remove seats Acura MDX 2015 Owner's Guide

6 || 7
SAFeTy
SAFeTy
Not wearing a seat belt properly increases the chance of a serious injury or
death in a crash, even though your vehicle has airbags.
Be sure you and your passengers always wear seat belts and wear them
properly.
WArNING
Seat Belt Inspection
Regularly check the condition of your seat belts as follows:
•  Pull each belt out fully, and look for frays, cuts, burns, and wear.
•  Check that the latches work smoothly and the belts retract easily. If a belt does not
retract easily, cleaning the belt may correct the problem. Only use a mild soap and
warm water. Do not use bleach or cleaning solvents. Make sure the belt is completely
dry before allowing it to retract.
Any belt that is not in good condition or working properly will not provide proper
protection and should be replaced as soon as possible.
A belt that has been worn during a crash may not provide the same level of protection in
a subsequent crash. Have your seat belts inspected by a dealer after any collision.
Not checking or maintaining seat belts can result in serious injury or death if
the seat belts do not work properly when needed.
Check your seat belts regularly and have any problem corrected as soon as
possible.
WArNING
Fastening a Seat BeltAdjust your seat to the proper position (see page 38), and then follow the below steps.
1. Pull the seat belt out slowly.
2. Insert the latch plate into the buckle, then tug on the
belt to make sure the buckle is secure. Make sure that
the belt is not twisted or caught on anything.
On models with CMBS
TM, the front seat belts retract
automatically.
3. Position the lap part of the belt as low as possible across
your hips, then pull up on the shoulder part of the belt
so the lap part fits snugly. This lets your strong pelvic
bones take the force of a crash and reduces the chance
of internal injuries.
4. If necessary, pull up on the belt again to remove any
slack, then make sure that the belt rests across the
center of your chest and over your shoulder. This spreads
the forces of a crash over the strongest bones in your
upper body.
To release the belt, push the red PRESS button
then guide the belt by hand until it has
retracted completely.
Adjusting the Shoulder Anchor
The front seats have adjustable shoulder anchors to accommodate taller and shorter
occupants.
1. Move the anchor up and down while holding the release
button.
2. Position the anchor so that the belt rests across the
center of your chest and over your shoulder. Improperly positioning the seat belts can cause serious injury or death in a
crash.
Make sure all seat belts are properly positioned before driving.
Pull
out
slowl y.
Lap belt
as low as
possible
Latch
plate
Buckle
Pull out
slowl y.
Lap belt
as low as
possible
Latch
plate
Buckle
Pull out
slowl y.
Lap belt
as low as
possible
Latch
plate
Buckle
Push
WArNING

18 || 19
SAFeTy
SAFeTy
Installing a LATCH-Compatible Child Seat
A LATCH-compatible child seat can be installed in the second-row seats. A child seat is
attached to the lower anchors with either the rigid or flexible type of connectors.
1. Locate the lower anchors under the marks.
2. Place the child seat on the vehicle seat, then attach
the child seat to the lower anchors according to the
instructions that came with the child seat. Make sure
that the lower anchors are not obstructed by the seat
belt or any other object.
outer seats: Raise the head restraint to its
highest position, then route the tether strap
between the head restraint legs, and secure the
tether strap hook onto the anchor.
Center seat: Lower the center head restraint to
its lowest position, then route the tether strap
over the top of the head restraint and secure the
tether strap hook onto the anchor.
3. Tighten the tether strap as instructed by the child seat
maker.
4. Make sure the child seat is firmly secured by rocking
it forward and back and side to side; little movement
should be felt.
5. Make sure any unused seat belt that a child can reach is
buckled, the lockable retractor is activated, and the belt
is fully retracted and locked.
Marks
Lower anchors Rigid type
Flexible type
Tether strap hook
Anchor
Installing a Child Seat with a Lap/Shoulder Seat Belt 1. Place the child seat on the vehicle seat.
2. Route the seat belt through the child seat according to
the seat maker’s instructions, and insert the latch plate
into the buckle. Insert the latch plate fully until it clicks.
3. Slowly pull the shoulder part of the belt all the way out
until it stops. This activates the lockable retractor.
4. Let the seat belt completely wind up into the retractor,
then try to pull it out to make sure the retractor is
locked. If you are able to pull the shoulder belt out, the
lockable retractor is not activated. Pull the seat belt all
the way out, and repeat steps 3 – 4.
5. Grab the shoulder part of the seat belt near the buckle,
and pull up to remove any slack from the lap part of the
belt. When doing this, place your weight on the child
seat and push it into the vehicle seat.
6. Make sure the child seat is firmly secured by rocking
it forward and back and side to side; little movement
should be felt.
7. Make sure any unused seat belt that a child can reach is
buckled, the lockable retractor is activated, and the belt
is fully retracted and locked.
To deactivate a lockable retractor, release the buckle and
allow the seat belt to wind up all the way.

