brake sensor YAMAHA YZ250LC 2001 Owners Manual

2-15
CABLE ROUTING DIAGRAMSPEC
1Brake hose holder
2Master cylinder
3Brake hose
4Reservoir hose
5Hose guide
6Clamp
7High tension cord
8Ignition coil
9Clutch cable
0Cable guide
qGround lead
wRadiator breather hose
eCDI magneto lead
rThrottle cable
tCDI unit lead
y“ENGINE STOP” button lead
uFuel tank damper
iEngine bracket
APass the brake hose into the
brake hose holder.BIf the brake hose contacts the
spring (rear shock absorber),
correct its twist.
CInstall the brake hose so that its
pipe portion directs as shown
and lightly touches the projec-
tion on the master cylinder.
DPass the reservoir hose
between the brake hose and
swingarm bracket.
EPass the reservoir hose into the
hose guide.
FClamp the high tension cord,
throttle cable, TPS (throttle posi-
tion sensor) and solenoid valve
lead so that the high tension
cord does not contact the
engine bracket installation nuts.
G
Fasten the ground lead together
with the front installation portion
of the ingnition coil.
HPass the clutch cable into the
cable guide.
IPosition the CDI magneto lead
coupler between the radiators.
JInstall the brake hose to the
caliper with the paint on the pipe
facing the caliper and with the
pipe contacting the caliper pro-
jection.
KPass the radiator breather hose
between the frame and radiator
hose so that it is not kinked or
wedged.
LPass the throttle cable, CDI unit
lead, “ENGINE STOP” button
lead and clutch cable between
the fuel tank damper tube ends.
5MW-9-30-2 7/3/00 2:26 PM Page 54