
8-99
5. Screw in the adjusting bolt at the rear
brake caliper by hand until it feels tight,
then screw it out 1/8 turn. Tighten the lock-
nut to the specified torque.
cC
When tightening the locknut, hold the adjust-
ing bolt with a wrench so that the adjusting
bolt does not turn together with the locknut.
w
Operating with improperly adjusted brakes
could cause the brakes to malfunction, result-
ing in reduced braking performance. This
could increase the chance of a collision or
accident. After adjusting the parking brake,
block the rear of the machine off the ground
and spin the rear wheels. Check to make sure
there is no brake drag. If brake drag is noticed,
perform the adjustment again.
Tightening torque:
Locknut:
16 Nm (1.6 m0kgf)
5TG-9-62 9-11 5/12/05 6:14 PM Page 8-99
Page 384 of 444
8-127
EBU07390
Wheel installation
When installing the wheel, reverse the removal
procedure.
NOTE:
The arrow mark on the tire must point
toward the rotating direction of the wheel.
Tighten the wheel nuts to the specified torque.1. Arrow mark1. Flèche1. Flecha
Wheel nut torque:
Front: 45 Nm (4.5 m0kgf)
Rear: 45 Nm (4.5 m0kgf)
5TG-9-62 9-11 5/12/05 6:14 PM Page 8-127