homelink Acura RL 2000 3.5 Owner's Manual
[x] Cancel search | Manufacturer: ACURA, Model Year: 2000, Model line: RL, Model: Acura RL 2000Pages: 330, PDF Size: 4.53 MB
Page 54 of 330
Instrument
s an d Control s
This section gives information about the controls and displays thatcontribute to the daily operation of
your Acura. All the essential controls are within easy reach.
Control Locations............................ 52
Indicator Lights................................ 53
Gauges.............................................. 58
Speedometer................................ 58
Tachometer.................................. 58
Odometer...................................... 59
Trip Meter/Outside Temperature Indicator............ 59
Temperature Gauge.................... 60 Fuel Gauge................................... 60
Maintenance Required Indicator.................................... 61
Controls Near the Steering Wheel........................................ 62
Headlights.................................... 63
Automatic Lighting..................... 64
Daytime Running Lights............. 65
Instrument Panel Brightness..... 66
Turn Signals................................. 66
Fog Lights.................................... 67 Windshield Wipers...................... 68
Windshield Washers................... 70
Hazard Warning........................... 70
Rear Window Defogger.............. 71
Steering Wheel Adjustments..... 71
Steering Wheel Controls ................ 73 Cruise Control.............................. 73
Remote Audio Controls .............. 76
Keys and Locks................................ 77 Keys............................................... 77
Immobilizer System..................... 78
Ignition Switch............................. 80
Power Door Locks....................... 81
Remote Transmitter.................... 82
Childproof Door Locks............... 85
Trunk............................................86
Glove Box..................................... 87
HomeLink Universal Transmitter......... 88
Customer Assistance.................. 88
Important Safety Precautions.... 88
Training the Transmitter............ 89
Training With a Rolling Code System....................................... 91
Erasing Codes.............................. 92
Seat Adjustments............................. 93
Driver's Seat Adjustments.......... 93
Driver's Lumbar Support............ 95
Front Passenger's Seat
Adjustments............................. 95
Head Restraints........................... 95
Armrest............................................. 96
Mirrors.............................................. 98
Adjusting the Power Mirrors..... 98
Driving Position Memory
System......................................... 100
Seat Heaters................................... 102
Ski Sleeve........................................ 103
Power Windows............................. 105
Moonroof........................................ 106
Parking Brake................................ 108
Digital Clock................................... 108
Sunglasses Holder......................... 110
Beverage Holder............................111
Console Compartment.................. 112
Coin Box......................................... 112
Sun Visor......................................... 113
Vanity Mirror................................. 113
Accessory Power Socket.............. 114 Cigarette Lighter........................... 115
Ashtrays.......................................... 116
Ceiling Lights................................. 117
Courtesy Lights............................. 118
Instrument s an d Control s
Page 91 of 330
HomeLin
k Universa l Transmitte r
The HomeLink Universal Transmit- ter built into your car can be
programmed to operate remotely-controlled devices around your home,
such as garage doors, lighting, or
home security systems. It can replace up to three remote
transmitters.
Custome r Assistanc e
If you have problems with training
the HomeLink Universal
Transmitter, or would like information on home products thatcan be operated by the transmitter,
call (800) 355-3515. Importan
t Safet y Precaution s
Always refer to the operating instruc- tions and safety information that
came with your garage door opener
or other equipment you intend tooperate with the HomeLink
Universal Transmitter. If you do not
have this information, you should contact the manufacturer of the
equipment.
While training or using the transmitter, make sure you have aclear view of the garage door or gate,
and that no one will be injured by its
movement. If your garage door opener was
manufactured before April 1982, you
may not be able to program the
HomeLink Universal Transmitter to
operate it. Garage door openers
manufactured before that date do
not have a safety feature that causes
them to stop and reverse if an obstacle is detected during closing,
increasing the risk of injury. If you
have questions, call (800) 355-3515.
Instrument s an d Control s
Page 92 of 330
HomeLin
k Universa l Transmitte r
Trainin g th e Transmitte r
Before you can use the HomeLink
Universal Transmitter to operate
devices around your home, it must
"learn" the proper codes. For
example, to train the transmitter to
open and close the garage door:
1. This step erases all previously learned
codes. Perform this step before
training the transmitter for the very
first time. Press and hold the two
outside buttons until the red light
in the transmitter flashes (approximately 20 seconds).
Release the buttons.
2. Hold the end of the garage door opener remote control 1 to 3
inches from the HomeLink
transmitter. Make sure you are
not blocking your view of the red
light in the transmitter. 3. Select the transmitter button you
want to train.
4. Press the button on the remote control and the button on the
transmitter at the same time. Hold down both buttons. 5. The red light in the transmitter
should begin flashing. It will flash
slowly at first, then rapidly.
