clock Acura RSX 2004 Owner's Manual

µ
µ
µ µ
µ
µ
µ
µ µ
The wipers are not activated.
The wipers run at low speed.
The wipers run at high speed. Rotate clockwise to turn the rear
window wiper on.
Hold past ON to turn the window
wiper on and the window washer
to spray.
OFF
Rotate counterclockwise to turn
the window wiper on and the
window washer to spray.
The length of the wiper
interval is varied automatically
according to the vehicle’s speed.
Vary the delay by turning the INT
TIME ring. If you turn it to the
shortest delay, the wipers will
change to low speed operation
when the vehicle speed exceeds 12
mph (20 km/h).
Push the right lever up or down to
select a position. MIST
OFF
INT Intermittent
LO Low
HI High
Windshield Washers
The wipers run at high
speed until you release the lever. Pull the
wiper control lever toward you and
hold it. The washers spray until
you release the lever. The wipers
run at low speed, then complete
one more sweep af ter you release
the lever.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
OFF
LO
HI
Rear Window Wiper and Washer
INT
MIST Windshield Wiper Windshield Washer
Inst rument s and Cont rols
Wipers and Washers
59

...............
Vents, Heating, and A/C . 88
............................
Playing the Radio .92
..............................
Radio Reception .96
.................................
Playing a Tape .98
..................................
Playing a CD .101
..........
Playing a CD, CD Changer . 102
.......................................
CD Player .102
...................................
CD Changer .103
....................
Protecting Your CDs .108
.........
CD Player Error Messages . 109
.....
CD Changer Error Messages . 110
.................
Radio Thef t Protection . 112
..........................
Setting the Clock .113
............................
Security System .114
...............................
Cruise Control .115
Comf ort and Convenience Features
Comf ort and Convenience Feat ures87

Air conditioning places an extra load
on the engine. Watch the engine
coolant temperature gauge (see page) when using the A/C in heavy
traf f ic or driving up long hills. If it
moves near the red zone, turn of f the
air conditioning until the gauge
reads normally.
This button controls the source of air
going into the system. When the
indicator in this button is on, the
system is recirculating the interior
air (Recirculation mode). When the
indicator is of f , f resh air is brought
in f rom outside the vehicle (Fresh
Air mode). Push the button to
change between recirculated and
f resh air. Use Recirculation mode to heat or
cool the interior more quickly, or to
keep out smoke and dust. Leaving
the system in the Recirculation mode
with the A/C off can cause the
windows to fog up. Switch to Fresh
Air mode as soon as the interior
reaches a comf ortable temperature
or the outside smoky, dusty condi-
tion clears.
You can manually select the f an
speed by turning the f an speed
control dial. Turning this dial
clockwise increases the f an speed,
which increases air flow.
When the dial is set to AUTO, the
system controls the f an speed
automatically.
Use this dial to select the direction of
airf low coming out of the system.
Some air will come out of the side
vents in all modes.
In AUTO mode, the system controls
the air f low direction automatically
between the dashboard vents and
the f loor vents.
The main air flow comes out
of the dashboard vents.
The main air flow is directed
to the floor vents.
The main air flow is divided
between the floor vents and
defroster vents at the base of the
windshield.
57
Vents, Heating, and A/C
Comf ort and Convenience Feat ures
Recirculat ion But t on
Fan SpeedMode Cont rol Dial
90

If your vehicle’s battery is
disconnected or goes dead, you will
need to set the clock.
Press and hold the CLOCK button.
ChangethehourbypressingtheH
button until the numbers advance to
the desired time. Change the minute
by press the M button until the
numbers advance to the desired time.When you are f inished, release the
CLOCK button.
You can quickly set the time to the
nearest hour. If the displayed time is
bef ore the half hour, pressing and
holding the CLOCK button, then
pressing the R (RESET) button sets
the clock back to the previous hour.
If the displayed time is after the halfhour, the clock sets f orward to the
beginning of the next hour.
1:06 will reset to 1:00
1:52 will reset to 2:00
For example :
Setting the Clock
Comf ort and Convenience Feat ures
A ll models except T ype-S
T ype-S
113
CLOCK BUTTON
M BUTTON RESET BUTTON
H BUTTON
M BUTTON
H BUTTON RESET
BUTTON
CLOCK BUTTON

