headlights Acura RSX 2003 Owner's Manual

Your Car at a Glance
3
TILT ADJUSTMENTHORN INSTRUMENT PANEL
BRIGHTNESS
(P.
70)
WINDSHIELD WIPERS/
WASHERS
HAZARD WARNING LIGHTS
REAR WINDOW DEFOGGER
CRUISE CONTROL
(P. 149)
MOONROOF
(P. 93)
HEADLIGHTS/TURN SIGNALS
(P.69/ 70) (P.
70/ 71)
(P.
73) (P.
73)
(P. 74)

This section gives inf ormation about
the controls and displays that
contribute to the daily operation of
your Acura. All the essential controls
are within easy reach............................
Control Locations .58
...............................
Indicator Lights .59
Maintenance Required ...................................
Indicator .64 .........
Security System Indicator . 65
.............................................
Gauges .66
...............................
Speedometer .66
.................................
Tachometer .66
.....................................
Odometer .66
...................................
Trip Meter .67
..................................
Fuel Gauge .67
...................
Temperature Gauge . 67
Controls Near the Steering .......................................
Wheel .68
...................................
Headlights .69
............
Daytime Running Lights . 69
....
Instrument Panel Brightness . 70
................................
Turn Signals .70
.....................
Windshield Wipers .71
..................
Windshield Washers . 72
Rear Window Wiper and .....................................
Washer .72
..........................
Hazard Warning .73
.............
Rear Window Def ogger . 73
......
Steering Wheel Adjustment . 74
...............................
Keys and Locks .75
..............................................
Keys .75
....................
Immobilizer System . 76
............................
Ignition Switch .77
..................................
Door Locks .79 .........
Power Door/Hatch Locks . 80
............................................
Hatch .80
...................
Remote Transmitter . 81
....................................
Glove Box .84
............................
Seat Adjustments .85
.............
Front Seat Adjustments . 85
Driver’s Seat Height ..............................
Adjustment .86
...........
Driver’s Lumbar Support . 86
........................
Rear Seat Access .86
...........................
Folding Rear Seat .87
....................................
Seat Heaters .88
...........................
Cargo Area Cover .89
..............................
Power Windows .90
.........................................
Moonroof .93
.............................................
Mirrors .94
....
Adjusting the Power Mirrors . 94
.................................
Parking Brake .95
..................................
Vanity Mirror .96
........................................
Coat Hook .96
.............................
Beverage Holder .97
...................
Console Compartment . 98
...............
Accessory Power Socket . 99
.................................
Interior Lights .99
Instruments and Controls
Inst rument s and Cont rols57

The lef t or right turn signal light
blinks when you signal a lane change
or turn. If the light does not blink or
blinks rapidly, it usually means one
of the turn signal bulbs is burned out
(see page ). Replace the bulb as
soon as possible, since other drivers
cannot see that you are signaling.
WhenyouturnontheHazard
Warning switch, both turn signal
lights blink. All turn signals on the
outside of the car should f lash.This lights when you set the cruise
control. See page f or inf ormation
on operating the cruise control.
This light comes on if either door is
not closed tightly.
This light comes on as a reminder
that you must ref uel soon.This light comes on with the high
beam headlights. See page for
inf ormation on the headlight
controls.
246 149
69
Only on models equipped with Cruise
Control System
Indicator L ights
Inst rument s and Cont rols
Turn Signal and
Hazard Warning
Indicators Cruise Control Indicator
Door-open Indicator
Low Fuel Indicator High Beam Indicator
62

This indicator comes on f or a f ew
seconds when you turn the ignition
switch ON (II). It will then go of f if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink
and the engine will not start (see
page ).
This indicator also blinks several
times when you turn the ignition
switch f rom ON (II) to ACCESSORY
(I) or LOCK (0).This indicator lights when you turn
the ignition switch to ON (II) with
the headlight switch of f and the
parking brake set. It should go of f if
youturnontheheadlightsorrelease
the parking brake. If it comes on at
any other time, it means there is a
problem with the DRL. There may
also be a problem with the high
beam headlights.
This light comes on when the
washer f luid level is low. Add washer
f luid when you see this light come on
(see page ).
76 216Canadian models only
Canadian models only
Indicator L ights
Inst rument s and Cont rols
Immobilizer System
Indicator Washer Level Indicator
‘‘Daytime Running
Lights’’ Indicator
63

Thetwoleversonthesteering
column contain controls f or driving
f eatures you use most of ten. The lef t
lever controls the turn signals,
headlights, and high beams. The
right lever controls the windshield
washers and wipers.
The controls on the dashboard to the
right of the steering column are f or
the instrument panel brightness,
hazard warning lights and rear
window def ogger.
The moonroof switch and cruise
control switch are to the left of the
steering column.
The tilt adjustment lever on the
underside of the steering column
allows you to tilt the steering wheel.
Controls Near the Steering Wheel
Inst rument s and Cont rols68
WINDSHIELD
WIPERS/WASHERSHAZARD WARNING LIGHTS REAR WINDOW
DEFOGGER
INSTRUMENT PANEL
BRIGHTNESS
HORN
TILT ADJUSTMENT
HEADLIGHTS/
TURN SIGNALS
MOONROOF CRUISE
CONTROL

