coolant YAMAHA YFZ450 2006 User Guide

8-49
5. Remove the coolant reservoir by removing
the bolts.
6. Remove the coolant reservoir cap, and
then turn the coolant reservoir upside
down to empty it.
7. After draining the coolant, thoroughly flush
the cooling system with clean tap water.
8. Install the coolant reservoir by installing the
bolts.
9. Replace the coolant drain bolt washer if it
is damaged, and then tighten the coolant
drain bolt to the specified torque.
10. Pour the recommended coolant into the
radiator until it is full.
11. Pour the recommended coolant into the
coolant reservoir to the maximum level
mark.
1. Coolant reservoir cap
2. Coolant reservoir 3. Bolt (×2)
1. Bouchon de vase d’expansion
2. Vase d’expansion 3. Boulon (×2)1. Tapa del depósito de refrigerante
2. Depósito de refrigerante 3. Perno (×2)
Tightening torque:
Coolant drain bolt:
10 Nm (1.0 m0kgf)
5TG-9-62 8 5/13/05 1:48 PM Page 8-49

8-51
Recommended antifreeze:
High quality ethylene glycol antifreeze
containing corrosion inhibitors for
aluminum engines.
Antifreeze and water mixing ratio:
1:1
Total amount:
1.30 L
Coolant reservoir capacity
(up to the maximum level mark):
0.29 L
5TG-9-62 8 5/13/05 1:48 PM Page 8-51

8-53
cC
Hard water or salt water is harmful to the
engine. You may use soft water if you cannot
get distilled water.
12. Install the radiator cap and the coolant
reservoir cap.
13. Start the engine and let it idle for several
minutes. Stop the engine, and then check
the coolant level in the radiator. If it is low,
add more coolant until it reaches the top of
the radiator.
14. Check the coolant level in the reservoir. If it
is low, add coolant to the maximum level
mark.
15. Start the engine and then check for coolant
leakage.
NOTE:
If any leakage is found, have a Yamaha dealer
check the cooling system.
16. Install the panel.
5TG-9-62 8 5/13/05 1:48 PM Page 8-53

8-150
Engine overheating
NOTE:
If it is difficult to get the recommended coolant, tap water can be temporarily used, provided that it is
changed to the recommended coolant as soon as possible.
w
Wait for the engine and radiator to cool before removing the radiator cap. You could be burned
by hot fluid and steam blown out under pressure. Always put a thick rag over the cap when
opening. Allow any remaining pressure to escape before completely removing the cap.
Wait until the
engine has cooled.Check the coolant level in the
reservoir tank and/or radiator.
Level is OK.
Level is low, check the
cooling system for leakage.
No
leakage.
Leakage.Ask a Yamaha dealer
to inspect and repair
the cooling system.
Add coolant.
(See NOTE.)
Restart the engine. If the engine overheats
again, ask a Yamaha dealer to inspect and/or
repair the cooling system.
5TG-9-62 9-11 5/12/05 6:14 PM Page 8-150

10-3
Model YFZ450V
Cooling system:
Radiator capacity (Including all routes) 1.30 L
Coolant reservoir capacity
(Up to the maximum level mark) 0.29 L
Air filter: Wet type element
Fuel:
Type PREMIUM UNLEADED GASOLINE ONLY
For Europe:
PREMIUM UNLEADED GASOLINE ONLY with
a research octane number of 97 or higher
Tank capacity 10.0 L
Reserve amount 1.9 L
Carburetor:
Type ×quantity FCR39H ×1
Manufacturer KEIHIN
Spark plug:
Type/manufacturer CR8E/NGK
Spark plug gap 0.7–0.8 mm
Clutch :
Type Wet, multiple-disc
Operation Left hand operation
5TG-9-62 9-11 5/12/05 6:14 PM Page 10-3

10-6
Model YFZ450V
Bulb voltage, wattage ×quantity:
Headlight 12V, 30W/30W ×2
Tail/brake light LED
Indicator/warning light
Neutral 12V, 1.7W ×1
Coolant temperature 12V, 1.7W ×1
Fuses:
Main 15.0 A
5TG-9-62 9-11 5/12/05 6:14 PM Page 10-6