AUX Abarth Punto 2020 Owner handbook (in English)
[x] Cancel search | Manufacturer: ABARTH, Model Year: 2020, Model line: Punto, Model: Abarth Punto 2020Pages: 271, PDF Size: 4.21 MB
Page 106 of 271

102
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
fig. 100fig. 101
IMPORTANT After turning the ignition key to STOP, wait
at least 1 minute before disconnecting the electrical supply
to the battery.
EMERGENCY STARTING fig. 101
When jump starting, never connect the negative lead (–)
of the auxiliary battery to the negative pole A of the car
battery, but rather to an engine/gearbox earth point. Note In any case, it is possible to keep the engine
running by deactivating the Start&Stop system.
IRREGULAR OPERATION
In the case of malfunction the Start&Stop system is
disabled. The driver is informed of the problem by the
general failure warning light
A-fig. 99, where provided, coming on with an
information message and the system failure symbol
B-fig. 5 in the control panel. In this case, contact an
Abarth Dealership.
CAR INACTIVITY fig. 100
In the case of car inactivity, special attention must be paid
due to the disconnection of the battery power supply.
Proceed as follows: detach the connector A (by pressing
button B) from sensor C for monitoring the status of the
battery installed on the negative battery pole D. This
sensor should never be disconnected from the pole except
if the battery is replaced.
When replacing the battery, always
contact an Abarth Dealership. Replace
the battery using a new one of the same type
(HEAVY DUTY) and having the same
specifications.
WARNING
069-108 PUNTO Abarth GB 1ed 17-07-2012 12:08 Pagina 102
Page 155 of 271

STARTING THE ENGINE
EMERGENCY STARTING
If the instrument panel warning light
Ystays on
permanently, contact an Abarth Dealership immediately.
IN AN EMERGENCY
In an emergency we recommend that you call the free-phone number found on the Warranty Booklet. You can
also find the Abarth Dealership nearest to you on the web site www.fiat.com.
This procedure must be performed by
expert personnel because incorrect
actions could cause electrical discharge of
considerable intensity. Furthermore, battery
fluid is poisonous and corrosive: avoid contact
with skin and eyes. Keep naked flames away
from the battery. No smoking. Do not cause
sparks.
WARNING
IMPORTANT For the jump starting procedure, refer to
“Knowing your car” section, paragraph “Start&Stop
system”.
fig. 126F0U187Ab
151
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
JUMP STARTING fig. 126
If the battery is flat, the engine may be started using an
auxiliary battery with the same capacity or a little higher
than the flat one. It is advisable to contact an Abarth
Dealership to check/replace the battery.
151-182 PUNTO Abarth GB 1ed 17-07-2012 13:23 Pagina 151
Page 225 of 271

Automatic tuning ............................................................ 245
Manual tuning .................................................................. 245
Autostore function ........................................................ 246
Emergency alarm reception ......................................... 247
EON function ................................................................. 247
Stereophonic broadcasters .......................................... 247
CD PLAYER .................................................................... 248
Introduction .................................................................... 248
CD player selection ....................................................... 248
CD loading/ejection ....................................................... 249
Display readings .............................................................. 250
Track selection ................................................................ 250
Fast forward/rewind through tracks .......................... 250
Pause function ................................................................. 250
CD MP3 PLAYER ........................................................... 251
Introduction .................................................................... 251
MP3 mode ....................................................................... 251
Selection of MP3 sessions with hybrid discs ............ 251
Display readings .............................................................. 252
Selection of next/previous folder ............................... 252
Folder structure ............................................................. 252
AUX (only with Blue&Me™)..................................... 253
Introduction .................................................................... 253
AUX mode ...................................................................... 253
TROUBLESHOOTING ............................................... 254
RADIO
INTRODUCTION ........................................................ 222
Suggestions ...................................................................... 222
Technical specifications ................................................. 224
QUICK GUIDE .............................................................. 225
Steering wheel controls ................................................ 228
General information ...................................................... 229
FUNCTIONS AND ADJUSTMENTS ........................ 231
Turning the car radio on .............................................. 231
Turning the car radio off .............................................. 231
Selecting the radio functions ....................................... 231
Selecting CD function ................................................... 231
Audio source memory function .................................. 231
Volume adjustment ........................................................ 232
Mute/Pause function ...................................................... 232
Audio adjustments ......................................................... 233
Preset/User/Classic/Rock/Jazz functions ................... 235
User Eq Settings function ............................................. 235
Menu ................................................................................. 236
Phone function................................................................. 241
Phone set-up ................................................................... 242
Anti-theft protection ..................................................... 243
RADIO (Tuner) .............................................................. 244
Introduction .................................................................... 244
Selecting a frequency band ........................................... 244
Preselection buttons ..................................................... 245
Storing the last station listened to ............................. 245
RADIO
221
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:27 Pagina 221
Page 229 of 271

