light YAMAHA YFZ450R 2009 Owner's Manual
[x] Cancel search | Manufacturer: YAMAHA, Model Year: 2009, Model line: YFZ450R, Model: YAMAHA YFZ450R 2009Pages: 150, PDF Size: 6.36 MB
Page 129 of 150

8-46
1
2
3
4
5
6
78
9
10
11
EBU25242
Replacing the fuse
The fuse holder is located under the seat. (See
page 4-10.)
If the fuse is blown, replace it as follows.
1. Turn the key to “OFF” and turn off all electrical
circuits.
NOTICE
ECB00640
To prevent accidental short-circuiting, turn off
the main switch when checking or replacing a
fuse.
2. Remove the blown fuse, and then install a
new fuse of the specified amperage.
WARNING
EWB02171
Always use a fuse of the specified rating, and
never use a substitute object in place of the
proper fuse. An improper fuse or a substitute
object can cause damage to the electrical sys-
tem, which could lead to a fire.
3. Turn the key to “ON” and turn on the electrical
circuits to check if the devices operate.
4. If the fuse immediately blows again, have a
Yamaha dealer check the electrical system.
EBU29460
Replacing a headlight bulb
If a headlight bulb burns out, replace it as follows.
1. Remove panel E. (See page 8-8.)
2. Remove the headlight bulb holder cover.
1. Fuse
2. Spare fuse
1
2
Specified fuse:
20.0 A
Page 130 of 150

8-47
1
2
3
4
5
6
78
9
10
11
3. Remove the headlight bulb holder by pushing
it in and turning it counterclockwise, and then
remove the burnt-out bulb.
WARNING
EWB02230
Do not touch a headlight bulb when it is on or
immediately after it is turned off. You can be
burned or a fire could start if the bulb touches
something flammable. Wait for the bulb to cool
before touching or removing it.
4. Place a new headlight bulb into position.
1. Headlight bulb holder cover
1
1. Headlight bulb holder
1
Page 131 of 150

8-48
1
2
3
4
5
6
78
9
10
11
NOTICE
ECB00650
Do not touch the glass part of the headlight
bulb to keep it free from oil, otherwise the
transparency of the glass, the luminosity of the
bulb, and the bulb life will be adversely affect-
ed. Thoroughly clean off any dirt and finger-
prints on the headlight bulb using a cloth
moistened with alcohol or thinner.
5. Install the headlight bulb holder by pushing it
in and turning it clockwise.
6. Install the headlight bulb holder cover.7. Install the panel.
8. Adjust the headlight beam if necessary.
EBU25551
Adjusting a headlight beam
NOTICE
ECB00690
It is advisable to have a Yamaha dealer make
this adjustment.
To raise a headlight beam, turn the headlight beam
adjusting screw in direction (a).
To lower a headlight beam, turn the adjusting
screw in direction (b).
1. Do not touch the glass part of the bulb.
1. Headlight beam adjusting screw1
(a)
(b)
Page 132 of 150

8-49
1
2
3
4
5
6
78
9
10
11
EBU26920
Tail/brake light
This model is equipped with an LED type of tail/
brake light.
If the tail/brake light does not come on, have a
Yamaha dealer check it.
EBU25651
Removing a wheel
1. Place the ATV on a level surface.
2. Loosen the wheel nuts.
FrontRear
3. Elevate the ATV and place a suitable stand
under the frame.
4. Remove the nuts from the wheel.
5. Remove the wheel.
EBU25681
Installing a wheel
1. Place the ATV on a level surface.
2. Install the wheel and the nuts.
TIP
When installing a front wheel, make sure its ar-
row mark points toward the rotating direction
1. Wheel nut
1. Wheel nut
Page 134 of 150

8-51
1
2
3
4
5
6
78
9
10
11
WARNING
EWB02280
Do not smoke when checking the fuel system.
Fuel can ignite or explode, causing severe inju-
ry or property damage. Make sure there are no
open flames or sparks in the area, including pi-
lot lights from water heaters or furnaces.
Page 143 of 150

10-4
1
2
3
4
5
6
7
8
910
11
Operation:
Right hand operation
Recommended fluid:
DOT 4
Rear brake:
Type:
Single disc brake
Operation:
Right foot operation
Recommended fluid:
DOT 4
Front suspension:
Type:
Double wishbone
Spring/shock absorber type:
Coil spring/gas-oil damper
Wheel travel:
250 mm (9.9 in)
Rear suspension:
Type:
Swingarm (link suspension)
Spring/shock absorber type:
Coil spring/gas-oil damper
Wheel travel:
280 mm (11.0 in)
Electrical system:
Ignition system:
TCI (digital)
Charging system:
AC magneto
Battery:
Model:
YTZ-7S
Voltage, capacity:
12 V, 6.0 Ah
Headlight:
Bulb type:
Krypton bulb
Bulb voltage, wattage
×× × ×
quantity:
Headlight:
12 V, 30/30 W
×
2
Tail/brake light:
LED
Neutral indicator light:
LED
Fuel level warning light:
LED
Coolant temperature warning light:
LED
Engine trouble warning light:
LED
Fuses:
Main fuse:
20.0 A
Page 147 of 150