If Honda antif reeze/coolant is not
available, you may use another
major-brand non-silicate coolant as a
temporaryreplacement.Makesureit
is a high-quality coolant
recommended f or aluminum engines.
Continued use of any non-Honda
coolant can result in corrosion,
causing the cooling system to
malf unction or f ail. Have the cooling
system f lushed and ref illed with
Honda antif reeze/coolant as soon as
possible.When the radiator and engine are
cool, relieve any pressure in the
cooling system by turning the
radiator cap counterclockwise,
without pressing down.
Remove the radiator cap by
pushing down and turning
counterclockwise.
If the reserve tank is completely
empty, you should also check the
coolant level in the radiator.
2. 1.
Engine Coolant
Maint enance168
RADIATOR CAP
Removing the radiator cap
while the engine is hot can
cause the coolant to spray out,
seriously scalding you.
Always let the engine and
radiator cool down before
removing the radiator cap.

If you need to change a f ront turn
signal bulb on the passenger’s side,
remove the power steering
reservoir f rom the bracket.If you need to change a f ront turn
signal bulb on the driver’s side,
remove the bolt f rom the battery
hold-down, and caref ully push the
battery toward the windshield to
obtain enough working space.Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket.
1.
2.
3.
Lights
Maint enance
Replacing a Front T urn Signal
Bulb
176
Passenger’s side
POWER STEERING RESERVOIR BULB
Driver’s side

Pull the bulb straight out of its
socket.
The f ront parking bulb is next to
the headlight bulb.
Remove the socket from the
headlight assembly by turning it
one-quarter turn counterclockwise.
Install the new bulb into the
socket.
(Passenger’s side)
Install the power steering
reservoir on the bracket.
(Driver’s side)
Place the battery in its original
position, then install the bolt in the
hold-down, and tighten it securely.
Install the new bulb into the
socket.
3.
4.
5.
1.
2.4.
Replacing a Front Parking Bulb
Lights
Maint enance177
BULB

Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
Insert the socket back into the
light assembly. Turn it clockwise
to lock it in place.
Testthelightstomakesurethe
new bulb is working.
Reinstall the high-mount brake
light cover.
Open the hatch.
Remove the high-mount brake
light cover by pivoting it toward
the back of the vehicle.
Remove the socket by turning it
one-quarter turn counterclockwise. Open the hatch. Remove the light
assembly cover by pulling on the
tabontheoutsideedge.
2.
3. 1. 4.
5.
6.
7.
1.
Lights
Maint enance
Replacing Rear Bulbs
Replacing a High-mount Brake
Light Bulb
178
COVER
COVER BULB

Reinstall the socket into the light
assembly by turning it clockwise
until it locks.
Testthelightstomakesurethe
new bulb is working.
Install the light assembly cover.
Make sure it locks in place.
Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms. Remove the socket by turning it
one-quarter turn counterclockwise. Determinewhichof thefivebulbs
is burned out: brake/taillight, turn
signal light, side marker light,
back-up light, or taillight.
2.
3.
4. 5.
6.
7.
Lights
Maint enance179

Lift the bass speaker out of the
spare tire and set it aside. Do not
pull on the wiring harness going to
the speaker.
Take the spare tire out of its well.Turn the jack’s end
counterclockwise to loosen it, then
remove the jack.Loosen each wheel nut 1/
2turn
with the wheel wrench.
5.
6. 7.8.
Type-S only:
Changing a Flat T ire
T aking Care of t he Unexpect ed194
BASS SPEAKER
(Type-S only) JACK