light YAMAHA YXZ1000R 2020 Owner's Guide

9-45
9
2. Remove the tailpipe bolts.
3. Remove the tailpipe by pulling it out ofthe muffler, and then remove the gasket.
4. Tap the tailpipe lightly, and then use a wire brush to remove any carbon depos-
its from the spark arrester portion of the
tailpipe and inside of the tailpipe housing. 5. Install the gasket, and then insert the tail-
pipe into the muffler and align the bolt
holes.
6. Install the tailpipe bolts and tighten them
to the specified torque.
7. Install the tailpipe cover.1. Tailpipe bolt
1
1
1. Gasket
2. Spark arrester
3. TailpipeTightening torque:
Tailpipe bolt:10 N·m (1.0 kgf·m, 7.4 lb·ft)
2
1
3
UB5J7BE0.book Page 45 Tuesday, June 18, 2019 10:07 AM

9-52
9
5. Slide the rubber cover back on the park-ing brake cable.
6. Loosen the locknut.
7. Turn the adjusting nut in direction (a) to increase the free play or in direction (b) to
decrease the free play.
8. Tighten the locknut, and then slide the
rubber cover to its original position.
9. Install the panel.
EBU32551Brake light switch adjustmentThe brake light switch, which is activated by
the brake pedal, is properly adjusted when
the brake light comes on just before braking
takes effect.
If necessary, adjust the brake light switch. 1. Hold the brake light switch in place.
2. Turn the adjusting nut in direction (a) to
make the brake light come on earlier.
3. Turn the adjusting nut in direction (b) to
make the brake light come on later.
1. Rubber cover
2. Adjusting nut
3. Locknut
1
(b)
(a)
3
2
1. Brake light switch
2. Adjusting nut
1
2
(b) (a)
UB5J7BE0.book Page 52 Tuesday, June 18, 2019 10:07 AM

9-64
9
If a fuse is blown, replace it as follows.1. Turn the key to “ ” (off) and turn off the electrical circuit in question.
NOTICEECB00641To prevent accidental short-circuiting,
turn off the main switch when checking or
replacing a fuse. 2. Remove panel A. (See page 9-10.)
3. Remove the blown fuse, and then install a
new fuse of the specified amperage.
WARNING! Always use a fuse of the specified amperage. Never use any
material in place of the proper fuse.
Using an improper fuse can cause
damage to the electrical system and
may lead to a fire.
[EWB03440]
1. Headlight fuse “HEAD”
2. Signaling system fuse “SIGNAL”
3. Four-wheel-drive motor fuse “DIFF”
4. Ignition fuse “IGNITION”
5. Backup fuse “BACK UP” (for clock)
6. Radiator fan motor fuse “FAN”
7. Spare fuse
8. Accessory fuse “ACC”
9. Sub radiator fan motor fuse “FAN_2”
10.Auxiliary DC jack fuse “TERMINAL”
1 234
5
6
7
8
9
10
UB5J7BE0.book Page 64 Tuesday, June 18, 2019 10:07 AM

9-65
9
4. Turn the key to “ ” (on) and turn on theelectrical circuit in question to check if
the device operates. If the fuse blows
again immediately, have a Yamaha dealer
check the electrical system.
5. Install the panel.EBU35261HeadlightsThis model is equipped with LED headlights.
There are no user replaceable bulbs. If one or
more headlights do not come on, check for a
loose connection, check the headlight fuse,
and then have a Yamaha dealer check the ve-
hicle.TIP When the headlights are set to low beam,
only the top half of each lamp will illuminate.
 When the headlights are set to high beam,
both halves of each lamp will illuminate.
Specified fuses:
Main fuse:50.0 A
Fuel injection system fuse: 15.0 A
Headlight fuse: 15.0 A
Ignition fuse: 15.0 A
Auxiliary DC jack fuse: 10.0 A
Signaling system fuse: 10.0 A
Four-wheel-drive motor fuse: 10.0 A
Sub radiator fan motor fuse: 30.0 A
Radiator fan motor fuse: 30.0 A
Backup fuse: 10.0 A
EPS fuse: 40.0 A
Accessory fuse: 15.0 A
UB5J7BE0.book Page 65 Tuesday, June 18, 2019 10:07 AM

