crankcase YAMAHA YZ125LC 2005 Owner's Guide

4-69
ENGTRANSMISSION, SHIFT CAM AND SHIFT FORK
Extent of removal Order Part name Q’ty Remarks
TRANSMISSION, SHIFT CAM AND
SHIFT FORK REMOVAL
Preparation for EngineRefer to “ENGINE REMOVAL” section.
removal Separate the crankcase. Refer to“CRANKCASE AND CRANK
SHAFT
” section.
1 Guide bar (long) 1
2 Guide bar (short) 1
3 Shift cam 1
4 Shift fork 3 1
5 Shift fork 1 1
6 Shift fork 2 1
7 Main axle 1
8 Drive axle 1Refer to “REMOVAL POINTS”.
9 Spacer 1
EC4H0000
TRANSMISSION, SHIFT CAM AND SHIFT FORK
Extent of removal:1Shift cam and shift fork removal2Main axle and drive axle removal
1
2



10 Nm (1.0 m•kg, 7.2 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)
1C3-9-30-4D 25/5/04 7:15 PM Page 28

4-72
ENGTRANSMISSION, SHIFT CAM AND SHIFT FORK
2. Install:
92nd wheel gear (29T) 1
95th wheel gear (24T) 2
93rd wheel gear (27T) 3
94th wheel gear (23T) 4
96th wheel gear (23T) 5
91st wheel gear (31T) 6
To drive axle 7.
NOTE:
Apply the molybdenum disulfide oil on the inner
and end surface of the idler gear and on the
inner surface of the sliding gear, then install.
3. Install:
9Plain washer 1
9Circlip 2
NOTE:
9Be sure the circlip sharp-edged corner ais po-
sitioned opposite side to the plain washer and
gear b.
9Be sure the circlip end cis positioned at axle
spline groove d.
4. Install:
9Spacer 1
NOTE:
9Apply the lithium soap base grease on the oil
seal lip.
9When installing the spacer into the crankcase,
pay careful attention to the crankcase oil seal
lip.
1C3-9-30-4D 25/5/04 7:15 PM Page 34

4-73
ENGTRANSMISSION, SHIFT CAM AND SHIFT FORK
EC4H5312
Shift cam and shift fork
1. Install:
9Shift fork 1 (L) 1
9Shift fork 2 (C) 2
9Shift fork 3 (R) 3
NOTE:
9Mesh the shift fork #1 (L) with the 5th wheel
gear 4and #3 (R) with the 6th wheel gear 6
on the drive axle.
9Mesh the shift fork #2 (C) with the 3rd/4th pin-
ion gear 5on the main axle.
2. Install:
9Shift cam 1
NOTE:
9Apply the transmission oil on the shift cam.
9Install the shift cam while holding up the 5th
wheel gear 2and keeping the shift fork #1 3
moved in the direction of the arrow.
3. Install:
9Guide bar (short) 1
9Guide bar (long) 2
NOTE:
9Apply the transmission oil on the guide bars.
9Be sure the long bar is inserted into the shift
forks #1 and #3 and the short one into #2.
5. Install:
9Main axle 1
9Drive axle 2
NOTE:
Apply the transmission oil on the crankcase
bearings.
1C3-9-30-4D 25/5/04 7:15 PM Page 36