low beam YAMAHA YZF-R1S 2004 Service Manual

3-69
A
A
B
B
B
REPLACING THE HEADLIGHT BULBS
CHK
ADJ
WARNING
EAS00183
REPLACING THE HEADLIGHT BULBS
The following procedure applies to both of the
headlight bulbs.
1. Disconnect:

headlight bulb cover
1

headlight coupler 2
Ahigh beam
Blow beam
2. Remove:

headlight bulb holder
1
Ahigh beam
Blow beam
3. Remove:

headlight bulb
Since the headlight bulb gets extremely hot,
keep flammable products and your hands
away from the bulb until it has cooled down.
4. Install:

headlight bulb
New
Secure the new headlight bulb with the head-
light bulb holder.
ProCarManuals.com

3-70
REPLACING THE HEADLIGHT BULBS /
ADJUSTING THE HEADLIGHT BEAMSCHK
ADJ
CAUTION:
a
b
a
b
Avoid touching the glass part of the head-
light bulb to keep it free from oil, otherwise
the transparency of the glass, the life of the
bulb and the luminous flux will be adversely
affected. If the headlight bulb gets soiled,
thoroughly clean it with a cloth moistened
with alcohol or lacquer thinner.
5. Install:

headlight bulb holder
6. Install:

headlight bulb cover (high beam)

headlight bulb coupler (low beam)
7. Connect:

headlight coupler (high beam)

headlight cover (low beam)
EAS00185
ADJUSTING THE HEADLIGHT BEAMS
The following procedure applies to both of the
headlights.
1. Remove:

front cowling inner panels
Refer to “COWLINGS”.
2. Adjust:

headlight beam (vertically)
a. Turn the adjusting screw
1 in direction a or
b.
Direction
Headlight beam is raised.
DirectionHeadlight beam is
lowered.
3. Adjust:

headlight beam (horizontally)
a. Turn the adjusting screw
2 in direction a or
b.
Direction
Headlight beam moves to
the left.
DirectionHeadlight beam moves to
the right.
4. Install:

front cowling inner panels
Refer to “COWLINGS”.
ProCarManuals.com

8-29
YESNO

Clean the battery
terminals.

Recharge or re-
place the battery.
EAS00749
3. Main switch

Check the main switch for continuity.
Refer to “CHECKING THE SWITCHES”.

Is the main switch OK?
YESNO
Replace the main
switch.
EAS00784
YESNO 4. Dimmer switch

Check the dimmer switch for continuity.
Refer to “CHECKING THE SWITCHES”.

Is the dimmer switch OK?
The dimmer switch is
faulty. Replace the
left handlebar switch.
Minimum open-circuit voltage
12.8 V or more at 20C (68F)

Is the battery OK?
LIGHTING SYSTEMELEC
NOTE:
YESNO
1. Main, turn and headlight fuses

Check the main, turn and headlight fuses for
continuity.
Refer to “CHECKING THE FUSES” in chap-
ter 3.

Are the main, turn and headlight fuses OK?
Replace the fuse(s).
2. Battery

Check the condition of the battery.
Refer to “CHECKING AND CHARGING
THE BATTERY” in chapter 3.
EAS00739EAS00781
TROUBLESHOOTING
Any of the following fail to light: headlight,
high beam indicator light, taillight, licence
light or meter light.
Check:
1. main, turn and headlight fuses
2. battery
3. main switch
4. dimmer switch
5. pass switch
6. headlight relay (on / off)
7. headlight relay (dimmer)
8. wiring connections
(of the entire lighting system)

Before troubleshooting, remove the following
part(s):
1. seat
2. fuel tank
3. side cowlings

Troubleshoot with the following special tool(s).
Pocket tester
90890-03112, YU-3112
EAS00738
ProCarManuals.com

8-31
High beam indicator light (LEDs)
Positive tester probe
black / yellow
Negative tester probe

black / white
YESNO 1. Headlight bulb and socket

Check the headlight bulb and socket for con-
tinuity.
Refer to “CHECKING THE BULBS AND
BULB SOCKETS”.

Are the headlight bulb and socket OK?
Replace the head-
light bulb, socket or
both.
YESNO 2. Voltage

Connect the pocket tester (DC 20 V) to the
headlight and meter assembly couplers as
shown.
The wiring circuit
from the main switch
to the headlight cou-
pler is faulty and
must be repaired.
When the dimmer switch is set to “ ”
When the dimmer switch is set to “ ”
Headlight coupler (wire harness side)
Low beam
Headlight
Positive tester probe
black
Negative tester probe
black / green
1
2
Meter assembly coupler (wire harness side)

Turn the main switch to “ON”.