9-66
9
EBU32681Headlight beam adjustmentNOTICEECB00691It is advisable to have a Yamaha dealer
make this adjustment. To raise the beam, turn the headlight beam
adjusting screw in direction (a).
To lower the beam, turn the headlight beam
adjusting screw in direction (b).
EBU37910Brake/tail lightThis model is equipped with an LED brake/tail
light, there are no replaceable bulbs.
If the brake/tail light does not come on, check
for a loose connection, check the fuses, and
then have a Yamaha dealer check the vehicle.EBU32700TroubleshootingAlthough Yamaha vehicles receive an inspec-
tion before shipment from the factory, trouble
may occur during operation. Any problem in
1. Headlight beam adjusting screw
(a)
(b)
1
1. Headlight beam adjusting screw
(b)
(a)
1
UB5J7BE0.book Page 66 Tuesday, June 18, 2019 10:07 AM

9-67
9
the fuel, compression, or ignition systems can
cause poor starting and loss of power. The
troubleshooting chart describes a quick, easy
procedure for making checks. If your vehicle
requires any repair, take it to a Yamaha deal-
er.
The skilled technicians at a Yamaha dealer-
ship have the tools, experience, and know-
how to properly service your vehicle. Use only
genuine Yamaha parts on your vehicle. Imita-
tion parts may look like Yamaha parts, but
they are often inferior. Consequently, they
have a shorter service life and can lead to ex-
pensive repair bills.
WARNING
EWB03450When checking the fuel system, do not
smoke and make sure there are no open
flames or sparks in the area, including pilot
lights from water heaters or furnaces.Gasoline or gasoline
vapors can ignite or
explode, causing severe injury or property
damage.

UB5J7BE0.book Page 67 Tuesday, June 18, 2019 10:07 AM

10-3
10
6. If storing in a humid or salt-air atmo-sphere, coat all exposed metal surfaces
with a light film of oil. Do not apply oil to
any rubber parts or the seat covers.
7. Remove the battery and charge it. Store
it in a dry place and recharge it once a
month. Do not store the battery in an ex-
cessively warm or cold place [less than 0
°C (30 °F) or more than 30 °C (90 °F)].
Use of fuel stabilizer eliminates the need to
drain the fuel system. Consult a Yamaha
dealer if the fuel system needs to be drained.
UB5J7BE0.book Page 3 Tuesday, June 18, 2019 10:07 AM

11-5
11
Rear suspension:Type:Double wishbone
Spring:
Coil spring
Shock absorber: Gas-hydraulic damper
Wheel travel: 432 mm (17.0 in)Electrical system:System voltage:12 V
Ignition system: TCI
Charging system:
AC magnetoBattery:Model:U1-H11L
Voltage, capacity:
12 V, 28.0 AhLights:Headlight:LED
Brake/tail light:
LED
Meter lighting: LED
Neutral indicator light: LED High beam indicator light:
LED
Reverse indicator light: LED
Coolant temperature warning light:
LED
Parking brake indicator light: LED
Engine trouble warning light: LED
Differential gear lock indicator light:
LED
EPS warning light: LED
Helmet reminder light: 0.8 W
Seat belt reminder light:
0.8 W
Shift timing indicator light: LED
Fuses:Main fuse:
50.0 A
Fuel injection system fuse: 15.0 A
EPS fuse: 40.0 A
Headlight fuse:
15.0 A
Signaling system fuse: 10.0 A
UB5J7BE0.book Page 5 Tuesday, June 18, 2019 10:07 AM