6. When the red light flashes rapidly, release both buttons. The
transmitter should have learned
the code from the remote control.
7. Test the transmitter button by pushing it. It should operate the
garage door.
8. Repeat these steps to train the other two transmitter buttons to
operate any other remotely-
controlled devices around your
home (lighting, automatic gate, security system, etc.).
CONTINUED
Instrument s an d Control s
Page 93 of 330
HomeLin
k Universa l Transmitte r
Canadian Owners:
The remote control you are training from may stop transmitting after twoseconds. This is not long enough for
the HomeLink transmitter to learn
the code. Release and press the
button on the remote control every
two seconds until the transmitter has
learned the code.
If you are programming the
transmitter to operate a garage door or gate, it is recommended that you
unplug the motor for that device during programming. Repeatedly
pressing the remote control button
could burn out the motor. The HomeLink transmitter stores
the code in a permanent memory.
There should be no need to retrain the transmitter if your car's battery
goes dead or is disconnected.
Retraining a Button
To train an already programmed transmitter button to operate a new
device:
1. Select the transmitter button you want to train.
2. Press and hold the transmitter button until the red light begins to
flash slowly (approximately 20
seconds).
3. While continuing to hold the
transmitter button, place the
remote control for the device 1 to
3 inches from the HomeLink
transmitter.
4. Press and hold the button on the remote control. Hold both buttons
until the red light begins to flash
rapidly.
5. Release both buttons. The transmitter should now be trained
to operate the device.
Instrument s an d Control s
Page 94 of 330
HomeLin
k Universa l Transmitte r
Trainin g Wit h a Rollin g Cod e
Syste m
For security purposes, newer garage
door opening systems use a "rolling"
or variable code. If you know that
your garage door opener has a
rolling code, or you have been
unable to train the transmitter after
several attempts, use the following
procedure. You will need someone to
help you.
1. Make sure you have properlycompleted the "Training the
Transmitter" procedure.
2. Find the "Training" button on your garage door opener motor/control
unit. The location will vary,depending on the manufacturer.
The manufacturer's documentation may help. 3. Press the Training button on the
motor/control unit until the
Training light comes on, then release it.
4. Press and release the desired button on the HomeLink
transmitter.
5. Press and release the HomeLink transmitter button again. Thisshould turn off the training light
on the motor/control unit. (Some
systems may require you to press
and release the button three times.)
6. Press the transmitter button again. It should operate the garage door.
Instrument s an d Control s
TRAININ
G BUTTO N
GARAG E DOO R
OPENE R MOTOR /
CONTRO L UNI T
Page 324 of 330
Inde
x
Reserve Indicator......................... 57
Tank, Filling the......................... 167
Fuel Mileage, Improving............... 171
Fuses, Checking the...................... 288
Gasohol........................................... 303
Gasoline.......................................... 166
Fuel Reserv
e Indicator................ 57
Gauge............................................
60
Octane Requirement................
. 166
Tank, Fillin
g the......................... 167
Gas Statio
n Procedures................. 167
Gauges..............................................
58
Engine Coolan
t Temperature .... 60
Fuel................................................
60
Maintenance Require
d
Indicator.................................... 61
GAWR (Gross Axle Weight
Rating) ........................................ 195
Gearshift Lever Positions .............180
Glass Cleaning............................... 265
Glove Box......................................... 87
GVWR (Gross Vehicle Weight
Rating) ........................................ 195
Halogen Headlight Bulbs.............. 250
Hazard Warning Flashers............... 70
Headlights
Automatic Lighting..................... 64
Daytime Running Lights............. 65
High Beam Indicator................... 57
High Beams, Turning on............ 63
Lights On Indicator..................... 55
Low Beams, Turning on............. 63
Reminder Chime.......................... 63
Replacing Halogen Bulbs ......... 250
Turning on.................................... 63
Head Restraints............................... 95
Heating and Cooling...................... 120
High Altitude, Starting at.............. 179
High-Low Beam Switch .................. 63
High-mount Brake Light............... 255
HomeLink Universal
Transmitter.................................. 88
Hood Latch..................................... 229
Hood, Opening the ........................ 168
Horn................................................... 62
Hot Coolant, Warning about........ 219
Hydroplaning.................................. 193 Identification Number, Vehicle.... 296
If Your Car Has to be Towed....... 292
Ignition
Keys............................................... 77
Switch............................................ 80
Timing Control System............. 306
Immobilizer System......................... 78
Important Safety Precautions .......... 6
Indicator Lights, Instrument Panel.............................................. 53
Inflation, Proper Tire .................... 241
Inside Mirror.................................... 98
Inspection, Tire.............................. 243
Instrument Panel............................. 53
Instrument Panel Brightness......... 66
Interior Cleaning............................ 264
Introduction......................................... i
CONTINUED