225
RADIO
QUICK GUIDE
Button
FM
AM
MEDIA
GENERAL FUNCTIONS
On
Off
FM1, FM2, FM Autostore radio source selection
MW1, MW2 radio source selection
Selection of CD/Media Player source (only with Blue&Me™)/
AUX (only with Blue&Me™)
Mode
Short button press
Short button press
Short cyclical button press
Short cyclical button press
Short cyclical button pressgON/OFF fig. 1
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:27 Pagina 225
Page 232 of 271

CONTROLS ON THE STEERING
WHEEL
(for versions/markets where provided)
Button
&
+
–
SRC
▲
▼
FUNCTION
AudioMute on/off (Radio mode)
or Pause function (MP3 or Media Player mode only with
Blue&Me™)
Increasing volume
Decreasing volume
Selection of Radio frequency range (FM1, FM2, FMT, FMA,
MW1, MW2) or listening sources (Radio, MP3 or Media
Player only with Blue&Me™)/AUX
(only with Blue&Me™)
Radio: automatic search for next station available
CD/CD MP3: select next track.
Radio: automatic search for previous station available
CD/CD MP3: select previous trackMode
Short button press
Button press
Button press
Button press
Button press
Button press
RADIO
228
fig. 2
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:27 Pagina 228
Page 234 of 271

RADIO
230
CD MP3 section
❒MP3-Info function (ID3-TAG);
❒Select folder (previous/next);
❒Track selection (forward/backward);
❒Fast forward/rewind through tracks;
❒MP3 Display function: display of folder name, ID3-
TAG information, time elapsed since the start of the
track, name of the file);
❒Audio or data CD, CD-R and CD-RW playback.
Audio section
❒Mute/Pause function;
❒Soft Mute function;
❒Loudness function;
❒7 band graphic equaliser:
❒Separate bass/treble adjustment;
❒Right/left channel balance.Media Player section
(only with Blue&Me™)
See the description in the Blue&Me™Supplement for
the operation of the Media Player.
AUX section
(only with Blue&Me™)
❒AUX source selection;
❒AUX Offset function: alignment of the portable device
volume to the one of the other sources;
❒Portable player reading.
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:27 Pagina 230
Page 237 of 271

233
RADIO
AUDIO ADJUSTMENTS
The functions in the audio menu are different depending
on the status activated: AM/FM/CE/Media Player
(only with Blue&Me™)/AUX (only with Blue&Me™).
Press the AUDIO button briefly to change the Audio
functions. After the AUDIO button is first pressed, the
display will show the bass level value for the source
activated at that time (e.g. in FM mode the display will
show the wording “FM Bass +2“).
Use the buttons ▲or ▼ to scroll through the menu
functions. To change the setting of the selected function,
use the buttons ¯or ˙.
The current status of the selected function appears on
the display.The functions managed by the Menu are:
❒BASS (bass adjustment);
❒TREBLE (treble adjustment);
❒BALANCE (right/left balance adjustment);
❒FADER (front/rear balance adjustment);
❒LOUDNESS (LOUDNESS function
activation/deactivation);
❒EQUALIZER (activation and selection of factory
equalisation presets);
❒USER EQUALISER (customised equalisation
adjustment).
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:27 Pagina 233
Page 240 of 271

