high beam Acura RL 2004 3.5 Owner's Manual

Î
Î
Î
The U.S. instrument panel is shown. Dif f erences f or the Canadian models are noted in the text.
Inst rument s and Cont rols
Indicator L ights
57
VSA ACTIVATION
INDICATOR
SEAT BELT
REMINDER
LIGHT
(P.59)
IMMOBILIZER
SYSTEM INDICATOR
CHARGING SYSTEM
INDICATOR
LOW OIL
PRESSURE
INDICATOR MALFUNCTION
INDICATOR
LAMP
BRAKE LAMP INDICATOR
MAINTENANCE
REQUIRED INDICATOR
CRUISE
CONTROL
INDICATOR
VEHICLE STABILITY ASSIST
SYSTEM INDICATOR
LOW FUEL
INDICATOR LIGHTS ON
INDICATOR
SIDE AIRBAG CUTOFF
INDICATOR
HIGH BEAM
INDICATOR
PARKING BRAKE AND BRAKE
SYSTEM INDICATOR SUPPLEMENTAL RESTRAINT
SYSTEM INDICATORANTI-LOCK BRAKE SYSTEM
INDICATOR
DOOR AND TRUNK
OPEN MONITOR
(P.66)
(P.62)
(P. 59) (P.61)(P.59)
(P.59) (P.60)
(P.60)
(P. 60)
(P. 59)
(P. 58)
(P.61)
(P.62)
(P.59,
323)
(P.58, 325)
(P.58, 321)
(P.58,322)

This light comes on as a reminder
that you must ref uel soon.This light comes on with the high
beam headlights. See page for
inf ormation on the headlight
controls.
On Canadian models, this indicator
comes on with reduced brightness
when the Daytime Running Lights
(DRL) are on (see page ).This indicator lights when you turn
the ignition switch to ON (II) with
the headlight switch of f and the
parking brake set. It should go of f if
youturnontheheadlightsorrelease
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
70 68Canadian models only
Indicator L ights
Inst rument s and Cont rols
L ow Fuel Indicator
High Beam Indicator ‘‘Daytime Running
Lights’’ Indicator
62

Thetwoleversonthesteering
column contain controls f or driving
f eatures you use most of ten. The lef t
lever controls the turn signals,
headlights, and high beams. The
right lever controls the windshield
washers and wipers.
The switch for the hazard warning
lights is on the dashboard to the
right of the steering column.
The controls under the lef t air vent
areforthecruisecontrol,instrument
panel brightness and the VSA
System.
The switches for the rear window
def ogger and f og lights are under
the audio system.
The steering wheel adjustment
switch on the side of the steering
column allows you to tilt and
telescope the steering wheel.
Controls Near the Steering Wheel
Inst rument s and Cont rols67
VEHICLE
STABILITY
ASSIST SYSTEM
OFF SWITCH
CRUISE
CONTROLSTEERING WHEEL
ADJUSTMENTS
HEADLIGHTS/
TURN SIGNALS
HAZARD WARNING
LIGHTS
INSTRUMENT
PANEL
BRIGHTNESS WINDSHIELD
WIPERS/WASHERS
HORN REAR WINDOW DEFOGGER FOG LIGHTS

To change between low beams and
high beams, pull the turn signal lever
until you hear a click, then let go.
The blue high beam indicator will
light (see page ).
When the light switch is in either of
these positions, the Lights On
indicator comes on as a reminder.
This light remains on if you leave the
light switch on and turn the ignition
switch to ACCESSORY (I) or LOCK
(0). If you leave the lights on with the
ignition switch in ACCESSORY (I)
or LOCK (0), you will hear a
reminder chime when you open the
driver’s door.
The rotating switch on the lef t lever
controls the lights. Turning this
switch to the position turns on
the parking lights, taillights,
instrument panel lights, side marker
lights, and rear license plate lights.
Turning the switch to the position turns on the
headlights. 62
U.S. models only
Headlights
Controls Near the Steering Wheel
Inst rument s and Cont rols68

