fuses Abarth Punto Evo 2011 Owner handbook (in English)

CHANGING A BULB
GENERAL INSTRUCTIONS
❒When a light is not working, check that the
corresponding fuse is intact before changing a bulb.
For the location of fuses, refer to the paragraph “If a
fuse blows” in this section;
❒before changing a bulb check the contacts for
oxidation;
❒burnt bulbs must be replaced by others of the same
type and power;
❒always check the height of the headlight beam after
changing a bulb for safety reasons.
158
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Changes or repairs to the electrical
system (electronic control units) carried
out incorrectly and without due consideration
for the technical specifications of the system
may lead to malfunctioning and generate a fire
hazard.
WARNING
Halogen lamps contain pressurised gas.
If they break, glass fragments could fly
everywhere.
WARNING
F0U135Abfig. 134
CYLINDER REPLACEMENT
PROCEDURE
To replace the cylinder, proceed as follows:
❒disconnect A-fig. 134;
❒turn the bottle anticlockwise to replace and raise it;
❒fit the new cylinder and turn it clockwise;
❒connect connection A to the canister and fit the
transparent tube B in the special compartment.

169
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
F0U156Abfig. 154
BOOT LIGHT fig. 154
To change the bulb, proceed as follows:
❒open the boot;
❒remove the light A by levering on the point shown
by the arrow.
❒open the protective cover B and replace the press-
fitted bulb;
❒re-close the protective cover B over the lens;
❒refit the light A by inserting it in its correct position
firstly on one side and then on the other until it
clicks into place.
F0U159Abfig. 155
REPLACING FUSES
GENERAL INFORMATION
Fuses protect the electric system: they cut in (i.e. they
blow) in the event of a failure or improper action on the
system.
Check the state of the corresponding fuse when a
device does not work: the filament A-fig. 155 must be
intact. If it is, replace the blown fuse with another with
the same amperage (same colour).
B intact fuse;
C fuse with damaged filament.

171
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
F0U160Abfig. 156
F0U161Abfig. 157
FUSE LOCATION
The fuses are grouped in three control units: on the
dashboard, in the engine compartment and in the left
side of the boot.
Dashboard fuse box fig. 157
To access the dashboard fuse box, loosen the screws A-
fig. 156 and remove the cover.

263
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Fuel
– consumption ............................ 219
– fuel cut-off system .................. 60
– fuel tank cap ............................. 107
– reserve warning light ............. 146
– saving fuel ................................. 135
– specifications ............................ 216
Fuse boxes (location) ......... 171-173
Fuses ................................................ 169
– accessing the fuses .................. 171
– fuse summary table ................ 174
– general information ................ 169
– location (fuse boxes) .... 171-173
Gear lever ..................................... 134
Gear Shift Indicator
(“e-GSI” system) ........................ 103
Gearbox ......................................... 134
Glove compartment ..................... 61
Handbrake ...................................... 134
Handbrake lever ........................... 134
Hazard warning lights .................. 58
Head restraint .............................. 33
Headlight alignment corrector.... 84
Headlights ....................................... 84
– adjusting headlights abroad ... 84
– beam orientation..................... 84
– bulb replacement .................... 162
– headlight alignment
corrector ..................................... 84
– orientation of front
fog lights ....................................... 84
Headrests
– front ........................................... 33
– rear ............................................ 33
Heated rear window .................... 59
Heating and ventilation ................ 37
– bi-zone automatic climate
control system ............................ 44
– diffusers .................................... 38
– maintenance ............................. 43
– manual climate control
system ........................................... 39
Heating and ventilation system ... 37
Hill Holder (system)...................... 89How to warm up the engine
after it has just started .............. 132
Identification data ......................... 205
– bodywork codes...................... 207
– Bodywork paint
identification plate ...................... 206
– chassis marking ........................ 206
– engine codes ............................ 207
– engine marking ........................ 206
– vehicle identification
number plate ............................... 205
Ignition switch ............................... 11
– steering wheel lock ................ 12
Important notes ............................ 2
In an emergency ............................ 151
Installing electrical/electronic
devices (important notes) ........ 106
Instrument panel ........................... 13
– right hand drive version ........ 258
Interior fittings................................ 61
Interiors (cleaning) ....................... 200