236
RADIO
MENU
MENU button functions
Press the MENU button briefly to activate the Menu
function. The display will show the first menu item that
can be adjusted (AF) (“AF Switching On” on the display).
Use the buttons ▲or ▼to scroll through the menu
functions. To change the setting of the selected function,
use the buttons ¯or ˙.
The current status of the selected function appears on
the display.The functions managed by the Menu are:
❒AF SWITCHING (ON/OFF);
❒TRAFFIC INFORMATION (ON/OFF);
❒REGIONAL MODE regional programmes (ON/OFF);
❒MP3 DISPLAY (CD MP3 display setting);
❒SPEED VOLUME (speed-dependent automatic
volume control);
❒RADIO ON VOLUME (radio volume limits
activation/ deactivation);
❒SPEECH VOLUME (telephone volume adjustment)
(for versions/markets where provided);
❒AUX OFFSET (alignment of the portable device
volume to the one of the other sources)
(for versions/ markets where provided);
❒RADIO OFF (off mode).
❒SYSTEM RESET.
Press the MENU button again to exit the Menu function.
IMPORTANT The AF SWITCHING, TRAFFIC
INFORMATION and REGIONAL MODE adjustments
are only possible on FM.
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:27 Pagina 236
Page 245 of 271

241
RADIO
PHONE FUNCTION (telephone volume
adjustment) (only with Blue&MeTMsystem)
With Speech volume function present in Menu
This function makes it possible to adjust (settings from 1
to 40), by turning the ON/OFF button/knob or pressing
the ¯/ ˙buttons or exclude (OFF setting), the volume
of the Telephone or the Blue&Me™(except the Media
Player function).
The display shows the current function status:
❒“Speech Off”: function deactivated.
❒“Speech volume 23”: function activated with volume
set to 23.
With Speech volume function not present in Menu
When one phone call is received, the audio passes to the
car sound system through the radio.
The incoming telephone sound is always at a fixed
volume, but it can be adjusted during the conversation
using the ON/OFF button/knob.
If, while using the Blue&Me™, the phone call volume is
changed, the same is displayed on the radio display,
memorised and kept for all the following phone calls
until the engine is switched off.
With the RADIO ON VOLUME function activated,
when the engine is started again:
❒if the radio was switched off with a Blue&Me™
volume lower than 12, at the next phone call the
Blue&Me™volume is automatically set to 12;
❒if the radio was switched off with a Blue&Me™
volume higher than 25, at the next phone call the
Blue&Me™volume is automatically set to 25;❒if the radio was switched off with a Blue&Me™
volume ranging between 12 and 25, at the next phone
call the Blue&Me™volume is kept as previously set
by the user.
If instead the RADIO ON VOLUME function is
deactivated, the radio keeps the last setting.
SPEECH VOLUME function
(telephone volume adjustment)
This function makes it possible to adjust (settings from 1
to 40), by turning the control fig. 1 or pressing the ¯/ ˙
buttons or exclude (OFF setting) the volume of the
Telephone, the Blue&Me™(except the Media Player
function).
The display shows the current function status:
❒“Speech Off”: function deactivated.
❒“Speech volume 23”: function activated with volume
setting 23.
AUX OFFSET function
(alignment of the portable device volume to the
one of the other sources)
(for versions/markets, where provided)
This function enables to align the volume of the AUX
source, depending on its own portable player, to the one
of the other sources. To activate the function, press the
MENU button and then select “AUX offset”.
Press the buttons ¯or ˙to decrease or increase the
volume value (set from – 6 to + 6).
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:28 Pagina 241
Page 248 of 271

RADIO
244
RADIO (Tuner)
INTRODUCTION
When the radio is turned on the last function selected
before it was switched off is activated: Radio, CD, CD
MP3, Media Player (only with Blue&Me™) or
AUX (only with Blue&Me™).
To select the Radio function when another audio source
is being listened to, briefly press the FM or AM buttons
depending on the desired band.
Once the Radio mode has been activated, the display will
show the name (RDS stations only), the frequency of the
selected radio station, the frequency band selected (e.g.
FM1) and the preselect button number (e.g. P1).FREQUENCY BAND SELECTION
With the Radio mode active, press the FM or AM button
briefly and repeatedly to select the desired reception
band.
Each time the button is pressed the following bands are
selected cyclically:
❒By pressing the FM button: “FM1”, “FM2” or “FMA”;
❒By pressing the AM button: “MW1”, “MW2”.
Each band is indicated by the corresponding text on the
display. The last station selected on the respective
frequency band will be tuned into.
If the CD player overheats the CD playing could be
temporarily interrupted. The radio will automatically
turn to the Radio (Tuner) mode and the display will
show “CD hot” and then “CD disc error”.
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:28 Pagina 244