The high beams will stay on f or as
long as you hold the lever back, no
matter what position the headlight
switch is in. To f lash the high beams, pull the
turn signal lever back lightly, then
release it. The high beams will come
on and go off.The Automatic Lighting f eature
turns on the headlights, all other
exterior lights, and the instrument
panel lights when it senses low
ambient light.
To turn on automatic lighting, turn
the light switch to AUTO at any time.
The lights will come on automatically
when the outside light level becomes
low (at dusk, f or example). TheLights On indicator comes on as a
reminder. The lights and indicator
will turn of f automatically when the
system senses high ambient light.
The lights will remain on when you
turn of f the ignition switch. They will
turn of f automatically when you open
the driver’s door. To turn them on
again, either turn the ignition switch
to ON (II) or turn the light switch to
.
Even with the automatic lighting
f eature turned on, we recommend
thatyouturnonthelightsmanually
when driving at night or in a dense
f og, or when you enter dark areas,
such as long tunnels or parking
structures.
CONT INUED
On U.S. models
Automatic Lighting
Inst rument s and Cont rols
Controls Near the Steering Wheel
69
AUTO POSITION

The automatic lighting f eature is
controlledbyasensorlocatedontop
of the dashboard. Do not cover this
sensor or spill liquids on it.With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
of f , even if you set the parking brake.
The headlights revert to normal
operation when you turn them on
with the switch.
Do not leave the light switch in
AUTO if you will not be driving the
vehicle f or an extended period (a
weekormore).Youshouldalsoturn
of f the lights if you plan to leave the
engine idling or the engine of f f or a
long time. This will prevent the
battery f rom discharging.
Daytime Running L ights
(Canadian Models)
Controls Near the Steering Wheel
Inst rument s and Cont rols70
LIGHT
SENSOR

Turn the f og lights on and of f by
pressing the button. The indicator in
the button lights to show the f og
lights are on.
To signal a lane change, push lightly
on the turn signal lever in the proper
direction and hold it. The lever will
return to the center position as soon
as you release it.
You can use the f og lights only when
the headlights are on low beam.
They will go of f when you turn the
headlights of f or onto high beam.
With the light switch in the AUTO
position, you can also use the f og
lights when the headlights turn on
automatically. They will go of f when
the headlights turn of f .
U.S. models only
Fog Lights
Controls Near the Steering Wheel
Inst rument s and Cont rols72
Cars without Navigation System

Check the operation of your car’s
exterior lights at least once a month.
A burned out bulb can create an
unsaf e condition by reducing your
car’s visibility and the ability to
signal your intentions to other
drivers.
Lights
Maint enance286
HIGH BEAM HEADLIGHT LOW BEAM HEADLIGHT
FRONT FOG LIGHT TURN SIGNAL/ PARKING LIGHTSIDE MARKER LIGHT

Check the f ollowing:Headlights (low and high beam)
Fog lights
Parking lights
Taillights
Brake lights
Turn signals
Back-up lights
Hazard light f unction
License plate lights
Side marker lights
High-mount brake light
Daytime running lights (Canadian
models)
If you f ind any bulbs are burned out,
replace them as soon as possible.
Refer to the chart on page to
determine what type of replacement
bulb is needed. 339
Lights
Maint enance287
HIGH-MOUNT BRAKE LIGHT
TURN SIGNAL LIGHT
LICENSE PLATE
LIGHTS BACK-UP LIGHT BRAKE/TAILLIGHTS

Halogen bulbs are used f or the high
beam headlight bulbs. When
replacing a high beam headlight bulb,
handle it by its base and protect the
glass from contact with your skin or
hard objects. If you touch the glass,
clean it with denatured alcohol and a
clean cloth.Open the hood.
Remove the electrical connector
f rom the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.
Theheadlightswereproperlyaimed
when your car was new. If you
regularly carry heavy items in the
trunk or pull a trailer, readjustment
may be required. Adjustment of the
headlights should be perf ormed by
an Acura technician or other
qualif ied mechanic.
The low beam headlight bulbs are a
type of high voltage discharge tube.
High voltage can remain in the
circuit even with the light switch of f
and the key removed. Because of
this, you should not attempt to
examine or change a low beam
headlight bulb yourself . If a low
beam headlight bulb fails, take the
vehicle to your dealer to have it
replaced. 1.
2.
3.
Lights
Maint enance
Headlight A iming
Replacing a High Beam Headlight
Bulb
288
Halogen bulbs get very hot when lit. Oil,
perspiration, or a scratch on the glass
can cause the bulb to overheat and
shatter.