brake light Acura MDX 2014 Advanced Technology Guide

5
4Opening the Power Tailgate from Inside the VehiclePOWER TAILGATEThere are multiple ways to operate the power tailgate.Opening the Power Tailgate Using the Remote Transmitter• Press and hold the tailgate
button until a beep sounds.
The tailgate begins to open.
•

To close the tailgate, press thebutton again at any time.
In ANYTIME mode: Press and
hold the tailgate button for
about one second to unlock
and open the tailgate. In WHEN UNLOCKED
mode:
Press the unlock button twice
to unlock all doors and the
tailgate. Then press and hold
the tailgate button for about
one second.
The vehicle must be off with the remote in operating range. The vehicle must be in Park (P) with all doors unlocked.
Make sure the power tailgate keyless open mode is set to your preference using
the MID. See your Owner’s Manual for instructions, or see page 8
for an example
of how to change a setting.
Two-Way Keyless System RemoteStarting the EngineStopping the EngineREMOTE ENGINE STARTStart your vehicle’s engine and adjust the interior temperature using the two-way
keyless access remote before you enter the vehicle. Available with Advance Package.*
*Also available as an accessory. See your authorized Acura dealer.
ENGINE button
LOCK button
Press and hold ENGINE. The red LED stays solid for one second.
The engine will stop if it has been running for more than 10 minutes or any door is
opened without using the remote or keyless access. See your Owner’s Manual for
more conditions and information.
Operating range:
approximately 328 feet
Amber LED
Green LEDRed LED
Press LOCK, then press and hold ENGINE. The
amber LED blinks, and the green LED stays solid for
one second when the engine starts. You can repeat
this once at any time within 10 minutes of the
initial remote start for a 10-minute extension.
While remote engine start is on:
• The climate control system can warm or cool the
interior, depending on the ambient temperature.
• The security system remains on.
• Exterior lights and accessories remain off.
To start driving after you enter the vehicle, depress
the brake pedal and press ENGINE START/STOP
(see page 3).
Only use remote engine
start when the vehicle
is outdoors or in a well-
ventilated area.
If the red LED is
blinking, the remote
cannot communicate
with the vehicle or it is
out of range.
14 MDX ATG_ATG Facing 3/29/2013 12:34 PM Page 4

67
\bNSTRUMENT PANEL \bND\bCAT\fRS
Briefly appear with each engine start. Red and amber indicators a\Nre most critical. Blue
and green indicators are used for general information. See your Owner’s \fanual for
more information.
If an indicator remains on, there may be a problem; see your dealer.
Charging system
Low brake fluid, Brake system
Low oil pressure
Vehicle Stability Assist (VSA®)
\falfunction indicator lamp(check engine light)
Tire Pressure \fonitoring System
(TP\fS) (blinks)
Collision \fitigation Braking
SystemT\f(C\fBST\f)*
Super \bandling
AllWheel Drive (S\bAWD)*
SRS(Supplemental Restraint System)
ABS (Antilock Brake System)Blind Spot Information (BSI)*
Brake system (hydraulic)
Electric Power Steering
Keyless Access System
PASSENGER AIRBAG \fFF
(next to display)
VSA \fFF
BSI* off
Immobilizer (blinks):
Use other vehicle key and see dealer
Exterior lights on
Turn signals/hazards onCRUISE
CONTROLCRUISE CONTROL on
CRUISE
MAINCRUISE \fAIN on
\bigh beams on
*if equipped
Action is needed by driver.
Parking brake on:
Release\fessage indicator:
See M\bD
Low tire pressure (stays on):
Add air
Seat belt reminder:
Fasten seat belt(s)Low fuel:
Refill
C\fBS* off
FCW* off
Lane Keeping Assist System* onAdaptive Cruise Control* on
Lane Departure Warning (LDW)*
Forward Collision Warning
(FCW)*
Malfunction \bndicatorsCondition \bndicators
\fn/\fff \bndicators
14 MDX ATG_RP1_Corre\Acted Pages_ATG Facin\Ag \b/5/2013 11\f53 \AAM Page \b

23
22
COLLISION MITIGATION BRAKING SYSTEM
™
(CMBS
™)
Alerts you to the possibility of a front-end collision and can help reduce the severity of
the collision if you are unable to avoid it. Visual and audible warnings depend on the
distance setting. See Forward Collision Warning on the opposite page for instructions Available with Advance Package.
CMBS Off
A beep sounds and a message
appears in the MID.
CMBS On
*Depending on the circumstances, CMBS may not go through all of the alert stages before initiating the last stage.
FORWARD COLLISION WARNING (FCW)Alerts you to the possibility of a front-end collision. Available with Technology
Package.
At 10 mph or higher, if the radar sensor in the front grille detects a vehicle in
front of you and the system determines a collision is likely, the system warns you
with visual and audible alerts.
1. Press SETTINGS. Use the interface dial to make and
enter selections.
2. Select Vehicle Settings.
3. Select Forward Collision Warning Distance.
4. Select Long, Normal, Short, or Off.
5. Press BACK to exit the menu.
If you do not brake in time
or take preventive action:
• BRAKE flashes in the MID
• a beep sounds continuously
Visual
warning
Audible
warning
Seat belt
retraction
Brake
application
Stage 1Stage 2Stage 3
Heads-up warning
timing depends on
the CMBS distance
setting.
Short
Normal
Long
Lightly applied
Lightly appliedStrongly applied Strongly applied
*You can also change these settings using the
multi-information display (see page 8).
How It Works
3 Stages of CMBS*
Changing Settings
Turning the System Off or On
Warning timing depends on
Long, Normal, or Shortsettings.
Determine the warning timing, or turn the system off.* Press and hold CMBS OFF.
A beep sounds, a message appears in the
MID, and the CMBS indicator turns on.
Flashes on the MID
FCW may not activate under certain conditions. See your Owner’s Manual for more information.
14 MDX ATG_ATG Facing 3/29/2013 12:37 PM Page 22
on changing the distance setting.