Start the engine.

Set the dimmer switch to “ ” or “ ”.

Measure the voltage (DC 12 V) of
black / green or black / yellow on the
headlight coupler (wire harness side).

Is the voltage within specification?
2
This circuit is OK.
A
B
Headlight
Positive tester probe
black
Negative tester probe
black / yellow
A
Headlight coupler (wire harness side)
High beam
B
6
5
3
4
4
LIGHTING SYSTEMELEC
EAS00788
CHECKING THE LIGHTING SYSTEM
1. The headlight and the high beam indicator
light fail to come on.
ProCarManuals.com

59Clutch switch
60Turn signal switch
61Horn
62Front turn signal / position light (left)
63Front turn signal / position light (right)
64Rear turn signal light (left)
65Rear turn signal light (right)
66Headlight
67Auxiliary light
68License plate light
69Rear brake light switch
70Tail / brake light
71Headlight relay (on / off)
72Headlight relay (dimmer)
73Fuse (ignition)
74Fuse (signal)
75Fuse (headlight)
76Radiator fan motor relay
77Fuse (radiator fan motor left)
78Fuse (radiator fan motor light)
79Radiator fan motor 2
80Radiator fan motor 1
81Ground
COLOR CODE
B Black. . . . .
Br Brown. . . .
Ch Chocolate. . .
Dg Dark green. . .
G Green. . . .
Gy Gray. . .
L Blue. . . . .
Lg Light green. . . .
O Orange. . . .
P Pink. . . . .
R Red. . . . .
Sb Sky blue. . . .
W White. . . .
Y Yellow. . . . .
B / G Black / Green. .
B / L Black / Blue. . .
B / R Black / Red. .
B / W Black / White. .
B / Y Black / Yellow. .
Br / G Brown / Green.
Br / L Brown / Blue. .
Br / R Brown / Red. .
Br / W Brown / White.
G / B Green / Black. .
G / R Green / Red. .
G / W Green / White. . G / Y Green / Yellow. .
Gy / B Gray / Black.
Gy / G Gray / Green.
Gy / R Gray / Red.
L / B Blue / Black. . .
L / R Blue / Red. .
L / W Blue / White. .
L / Y Blue / Yellow. . .
O / B Orange / Black. .
O / G Orange / Green. .
P / W Pink / White. .
R / B Red / Black. .
R / G Red / Green. .
R / L Red / Blue. .
R / W Red / White. .
R / Y Red / Yellow. .
Sb / W Sky blue / White.
W / B White / Black. .
W / R White / Red. .
W / Y White / Yellow. .
Y / B Yellow / Black. .
Y / G Yellow / Green. .
Y / L Yellow / Blue. . .
Y / R Yellow / Red. .
Y / W Yellow / White. .
YZF-R1S / YZF-R1SC WIRING DIAGRAM
1Main switch
2A.C. magneto
3Rectifier / regulator
4Fuse (main)
5Fuse (backup)
6Battery
7Fuse (fuel injection)
8Starter relay
9Starter motor
10Starting circuit cut-off relay
11Neutral switch
12Sidestand switch
13Fuel pump
14E.C.U
15Ignition coil #1
16Ignition coil #2
17Ignition coil #3
18Ignition coil #4
19Spark plug
20Injector #1
21Injector #2
22Injector #3
23Injector #4
24Air induction system solenoid
25Sub-throttle position sensor
26EXUP servo motor
27Speed sensor
28Coolant temperature sensor
29Intake air temperature sensor
30Option switch
31Crankshaft position sensor
32Throttle position sensor
33Intake air pressure sensor
34Atmospheric pressure sensor
35Cylinder identification sensor
36Lean angle cut-off switch
37Meter assembly
38Fuel level warning light
39Oil level warning light
40Neutral indicator light
41Tacho meter
42Shift timing indicator light
43Multi function meter
44Engine trouble warning light
45Coolant temperature indicator light
46Hi beam indicator light
47Turn signal indicator light (left)
48Turn signal indicator light (light)
49Meter light
50Oil level switch
51Right handlebar switch
52Front brake light switch
53Engine stop switch
54Start switch
55Turn signal relay
56Left handlebar switch
57Dimmer switch
58Horn switch
ProCarManuals.com