13-1
13
INDEX
AAccelerator pedal ......................................................... 5-18
Accelerator pedal, checking ........................................ 9-51
Accelerator pedal, Pre-operation check ........................ 6-7
Air filter ......................................................................... 9-39
Air filter case hoses, cleaning ...................................... 9-43
Auxiliary DC jack .......................................................... 5-38
Axle boots .................................................................... 9-37BBasic guide for safe use ................................................. 8-1
Battery, Periodic maintenance ..................................... 9-58
Brake and clutch fluid levels, checking ........................ 9-47
Brake fluid, replacing ...................................................9-49
Brake light switch, adjusting ........................................ 9-52
Brake pedal .................................................................. 5-19
Brake pedal, checking ................................................. 9-50
Brakes, Periodic maintenance ..................................... 9-46
Brakes, Pre-operation check ......................................... 6-3
Brake/tail light .............................................................. 9-66CCable, inspecting and lubrication ................................ 9-53
Cargo bed .................................................................... 5-27
Cleaning ....................................................................... 10-1
Clutch pedal ................................................................. 5-18
Clutch pedal, checking ................................................ 9-49
Clutch, Pre-operation check .......................................... 6-3
Control cables, Pre-operation check ............................. 6-8
Coolant, Periodic maintenance .................................... 9-35
Coolant, Pre-operation check ........................................ 6-6Coolant temperature warning light ................................ 5-4
Cup holders ................................................................. 5-26
DData recording, vehicle ................................................ 12-1
Differential gear lock indicator light ............................... 5-3
Differential gear oil, Periodic maintenance .................. 9-32
Differential gear, Pre-operation check ........................... 6-6
Doors ........................................................................... 5-21
Drive mode, selecting .................................................... 7-7
Driver seat position ...................................................... 5-23
Drive shaft universal joint, lubrication .......................... 9-55
Drivetrain icon ................................................................ 5-3EEngine break-in .............................................................. 7-1
Engine oil and oil filter, Periodic maintenance ............. 9-16
Engine oil, Pre-operation check ..................................... 6-6
Engine trouble warning light .......................................... 5-5
EPS warning light ........................................................... 5-5FFinal gear oil, Periodic maintenance ............................ 9-30
Final gear, Pre-operation check ..................................... 6-6
Fittings and fasteners, Pre-operation check .................. 6-8
Flag pole bracket ......................................................... 5-28
Four–wheel drive knob (On–Command 4WD) .............. 5-17
Front and rear brake pads, checking ........................... 9-46
Fuel, Pre-operation check .............................................. 6-4
Fuel tank cap ............................................................... 5-21
Fuse, replacing ............................................................. 9-63GGlove compartment ..................................................... 5-25
UB5J7BE0.book Page 1 Tuesday, June 18, 2019 10:07 AM

13-2
13
HHeadlight beam, adjusting ........................................... 9-66
Headlights .................................................................... 9-65
Helmet reminder light .................................................... 5-6
High beam indicator light ............................................... 5-3
Hood ............................................................................ 9-10IIdentification numbers ................................................... 1-1
Indicator lights and warning lights ................................. 5-2
Instruments, lights and switches, Pre-operation check ........................................................................... 6-8JJump-starting .............................................................. 9-62LLabel locations ............................................................... 2-1
Light switch .................................................................. 5-16
Loading .......................................................................... 7-9MMain switch .................................................................... 5-1
Maintenance and lubrication chart ................................ 9-6
Maintenance chart, emission control system ................ 9-4
Maintenance charts ....................................................... 9-4
Model label .................................................................... 1-1
Multi-function meter unit ............................................... 5-7NNeutral indicator light ..................................................... 5-2OOwner’s Manual and tool kit .......................................... 9-2PPanels .......................................................................... 9-10
Parking ........................................................................... 7-9 Parking brake indicator light .......................................... 5-3
Parking brake lever ...................................................... 5-19
Parking brake lever free play, adjusting ...................... 9-51
Parking brake pads, checking ..................................... 9-47
Passenger handhold, Pre-operation check ................... 6-7
Pedal, lubrication ......................................................... 9-53
RRear knuckle upper and lower pivot, lubrication ......... 9-55
Reverse gear lock lever ............................................... 5-20
Reverse indicator light ................................................... 5-2SSafety information .......................................................... 3-1
Seat belt reminder light ................................................. 5-6
Seat belts ..................................................................... 5-24
Seat belts, Pre-operation check .................................... 6-7
Seats ............................................................................ 5-21
Shift lever ..................................................................... 5-20
Shift lever operation and reverse driving ....................... 7-3
Shift lever, Pre-operation check .................................... 6-8
Shift light ........................................................................ 5-4
Shock absorbers, front ................................................ 5-28
Shock absorbers, rear ................................................. 5-33
Spark arrester, cleaning ............................................... 9-44
Spark plugs, checking ................................................. 9-37
Specifications .............................................................. 11-1
Stabilizer bushes, checking ..........
............................... 9-54
Starting the engine ........................................................ 7-2
Steering, Pre-operation check ....................................... 6-7
Steering shaft, lubrication ............................................ 9-56
Steering wheel position ............................................... 5-23
Storage ........................................................................ 10-2
Storage compartments ................................................ 5-25
UB5J7BE0.book Page 2 Tuesday, June 18, 2019 10:07 AM