Acura RL 2002 3.5 Owners Manual

Vary the lumbar support by moving
the lever on the right side of the
seat-back. Pivot the lever forward
until it stops, then let it return. Doing
this several times adjusts the lumbar
support through its f ull range.The seat adjustment switches are on
the outside edge of the seat bottom.
Push the long horizontal switch
forward or backward to move the
seat bottom in that direction.
Adjust the seat-back angle by
pushing the vertical switch in the
direction you want to move.The head restraints help protect you
and your passengers from whiplash
and other injuries. They are most
effective when you adjust them so
the back of the occupant’s head rests
against the center of the restraint. A
taller person should adjust the
restraint as high as possible.
See page f or important saf ety
inf ormation and a warning about how toproperly position the head restraints. 14
Driver’s L umbar Support
Front Passenger’s Seat
Adjustments Head Restraints
Seat A djustments
Inst rument s and Cont rols88
01/09/28 19:39:33 31SZ3660_091

The lid of the console compartment
canbeusedasanarmrestatthe
high or low position. To raise the
armrest, push the button on the lid.
Make sure the armrest is securely
latched. To lower it, press the button
and push the armrest down until it
latches.
Make sure the passengers’ hands or
fingersareawayfromthearmrest
bef ore pushing it down.
To remove a head restraint f or
cleaning or repair, pull it up as f ar as
it will go. Push the release button
and pull the restraint out of the seat-
back.
The head restraints adjust f or height
and tilt. You need both hands to
adjust the restraint. Do not attempt
to adjust it while driving. To raise it,
pull upward. To lower the restraint,
push the release button sideways
and push the restraint down. To
adjust the tilt, pivot the head
restraint to the desired position. Armrest
Seat A djustments, A rmrest
Inst rument s and Cont rols89
P P
u
us
shh
R
RE EL
LEE A
A S
SEE B
BUUT TT
TO
ON N
01/09/28 19:39:42 31SZ3660_092

Make sure all items in the trunk and
those extending through the pass-
through are secured.
For security, this cover can be
locked and unlocked only with the
master key. To lock the cover, insert
thekeyandturnitclockwise.
Never drive with this cover open and
the trunk lid open.
See on
page .
The rear seat armrest is located at
the center of the rear seat. Pivot it
down to use it. The pass-through cover can be
opened f rom either side; it f olds
f orward onto the center armrest.
Open the cover by sliding the knob
downward and pushing or pulling on
the cover. To close the cover, swing
it up and push f irmly on the top.
Make sure it latches properly. 49
Carbon Monoxide HazardT runk Pass-through Cover
Armrest
Inst rument s and Cont rols90
K KN
NO OBB
L
LIIDD
01/09/28 19:39:51 31SZ3660_093

Adjust the outside mirrors with the
adjustment button on the driver’s
door armrest:Turn the ignition switch ON (II).
Move the selector switch to L
(driver’s side) or R (passenger’s
side).
Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror has an automatic
anti-glare mechanism. When the
AUTO switch is pushed in, the
indicator will light. When the mirror
senses light f rom the headlights of
the car behind you, the mirror
surf ace will automatically darken to
reduce the glare.1.
2.
CONT INUED
A djusting the Power Mirrors
Mirrors
Inst rument s and Cont rols91
S SE
EL
LEE C
CT TO
OR R S
SWWI ITT C
CH H
O
ON
N S
STTA
A R
R
I
IN ND DI
ICCA A T
TO
OR R
A
A
N
NT TI
IG
GL LAA R
REE
I
IN ND DI
ICCA A T
TO
OR R
A
A N
NT TI
IG
GL LAA R
REE S
SWWI ITT C
CH H
01/09/28 19:40:01 31SZ3660_094

The outside mirrors are heated to re-
move fog and frost. With the ignition
switchON(II),turnontheheaters
by pressing the button. The light in
the button comes on as a reminder.
Press the button again to turn the
heaters off.
When you f inish, move the
selector switch to the center (off)
position. This turns of f the
adjustment button so you can’t
move a mirror out of position by
accidentally bumping the button.
Move the mirror right, left, up or
down by pushing the adjustment
button in that direction. Outside mirror positions can be
stored in the driving position
memory system (see page ). 4.
3. 93
Mirrors
Inst rument s and Cont rols92
H H
E
EA
A T
TE
ED
D M
MI
IRRR ROOR R B
BUUT TT
TO
ON N
A
A D
DJ
JUUS STTM
M E
EN
NT T B
BUUT TT
TO
ON N
01/09/28 19:40:09 31SZ3660_095

