low beam YAMAHA YS125 2017 Owners Manual

Instrument and control functions
3-5
3 Transmission
gear display
This display shows the selected gear.
The neutral position, however, is not
displayed, it is indicated by the neutral
indicator light.
EAU1234M
Han dle bar switchesLeft
Ri ght
EAU12352
Pass switch “ ”
Press this switch to flash the headlight.TIPWhen the dimmer switch is set
to “ ”, the passing switch has no ef-
fect.
EAU12401
Dimmer switch “ / ”
Set this switch to “ ” for the high
beam and to “ ” for the low beam.
EAU12461
Turn si gnal switch “ / ”
To signal a right-hand turn, push this
switch to “ ”. To signal a left-hand
turn, push this switch to “ ”. When
released, the switch returns to the cen-
ter position. To cancel the turn signal
lights, push the switch in after it has re-
turned to the center position.
EAU12501
Horn switch “ ”
Press this switch to sound the horn.
1. Transmission gear display
1
1. Pass switch “ ”
2. Dimmer switch “ / ”
3. Turn signal switch “ / ”
4. Horn switch “ ”
1. Start switch “ ”
12
34
1
UBT4E0E0.book Page 5 Thursday, November 17, 2016 10:55 AM

Periodic maintenance an d a djustment
6-34
6
4. Disconnect the headlight coupler,
then remove the headlight bulb
cover.
5. Unhook the headlight bulb holder, then remove the burnt-out bulb. 6. Place a new headlight bulb into
position, then secure it with the
bulb holder.
7. Install the headlight bulb cover, then connect the headlight cou-
pler.
8. Place the headlight unit in its orig- inal position, and then tighten the
headlight unit stay bolt to the
specified torque.
9. Install the bolt on each side.
10. Place the headlight unit side cov- ers in their original position, and
then install the screw on each
side.
11. Have a Yamaha dealer adjust the headlight beam if necessary.
EAU45226
Replacin g the auxiliary li ght
b ul b If the auxiliary light bulb burns out, re-
place it as follows.
1. Remove the headlight unit. (See page 6-33.)
2. Remove the auxiliary light bulb socket (together with the bulb) by
pulling it out.
3. Remove the burnt-out bulb by pulling it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the bulb) by pushing it in.
6. Install the headlight unit.
1. Headlight coupler
2. Headlight bulb holder
1. Headlight bulb holder
2. Headlight bulb
1 21
2
Ti
ghtenin g torque:
Headlight unit stay bolt: 7 N·m (0.7 kgf·m, 5.1 lb·ft)
1. Auxiliary light bulb
2. Auxiliary light bulb socket
1
2
UBT4E0E0.book Page 34 Thursday, November 17, 2016 10:55 AM