start stop button Acura MDX 2014 Advanced Technology Guide

2
3
Unlocking/Locking the DoorsOpening the Tailgate*For Technology and Advance Packages, the rear doors also include this function.
To unlock, grab either one of
the front door handles* when
the vehicle is off.
To lock, press the door lock
button on either front door
handle* when the vehicle is off.Press the tailgate release button
under the tailgate handle when
all doors are unlocked. The
vehicle can be on or off.
See page 4 for more information
on opening the tailgate.
Engine Start/Stop Button
KEYLESS ACCESS SYSTEMOperate certain functions of your vehicle by simply having the remote transmitter
within operating range.
Accessory or On Mode
Press ENGINE START/STOP once without pressing the brake pedal for
Accessory mode. Press it again for On mode.
Starting the Engine
Press and hold the brake pedal, then press ENGINE START/STOP.
Turning the Vehicle Off
Shift to Park, then press ENGINE START/STOP.
Note:If you press the button when the vehicle is stopped and the shift lever is
not in Park, the vehicle goes into Accessory mode.
Note: If there is not enough clearance
for the tailgate to fully open, press
and hold the tailgate release button
until you hear two beeps. The tailgate
unlatches, and you can open it
manually.
14 MDX ATG_ATG Facing 3/29/2013 12:33 PM Page 2

5
4Opening the Power Tailgate from Inside the VehiclePOWER TAILGATEThere are multiple ways to operate the power tailgate.Opening the Power Tailgate Using the Remote Transmitter• Press and hold the tailgate
button until a beep sounds.
The tailgate begins to open.
•

To close the tailgate, press thebutton again at any time.
In ANYTIME mode: Press and
hold the tailgate button for
about one second to unlock
and open the tailgate. In WHEN UNLOCKED
mode:
Press the unlock button twice
to unlock all doors and the
tailgate. Then press and hold
the tailgate button for about
one second.
The vehicle must be off with the remote in operating range. The vehicle must be in Park (P) with all doors unlocked.
Make sure the power tailgate keyless open mode is set to your preference using
the MID. See your Owner’s Manual for instructions, or see page 8
for an example
of how to change a setting.
Two-Way Keyless System RemoteStarting the EngineStopping the EngineREMOTE ENGINE STARTStart your vehicle’s engine and adjust the interior temperature using the two-way
keyless access remote before you enter the vehicle. Available with Advance Package.*
*Also available as an accessory. See your authorized Acura dealer.
ENGINE button
LOCK button
Press and hold ENGINE. The red LED stays solid for one second.
The engine will stop if it has been running for more than 10 minutes or any door is
opened without using the remote or keyless access. See your Owner’s Manual for
more conditions and information.
Operating range:
approximately 328 feet
Amber LED
Green LEDRed LED
Press LOCK, then press and hold ENGINE. The
amber LED blinks, and the green LED stays solid for
one second when the engine starts. You can repeat
this once at any time within 10 minutes of the
initial remote start for a 10-minute extension.
While remote engine start is on:
• The climate control system can warm or cool the
interior, depending on the ambient temperature.
• The security system remains on.
• Exterior lights and accessories remain off.
To start driving after you enter the vehicle, depress
the brake pedal and press ENGINE START/STOP
(see page 3).
Only use remote engine
start when the vehicle
is outdoors or in a well-
ventilated area.
If the red LED is
blinking, the remote
cannot communicate
with the vehicle or it is
out of range.
14 MDX ATG_ATG Facing 3/29/2013 12:34 PM Page 4

25
24ADAPTIVE CRUISE CONTROL (ACC) WITH LOW SPEED FOLLOWSet a space interval between your vehicle and the vehicle ahead of you. When the vehicle
ahead changes speed, ACC senses the change and increases or decreases your vehicle’s
speed to maintain a set following distance or speed. Available with Advance Package.
Press the Distance button to shuffle
through four ranges.
The selected range and set speed are shown in the MID.
Note: The ACC radar sensor in the front grille can detect and monitor the
distance of a vehicle up to approximately 100 yards ahead.
Control the distance between your vehicle and the vehicle in front of you.
Using ACC
1. Accelerate to the desired speed. Above 25 mph: Go to step 2.
Below 25 mph (Low Speed Follow): Press SET/- to set the speed at 25 mph
when there is a vehicle ahead of you. If there is no vehicle ahead, ACC will
not engage.
2. Press SET/-, then release the accelerator pedal. The set speed is fixed, and ACC begins.
3. To increase speed, press RES/+. To decrease speed, press SET/-.
4. If the vehicle ahead of you stops, your vehicle also stops. When the vehicle ahead starts to accelerate, press RES/+ or SET/- or depress the accelerator
pedal to resume following at the set distance.
Choosing Standard Cruise Control Mode
1. Press and hold the Distance button.
2. A beep sounds, and the selected mode appears in the MID.
MAIN
SET/-
Distance RES/+
CANCEL
Range
MID Screen
Extra LongLongMiddleShort
If the vehicle ahead of you goes
out of range, the vehicle icon
changes to a dotted outline.If a another vehicle enters the
selected range, a vehicle icon
appears on the MID.Short
range
Normal
range
Long
range
Extra Long
Range
ACC automatically adjusts the following distance based on the
range selected and your set vehicle speed.
Operating ACC
Changing Vehicle Distance
Turning ACC On
Press MAIN. ACC appears in the MID.
Canceling ACC
Press MAIN or CANCEL, or tap the brake pedal.Check the MID for
ACC information.
14 MDX ATG_ATG Facing 3/29/2013 12:38 PM Page 24