To f lash the high beams, pull the
turn signal lever back lightly, then
release it. The high beams will come
on and go of f .
The high beams will stay on f or as
long as you hold the lever back, no
matter what position the headlight
switch is in.
With the headlight switch off, the
high beam headlights come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
of f , even if you set the parking brake.
To change between low beams and
high beams, pull the turn signal lever
until you hear a click, then let go.
The blue high beam indicator will
light (see page ). The headlights revert to normal
operation when you turn them on
with the switch.
The rotating switch on the lef t lever
controls the lights. Turning this
switch to the ‘‘ ’’ position turns
on the parking lights, taillights,
instrument panel lights, side-marker
lights, and rear license plate lights.
Turning the switch to the ‘‘ ’’
position turns on the headlights. If you leave the lights on with the
ignition switch in ACCESSORY (I)
or LOCK (0), you will hear a
reminder beeper when you open the
driver’s door.
62
Headlights
Daytime Running L ights
(Canadian Models)
Controls Near the Steering Wheel
Inst rument s and Cont rols69

Panic mode allows you to remotely
activate your vehicle’s horn and
lights to attract attention. When
activated, the horn will sound, and
the headlights, parking lights, side
marker lights, taillights and
instrument panel lights will f lash f or
about 30 seconds. To activate panic
mode,pressandholdthePANIC
button f or about one second.
To cancel Panic mode bef ore 30
seconds, press any button on the
remote transmitter. You can also
turn the ignition switch to ON (II).
Panic mode will not activate if the
key is in the ON (II) position.When the remote transmitter’s
battery begins to get weak, it may
take several pushes on the button to
lock or unlock the doors and the
tailgate, and the LED will get dim.
Replace the battery as soon as
possible.
Battery type: CR2025To replace the battery, place a cloth
on the edge of the transmitter and
remove the upper half by carefully
prying on the edge with a small f lat-
tip screwdriver.
Panic Mode
Replacing t he Bat t ery
Keys and Locks
Inst rument s and Cont rols82

To open or close the driver’s window
partially, push down or pull back on
the window switch lightly and hold it.
The window will stop when you
release the switch.
If the driver’s window runs into any
obstacle while it is closing
automatically, it will stop, and then
reverse direction. To close the
window, remove the obstacle, then
use the window switch again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it.If your car’s battery is disconnected
or goes dead, or the driver’s window
f use is removed, the AUTO f unction
will be disabled. The power window
system needs to be reset af ter
reconnecting the battery or installing
the f use. You should do the f ollowing.
Start the engine. Push down on
the driver’s window switch until
the window is f ully open.
Pull back on the driver’s window
switch to close the window
completely, then hold the switch
f or a second or two more.
If the power windows do not operate
properly af ter resetting, have your
car checked by a Honda dealer.
The MAIN switch controls power to
the passenger’s window. With this
switch of f , the passenger’s window
cannot be raised or lowered. The
MAIN switch does not af f ect the driv-
er’s window. Keep the MAIN switch
off whenyouhavechildreninthecar
so they do not injure themselves by
operating the window unintentionally.
The lights inside the switches come
onwhenyouturntheparkinglights
or headlights on and the ignition
switch is ON (II).
1.
2.
Auto Reverse
Power Windows
Inst rument s and Cont rols92

Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.
The inside mirror has day and night
positions. The night position reduces
glare f rom headlights behind you.
Flip the tab on the bottom edge of
the mirror to select the day or night
position.Adjust the outside mirrors with the
adjustment switch on the lef t side of
the dashboard:
Turn the ignition switch ON (II).
Move the selector switch to L
(driver’s side) or R (passenger’s
side). Push the appropriate edge of the
adjustment switch to move the
mirrorright,left,up,ordown.
When you f inish, move the
selector switch to the center (off)
position. This turns of f the
adjustment switch so you can’t
move a mirror out of position by
accidentally bumping the switch.
1.
2. 3.
4.
Adjusting the Power Mirrors
Mirrors
Inst rument s and Cont rols94
TAB
SELECTOR SWITCH ADJUSTMENT SWITCH

Once the security system is set,
opening either door (without using
the key or the remote transmitter),
or the hood, will cause it to alarm. It
also alarms if the radio is removed
f rom the dashboard or the wiring is
cut.Do not attempt to alter this system
or add other devices to it.
The security system sets auto-
matically fifteen seconds after you
lock the doors, hood, and hatch. The
security system indicator on the
instrument panel starts blinking
immediately to show you the system
is setting itself . The security system will not set if
the hood, hatch, or either door is not
f ully closed. If the system will not set,
check the Door Open Indicator on
the instrument panel (see page ),
to see if the doors are f ully closed.
Since they are not part of the
monitor display, manually check the
hood and hatch.
The security system helps to protect
your car and valuables f rom thef t.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights f lashes if
someone attempts to break into your
carorremovetheradio.Thisalarm
continues f or two minutes, then the
alarm stops. To reset an alarming
system bef ore the two minutes have
elapsed, unlock either door with the
key or the remote transmitter.
61
Security System
Comf ort and Convenience Feat ures148
SECURITY SYSTEM LIGHT