tires YAMAHA YFZ50 2017 User Guide

8-6
8
5*Wheels • Check runout and for damage, and replace if nec-
essary. √ √√√
6 *Tires • Check tread depth and for damage, and replace if
necessary.
• Check air pressure and balance, and correct if necessary. √ √√√
7 *Wheel hub bearings • Check for looseness or damage, and replace if
necessary. √ √√√
8 *Front arm pivots • Lubricate with lithium-soap-based grease. √√√
9Drive chain • Check chain slack and adjust if necessary.
• Check rear wheel alignment and correct if neces-
sary.
• Clean and lubricate. √√√√√
10 *V- b e l t • Check for wear, cracks or other damage, and re-
place if necessary. √ √√√
11 *Chassis fasteners • Make sure that all nuts, bolts, and screws are
properly tightened. √√√√√
12 *Shock absorber as-
semblies • Check operation and correct if necessary.
• Check for oil leakage and replace if necessary.
√√√
13 *Front knuckle piv-
ots • Lubricate with lithium-soap-based grease.
√√√
14 *Steering shaft • Lubricate with lithium-soap-based grease. √√√
NO. ITEM
CHECK OR MAINTENANCE
JOB INITIAL EVERY
Whichev-
er comes first month136612
km (mi) 240
(150) 1300
(800) 2500
(1600) 2500
(1600) 5000
(3200)
hours 20 80 160 160 320UBW460E0.book Page 6 Tues day, June 7, 2016 4:17 PM

8-26
8
TIPAfter adjusting the brake lever free play, check the
rear brake shoes for wear. EBU34013Drive chain slackThe drive chain slack should be checked before
each ride and adjusted if necessary.
To check the drive chain slack1. Place the ATV on a level surface.
TIPWhen checking and adjusting the drive chain
slack, there should be no weight on the ATV and
all tires must be touching the ground. 2. Move the ATV back and forth to locate the tightest portion of the drive chain, and then
measure the drive chain slack as shown.
3. If the drive chain slack is incorrect, adjust it as follows.
1. Rear brake lever free play adjusting nut
1
(a)
(b)
Drive chain slack:6.0–12.0 mm (0.24–0.47 in)1. Drive chain slack
1
UBW460E0.book Page 26 Monday, May 23, 2016 11:12 AM

9-3
9
7. Check and, if necessary, correct the tire air
pressure, and then block up the ATV so that
all of its wheels are off the ground. Alterna-
tively, turn the wheels a little every month in
order to prevent the tires from becoming de-
graded in one spot.
8. Cover the muffler outlet with a plastic bag to prevent moisture from entering it.
9. Remove the battery and fully charge it. Store it in a cool, dry place and charge it once a
month. Do not store the battery in an exces-
sively cold or warm place [less than 0 °C (30
°F) or more than 30 °C (90 °F)]. For more infor-
mation on storing the battery, see page 8-32.
TIPMake any necessary repairs before storing the
ATV. UBW460E0.book Page 3 Monday, May 23, 2016 11:12 AM

10-3
10
Caster angle:1.10 °
Trail: 10.4 mm (0.41 in)Front tire:Type:Tubeless
Size: AT16 x 6.5-7
Manufacturer/model:
DURO/DI2040Rear tire:Type:Tubeless
Size:
AT16 x 7-7
Manufacturer/model: DURO/DI2041Loading:Maximum loading limit:
41.0 kg (90 lb)
(Total weight of rider, cargo, accessories, and tongue)Tire air pressure (measured on cold tires):Recommended:Front:
13.8 kPa (0.14 kgf/cm², 2.0 psi)
Rear: 13.8 kPa (0.14 kgf/cm², 2.0 psi)
Minimum: Front: 12.4 kPa (0.124 kgf/cm², 1.8 psi) Rear:
12.4 kPa (0.124 kgf/cm², 1.8 psi)
Front wheel:Wheel type:
Panel wheel
Rim size: 7 x 5.2ATRear wheel:Wheel type:
Panel wheel
Rim size: 7 x 5.2ATFront brake:Type:
Mechanical leading, trailing drum brake
Operation: Right hand operationRear brake:Type:
Mechanical leading, trailing drum brake
Operation: Left hand operationFront suspension:Type:
Swing axle
Spring/shock absorber type: Coil spring/oil damper
Wheel travel: 60 mm (2.4 in)
UBW460E0.book Page 3 Monday, May 23, 2016 11:12 AM

12-2
12
Part locations ................................................................. 3-1RRiding your ATV ............................................................. 7-1SSafety information .......................................................... 2-1
Seat .............................................................................. 4-12
Shock absorber assembly, adjusting the rear ............. 4-13
Spark arrester, cleaning ............................................... 8-19
Spark plug, checking ..................................................... 8-9
Specifications .............................................................. 10-1
Speed limiter .................................................................. 4-3
Starter (choke) ............................................................. 4-11
Start switch .................................................................... 4-2
Steering shaft, lubricating ............................................ 8-31
Storage .......................................................................... 9-2TThrottle lever ...........................................................4-3, 5-3
Throttle lever free play, adjusting ................................ 8-21
Tires ............................................................................... 5-3
Transmission oil ....................................................5-3, 8-14
Troubleshooting ........................................................... 8-37
Troubleshooting chart .................................................. 8-38VValve clearance ............................................................ 8-22
Vehicle identification number ...................................... 11-1WWheel hub bearings, checking .................................... 8-30
Wheel, installing ........................................................... 8-36
Wheel, removing .......................................................... 8-35
UBW460E0.book Page 2 Monday, May 23, 2016 11:12 AM