Press and release the MEMO
buttononthecontrolpanel.You
will hear a beep. Immediately
press and hold one of the memory
buttons (1 or 2) until you hear two
beeps. The indicator light in the
memory button will come on. The
current positions of the driver’s
seat, steering wheel, and outside
mirrors are now stored.
Your Acura has a memory f eature
f or the steering wheel, driver’s seat,
and outside mirror positions.
Turn the ignition switch ON (II).
You cannot add a new driving
position in the memory unless the
ignition switch is ON (II). You can
recall a memorized position with
the ignition switch in any position.
Store a driving position as explained
in this section only when the car is
parked.
Two seat, steering wheel, and
outside mirror positions f or dif f erent
drivers or driving conditions can be
stored in separate memories. You
select a memorized position by
pushing the appropriate button.
Adjust the seat to a comfortable
position (see page ). Adjust
the steering wheel to a
comf ortable position (see page). Adjust the outside mirrors
f or best visibility (see page ). 3.
1.
2.
71 86
91
CONT INUED
St oring a Driving Posit ion in Memory
Driving Posit ion Memory Syst em
Inst rument s and Cont rols93
M ME
EM
M O
O B
BUUT TT
TO
ON N
01/09/28 19:40:19 31SZ3660_096

Doing any of the f ollowing af ter
pressing the MEMO button will
cancel the storing procedure.Not pressing a memory button
within 5 seconds.
Readjusting the seat or steering
position.
You can select memorized positions
as f ollows.Make sure the parking brake is set
and the shif t lever is in Park.
Insert the key in the ignition
switch. If you do not insert the key
in the ignition switch, the steering
wheel will not adjust to the
memorized position until you do. Press the desired memory button
(1 or 2) until you hear a beep, then
release the button.
The system will move the seat,
steering wheel and outside mirrors
to the memorized positions. The
indicator light in the selected
memory button will f lash during
movement. When the adjustments
are complete, you will hear two
beeps and the indicator light will
remain on.
Readjusting the outside mirror
position.
Each memory button stores only one
driving position. Storing a new
position erases the previous setting
stored in that button’s memory. If
you want to add a new position while
retaining the current one, use the
other memory button.
All stored driving positions will be
lost if your car’s battery goes dead or
is disconnected. 3.
1.
2.Select ing a Memorized Posit ion
Driving Posit ion Memory Syst em
Inst rument s and Cont rols94
M M E
EM
M O
ORRYY B
BUUT TT
TO
ON NSS
01/09/28 19:40:31 31SZ3660_097

Press any button on the control
panel: MEMO, 1 or 2.
Push any of the adjustment
switches f or the seat or steering
wheel.
Shif t out of Park.If desired, you can use the adjust-
ment switches to change the posi-
tions of the seat, steering wheel or
outside mirrors af ter they are in
their memorized position. To keep
this driving position f or later use,
you must store it in the driving posi-
tion memory.
To stop the system’s automatic ad-
justment;
Adjust the outside mirrors.
If you select a memorized position
without inserting the key in the
ignition switch, only the seat and
outside mirrors will adjust. To get
the system to also adjust the steering
wheel, insert the key in the ignition
switch. You will hear two beeps
when it is complete. Both f ront seats are equipped with
seat heaters. The ignition switch
must be ON (II) to use them. Push
the front of the switch, HI, to rapidly
heat up the seat. After the seat
reaches a comf ortable temperature,
select LO by pushing the back of the
switch. This will keep the seat warm.
CONT INUED
Seat Heaters
Driving Position Memory System, Seat Heaters
Inst rument s and Cont rols95
S SE
EA
A T
T H
HE
EA
A T
TE
ER
RS S
01/09/28 19:40:43 31SZ3660_098

The HI or LO indicator lights and
remains lit until you turn it of f by
pushing the opposite side of the
switch lightly. The indicator will turn
off.Follow these precautions whenever
you use the seat heaters:
Use the HI setting only to heat the
seats quickly. Select the LO
setting when the seats f eel warm.
The HI setting draws large
amounts of current f rom the
battery.
Do not use the seat heaters, even
on the LO setting, if the engine is
lef t idling f or an extended period.
They can weaken the battery,
causing hard starting.
In LO, the heater runs continuously.
It does not cycle with temperature
changes. In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat’s temperature drops. It
continues to cycle as long as you
leave it set on HI. The HI indicator
remains lit as a reminder that you
have the heater on.
Because of the sensors f or the side
airbag system, there is no heater in
the passenger’s seat-back. To use the ski sleeve:
Pull down the rear seat armrest.
Open the trunk pass-through
cover by sliding the knob down-
ward and pulling on the cover.
Theskisleeveallowsyoutocarry
skis or other long objects saf ely
without soiling or damaging the
interior of your car. It attaches to the
trunk pass-through.
1. Ski Sleeve
Seat Heaters, Ski Sleeve
Inst rument s and Cont rols96
K KN
NO OBB
L
LIIDD
01/09/28 19:40:56 31SZ3660_099

Follow these precautions when you
use the ski sleeve:
Use the strap on the ski sleeve to
secure it tightly to the rear seat
armrest.
Attach the ski sleeve to the trunk
pass-through.
Load the skis into the ski sleeve
fromthetrunk.Makesurethetip
of the ski sleeve is resting on the
center console. Afteruse,makesuretheski
sleeve is dry both inside and out
before folding it up for storage.
This will help to prevent mildew.
Open the trunk. Remove the ski
sleeve f rom its storage bag. Donottransportskisthatare
longer or heavier than these limits:
Maximum length: 84 in (215 cm)
Maximum weight: 55 lbs (25 kg)
5.
4. 2.
3.
Ski Sleeve
Inst rument s and Cont rols97
01/09/28 19:41:06 31SZ3660_100