hood release Acura Integra 2000 Hatchback Owner's Manual

Servic
e Statio n Procedure s
5. Screw the fuel fill cap back on,
tighten it until it clicks at least
three times. If you do not properly
tighten the cap, the Malfunction Indicator Lamp may come on (see
page 237).

6. Push the fuel fill door closed until

it latches.

Openin g th e Hoo d
1. Shift to Park or Neutral and set

the parking brake. Pull the hood release handle located under the
lower left corner of the dashboard.
The hood will pop up slightly.

2. Standing in front of the car, put

your fingers under the front edge of the hood to the left of center.
Slide your hand to the right until
you feel the hood latch handle. Push this handle to the right until
it releases the hood. Lift the hood.

CONTINUED
Befor e Drivin g

LATC
H
HOO D RELEAS E HANDL E

Light
s

Replacin g a Headligh t Bul b
Your car has two bulbs on each side, four in total. Make sure you arereplacing the bulb that is burned out.
Your car uses halogen headlight bulbs. When replacing a bulb, handle
it by its plastic case and protect the
glass from contact with your skin or
hard objects. If you touch the glass,clean it with denatured alcohol and a
clean cloth.

Halogen headlight bulbs get very hot when lit. Oil, perspiration, or a scratch
on the glass can cause the bulb to
overheat and shatter.
1. Open the hood.
If you need to change the high
beam headlight bulb on the
passenger's side, remove the
radiator reserve tank by pulling it straight up.

2. To disconnect the bulb from the

electrical harness, push on the end
of the lock tab to release the
connector then push the connec-
tor straight down.

3. Turn the bulb about one-eighth

turn counterclockwise to unlock it
from the headlight assembly.

4. Remove the bulb by pulling it

straight out of its recess.

5. Align the tabs on the new bulb
with the slots in the headlightassembly and push it into place.
6. Turn the bulb clockwise to lock it

in place. Do not force it. Check the seating of the bulb's tabs in the
slots if the bulb will not return to
its original position.

7. Reinstall the harness connector on

the bulb connector. Make sure it
locks in place.
Turn on the headlights to test the new bulb.

8. (Passenger's side)

Reinstall the radiator reserve tank.

Maintenanc e

NOTIC
E