electrical YAMAHA YFZ450 2006 Owners Manual

4-1
EBU00400
CONTROL FUNCTIONS
EBU00420
Main switch
Functions of the respective switch positions are
as follows:
ON:
The engine can be started only at this position.
OFF:
All electrical circuits are switched off. The key
can be removed in this position.
OFF ON
5TG-9-62 4 5/12/05 5:18 PM Page 4-1

4-3
1. Neutral indicator light “N”
2. Coolant temperature warning light “ ”
1. Témoin de point mort “N”
2. Témoin d’avvertissement de la température du liquide de
refroidissement “ ”
1. Luz de control de punto muerto “N”
2. Luz de aviso de la temperatura del refrigerante “ ”
EBU08020
Indicator and warning lights
EBU06030
Neutral indicator light “N”
This indicator light comes on when the transmis-
sion is in neutral.
EBU13850
Coolant temperature warning light “ ”
When the coolant temperature reaches a speci-
fied level, this light comes on to warn that the
coolant temperature is too hot. If the light comes
on during operation, stop the engine as soon as
it is safe to do so and allow the engine to cool
down for about 10 minutes.
The electrical circuit of the warning light can be
checked according to the following procedures.
1. Set the engine stop switch to “RUN” and
turn the key to “ON”.
2. Shift the transmission into the neutral posi-
tion or pull the clutch lever.
5TG-9-62 4 5/12/05 5:18 PM Page 4-3

4-5
3. Push the start switch. If the warning light
does not come on while the start switch is
pushed, have a Yamaha dealer check the
electrical circuit.
cC
8The engine may overheat if the ATV is
overloaded. If this happens, reduce the
load to specification.
8Restart after making sure that the light is
off. Continuous use while the light is on
may cause damage to the engine.
5TG-9-62 4 5/12/05 5:18 PM Page 4-5

8-1
EBU05160
PERIODIC MAINTENANCE AND
ADJUSTMENT
Periodic inspection, adjustment and lubrication
will keep your machine in the safest and most
efficient condition possible. Safety is an obliga-
tion of the machine owner. The most important
points of machine inspection, adjustment and
lubrication are explained on the following pages.
w
Never service an engine while it is running.
Moving parts can catch clothing or parts of
the body, causing injury. Electrical compo-
nents can cause shocks or can start fires.
Turn off the engine when performing mainte-
nance unless otherwise specified. Have a
Yamaha dealer perform service if you are not
familiar with machine service.
5TG-9-62 7 5/12/05 4:29 PM Page 224

8-135
EBU03910
Fuse replacement
1. The fuse case is located under the seat.
2. If the fuse is blown, turn off the main switch
and install a new fuse of the specified
amperage. Then turn on the switches. If
the fuse immediately blows again, consult
a Yamaha dealer.
w
Always use a fuse of the specified rating.
Never use a material in place of the proper
fuse. An improper fuse can cause damage to
the electrical system which could lead to a
fire.
cC
To prevent accidental short-circuiting, turn
off the main switch when checking or replac-
ing a fuse.
1. Fuse 2. Spare fuse1. Fusible 2. Fusible de rechange1. Fusible 2. Fusible de repuesto
Specified fuse: 15.0A
5TG-9-62 9-11 5/12/05 6:14 PM Page 8-135

9-3
cC
Excessive water pressure may cause water
seepage and deterioration of wheel bearings,
brakes, transmission seals and electrical
devices. Many expensive repair bills have
resulted from improper high pressure deter-
gent applications such as those available in
coin-operated car washers.
4. Once the majority of the dirt has been
hosed off, wash all surfaces with warm
water and mild, detergent-type soap. An
old toothbrush or bottle brush is handy for
hard-to-get-at places.
5. Rinse the machine off immediately with
clean water and dry all surfaces with a
chamois, clean towel or soft absorbent
cloth.
6. Dry the chain and lubricate it to prevent
rust.
7. Clean the seat with a vinyl upholstery
cleaner to keep the cover pliable and
glossy.
5TG-9-62 9-11 5/12/05 6:14 PM Page 9-3

10-5
Model YFZ450V
Brake:
Front brake type Dual disc brake
operation Right hand operation
Rear brake type Single disc brake
operation Right foot operation
Suspension:
Front suspension Double wishbone
Rear suspension Swingarm (link suspension)
Shock absorber:
Front shock absorber Coil spring/Gas-Oil damper
Rear shock absorber Coil spring/Gas-Oil damper
Wheel travel:
Front wheel travel 230.0 mm
Rear wheel travel 270.0 mm
Electrical:
Ignition system D.C. C.D.I.
Generator system A.C. magneto
Battery type/voltage capacity GT7B-4/12V, 6.5 Ah
Headlight type: Krypton bulb
5TG-9-62 9-11 5/12/05 6:14 PM Page 10-5