Acura Integra 2000 Hatchback Manual Online

Key
s an d Lock s

Glov e Bo x
Open the glove box by pulling the
bottom of the handle. Close it with a
firm push. Lock or unlock the glove
box with the master key.
LS, GS, GS-R and Type-R models

The glove box light comes on only when the instrument panel lights are
on.

Instrument s an d Control s
An open glove box can cause
serious injury to your passengerin a crash, even if the
passenger is wearing the seat

belt.

Always keep the glove box closed while driving.

Sea
t Adjustment s
Front Seat Adjustment s
See pages 13 — 14 for important safety
information and warnings about how to
properly position seats and seat-backs.
Make all seat adjustments before
you start driving.
To adjust the seat forward andbackward, pull up on the lever under
the seat cushion's front edge. Move
the seat to the desired position and
release the lever. Try to move theseat to make sure it is locked in

position.
To change the angle of the seat-back,
pull up on the lever on the outside of
the seat bottom. Move the seat-back
to the desired position and release
the lever. Let the seat-back latch in
the new position.

Instrument s an d Control s

Sea
t Adjustment s

Driver' s Sea t Heigh t Adjustmen t
Except SE and Type-R models See pages 13 — 14 for important safety
information and warnings about how to
properly position seats and seat-backs.
Make all adjustments before youstart driving.
The height of your driver's seat is adjustable. Turn the front dial on theoutside of the seat cushion to raise
the front of the seat bottom and turn
the rear dial to raise the rear. Driver'
s Lumba r Suppor t
Vary the lumbar support by moving the lever on the right side of the
seat-back.

Instrument s an d Control s

Sea
t Adjustment s
Rea r Sea t Acces s
To get into the back seat on the driver's side, pull up on the seat-back
adjustment lever.

RELEASE LEVE R

To get into the back seat on the passenger's side, push forward on
the release lever at the base of the seat-back. The entire seat will slide
forward at the same time to allow easier entry to the back seat. After
you return the seat-back to the upright position, push the whole seat
backwards until it latches. Make sure the seat is fully latched before
sitting in it.

Instruments an d Control s

Sea
t Adjustment s

Hea d Restraint s
See page 15 for important safety
information and a warning about how to
properly position the head restraints.
RELEASE

BUTTO N
The front head restraints help protect you and your passenger from
whiplash and other injuries. They are most effective when you adjust them
so the back of the occupant's head
rests against the center of the
restraint. A taller person should adjust the restraint as high as

possible.
The front head restraints adjust for
height. You need both hands toadjust the restraint. Do not attempt
to adjust it while driving. To raise it,
pull upward. To lower the restraint,
push the release button sideways and push the restraint down.
To remove a head restraint for cleaning or repair, pull it up as far as
it will go. Push the release button
and pull the restraint out of the seat-
back.

Instrument s an d Control s

Foldin
g Rea r Seat , Carg o Are a Cove r
Foldin g Rea r Sea t

RELEASE

TA B

The back of the rear seat folds down to give you more cargo space. Eachside folds down separately. With only
half the seat folded, you can still carry a passenger in the back seat.
To unlatch either side of the seat- back, pull up on the release tab.Move the seat belt out of the way
and fold the seat-back down. To lock the seat-back upright, push
the seat-back firmly against its latch.
Tug on the seat-back to make sure it
is latched.

Make sure all items in the cargo area
are secured. Loose items can fly
forward and cause injury if you have
to brake hard. See Carrying Cargo
on page 132. Carg
o Are a Cove r
The cargo area cover may be removed to give you more cargo
height. Place your hands, palms up,
under the cover near the outsideedges. Lift it straight up.
To install the cover, line up the mounting rods with the slots, then
push down on the cover until it clips
into place. Make sure it is securely
latched so it will not come loose
while you are driving.

Instrument s an d Control s

MOUNTIN
G RO D

Powe
r Window s

Your car's windows are electrically- powered. Turn the ignition switch toON (II) to raise or lower any window.
Each door has a switch that controls
its window. To open the window,
push the switch down and hold it. Release the switch when you want
the window to stop. Close the
window by pushing the switch up and holding it.
MAI
N SWITC H

The driver's armrest has a master power window control panel. Toopen the passenger's window, push
down on the switch and hold it down
until the window reaches the desired
position. To close the window, push
up on the window switch. Release
the switch when the window gets to
the position you want.

Instrument s an d Control s
Closing a power window on
someone's hands or fingers can cause serious injury.
Make sure your passengers are
away from the windows before

closing them.

DRIVER' S WINDO W SWITC H

Powe
r Windows , Moonroo f

The master control panel also con- tains these extra features:
AUTO — To open the driver's
window fully, push the window switch firmly down and release it.
The window automatically goes all the way down. To stop the window
from going all the way down, push the window switch up briefly.
To open the driver's window only partially, push the window switchdown lightly and hold it. The window
will stop as soon as you release the
switch.

The AUTO function only works to lower the driver's window. To raise
the window, you must push the
window switch up and hold it until the window reaches the desired

position.
The MAIN switch controls power to
the passenger's window. With thisswitch off, the passenger's window
cannot be raised or lowered. The
MAIN switch does not affect the driver's window. Keep the MAIN
switch off when you have children in
the car so they do not injure them- selves by operating the window
unintentionally. Moonroo
f

On some models

Use the switch on the dashboard to open and close the moonroof. The
ignition switch must be ON (II). Push and hold the switch to
open the moonroof. Release the
switch when the moonroof reaches
the desired position. To close the
moonroof, press and hold the
switch.

Instrument s an d Control s

CONTINUED

Moonroof
, Mirror s

If you try to open the moonroof in below-freezing temperatures, or whenit is covered with snow or ice, you can
damage the moonroof panel or motor.
Mirror
s

TAB
Keep the inside and outside mirrors
clean and adjusted for best visibility.
Be sure to adjust the mirrors before
you start driving.
The inside mirror has day and night positions. The night position reduces
glare from headlights behind you.Flip the tab on the bottom edge of
the mirror to select the day or night

position.
Adjusting the Power Mirrors

Adjust the outside mirrors with the adjustment switch on the driver's
door:

1. Turn the ignition switch ON (II).
2. Move the selector switch to L (driver's side) or R (passenger's

side).

Instrument s an d Control s

NOTIC
E
SELECTO
R SWITC H
Closing the moonroof on

someone's hands or fingers can

cause serious injury.

Make sure passengers are

clear of the moonroof before

closing it.

Mirrors
, Parking Brake

ADJUSTMEN T
SWITC H

3. Push the appropriate edge of the adjustment switch to move the
mirror right, left, up or down.
4. When you finish, move the selector switch to the center (off)
position. This turns off the adjustment switch so you can't
move a mirror out of position by
accidentally bumping the switch. Parkin
g Brak e
To apply the parking brake, pull the lever up fully. To release it, pull upslightly, push the button, and lower
the lever. The parking brake light on
the instrument panel should go out
when the parking brake is fully released (see page 54).
Driving the car with the parking brake

applied can damage the rear brakes

and axles.

Instrument s an d Control s

NOTIC
E
PARKIN G BRAK E LEVE R