38 || 39

veHICLe CoNTroLS
veHICLe CoNTroLS
Adjusting the Seats
Make seat adjustments before driving to ensure the best comfort and safety.
Adjusting the Front Seats
Adjust the driver’s seat as far back as possible while
allowing you to maintain full control of the vehicle. You
should be able to sit upright and well back in the seat,
adequately press the pedals without leaning forward, and
grip the steering wheel comfortably. The passenger’s seat
should be adjusted so that it is as far back from the front
airbag in the dashboard as possible.
The National Highway Traffic Safety Administration and
Transport Canada recommend that drivers allow at least
10 inches (25 cm) between the center of the steering wheel and the chest.
Sitting too close to a front airbag can result in serious injury or death if the
front airbags inflate.
Always sit as far back from the front airbags as possible while maintaining
control of the vehicle.
Allow sufficient
space.
Move
back.
Horizontal position
adjustment
Height adjustment Lumbar support
adjustment*
Seat-back angle
adjustment
WArNING
*if equipped
Reclining the seat-back too far can result in serious injury or death in a crash.
Adjust the seat-back to an upright position, and sit well back in the seat.
Sitting improperly or out of position can result in serious injury or death in a
crash.
Always sit upright, well back in the seat, with your feet on the floor.
Adjusting the
Head restraints
Your vehicle is equipped with head restraints in all seating positions. Head restraints are
most effective for protection against whiplash and other rear-impact crash injuries.
The center of the back of the occupant’s head should
rest against the center of the restraint. The tops of the
occupant’s ears should be level with the center height of
the restraint.
Front and second-row seats
To raise the head restraint: Pull it upward.
To lower the head restraint: Push it down while pressing
the release button.
To remove the head restraint: Pull the restraint up as far
as it will go. Then push the release button, and pull the
restraint up and out.
To reinstall a head restraint: Insert the legs back in
place, then adjust the head restraint to an appropriate
height while pressing the release button. Pull up on the
restraint to make sure it is locked in position.
Front and second-row outer seat
Second-row center seat
WArNING
WArNING
Third-row seats
To fold down the head restraint: Pull the handle.
To fold up the head restraint: Pull up the head
restraint and push it back until it latches into
place.Third-
row seat
Handle

82 || 83
DrIvING
NA vIGATIoN
Taking a Detour
You can calculate a detour route manually if you encounter a road closure or other
obstacle. Use the interface dial to make and enter selections.
1. When en route, press MENU.
2. Select Detour. The system attempts to calculate a new
route by avoiding the next 5 miles (8 km) while on a
freeway or 1 mile (1 km) while on a surface street.
AcuraLink r eal-Time Traffic™*
View traffic flow, incidents, and construction in major metro areas. You can also route
around congestion or incidents using voice commands. Press the Talk button before
saying each command. Available in the U.S. only.
1. When en route, say “Display  traffic on my route.” A list of
incidents on your route appears.
2. Say the number of the incident you want to avoid.
3. Say “Avoid” and the incident list returns.
4. Say “Reroute” to set the new route.
*Requires  AcuraLink subscription.  Visit  owners.acura.com for more information.
Canceling y our route
You can cancel your route at any time. Press the Talk button and say “Cancel route.” You
can also use the interface dial to make and enter selections.
1. When en route, press MENU.
2. Select Cancel Route. The route is cleared and the map
screen returns.
Learn about preparation for driving, as well as other features.
Before Driving
Check the following items before you begin driving.
exterior Checks
•  Make sure there are no obstructions on the windows, door mirrors, exterior lights, or
other parts of the vehicle.
•  Remove any frost, snow, or ice.
•  Make sure the hood is securely closed.
•  Heat from the engine and exhaust can ignite flammable materials left under the hood,
causing a fire. If you’ve parked your vehicle for an extended period, inspect and remove
any debris that may have collected, such as dried grass and leaves that have fallen or
have been carried in for use as a nest by a small animal. Also check under the hood for
leftover flammable materials after you or someone else has performed maintenance on
your vehicle.
•  Make sure the tires are in good condition.
•  Make sure there are no people or objects behind or around the vehicle.
DrIvING
If the doors are frozen shut, use warm water around the door edges to melt any ice. Do not
try to force them open, as this can damage the rubber trim around the doors. When done,
wipe dry to avoid further freezing.
Interior Checks
•  Store or secure all items on board properly.
•  Do not pile items higher than the seat height.
•  Do not place anything in the front seat footwells. Make sure to secure the floor mats.
•  If you have any animals on board, do not let them move freely in the vehicle.
•  Securely close and lock all doors and the tailgate.
•  Adjust your seating position, mirrors, and steering wheel properly.
•  Make sure items placed on the floor behind the front seats cannot roll under the seats.
•  Everyone in the vehicle must fasten their seat belt.
•  Make sure that the indicators in the instrument panel come on when you start the
vehicle, and go off soon after.
No TICe