INDEX
A
Accessories and loading ................................................ 6-5
Air filter element, cleaning ............................................ 8-23
B
Battery .......................................................................... 8-43
Brake and clutch levers, checking and lubricating ....... 8-40
Brake fluid, changing.................................................... 8-32
Brake fluid level, checking............................................ 8-30
Brake lever ..................................................................... 4-6
Brake lever free play, checking the front ...................... 8-32
Brake light switches ..................................................... 8-35
Brake pads, checking the front and rear ...................... 8-29
Brake pedal .................................................................... 4-7
Brake pedal, checking and lubricating ......................... 8-41
Brake pedal position, checking .................................... 8-33
Brakes, front and rear .................................................... 5-4
C
Cables, checking and lubricating ................................. 8-40
Chassis fasteners........................................................... 5-8
Cleaning ......................................................................... 9-1
Clutch lever .................................................................... 4-6
Clutch lever free play, adjusting ................................... 8-36
Coolant ................................................................. 5-4
,
8-19
Coolant temperature warning light ................................. 4-2
D
Drive chain ..................................................................... 5-5Drive chain, lubricating ................................................. 8-39
Drive chain slack .......................................................... 8-37
E
Engine break-in .............................................................. 6-4
Engine oil ....................................................................... 5-4
Engine oil and oil filter element .................................... 8-14
Engine, start ................................................................... 6-1
Engine stop switch ......................................................... 4-3
Engine trouble warning light ........................................... 4-3
F
Fuel ........................................................................ 4-9
,
5-4
Fuel level warning light................................................... 4-2
Fuel tank cap.................................................................. 4-8
Fuse, replacing............................................................. 8-46
H
Handlebar position, adjusting ....................................... 4-24
Handlebar switches ........................................................ 4-3
Headlight beam, adjusting............................................ 8-48
Headlight bulb, replacing.............................................. 8-46
I
Identification numbers .................................................. 11-1
Indicator light and warning lights .................................... 4-2
Instruments, lights and switches .................................... 5-8
K
Key identification number ............................................. 11-1
Page 148 of 150

L
Label locations ................................................................2-1
Light switch .....................................................................4-3
M
Main switch .....................................................................4-1
Maintenance and lubrication chart ..................................8-4
Maintenance chart, emission control system ..................8-3
Model label....................................................................11-2
N
Neutral indicator light ......................................................4-2
O
Owner’s manual and tool kit............................................8-1
P
Panels, removing and installing ......................................8-8
Parking ............................................................................6-4
Parking brake free play, adjusting.................................8-34
Parking brake lever .........................................................4-7
Parking on a slope ..........................................................6-5
Part locations ..................................................................3-1
Pre-operation check list ..................................................5-1
R
Riding your ATV ..............................................................7-1
S
Safety information ...........................................................1-1
Seat...............................................................................4-10
Shifting ............................................................................6-2
Shift pedal .......................................................................4-8
Shift pedal, checking .....................................................8-41
Shock absorber assemblies, adjusting the front ...........4-11
Shock absorber assembly, adjusting the rear ...............4-16
Spark arrester, cleaning ................................................8-27Spark plug, checking.................................................... 8-13
Specifications ............................................................... 10-1
Speed limiter .................................................................. 4-5
Start switch .................................................................... 4-3
Storage .......................................................................... 9-2
Suspension, lubricating the upper and lower arm
pivots ......................................................................... 8-42
Swingarm pivots, lubricating ........................................ 8-42
T
Tail/brake light.............................................................. 8-49
Throttle cable free play, adjusting ................................ 8-28
Throttle lever ...........................................................4-4
,
5-5
Tire pressure, measuring ............................................... 5-6
Tires ............................................................................... 5-5
Tire wear limit................................................................. 5-7
Troubleshooting ........................................................... 8-50
Troubleshooting charts ................................................ 8-52
V
Valve clearance ........................................................... 8-29
Vehicle identification number ....................................... 11-1
W
Wheel hub bearings, checking ..................................... 8-42
Wheel, installing ........................................................... 8-49
Wheel, removing .......................................................... 8-49