lights Acura TL 2007 Owner's Guide

Remove the socket by turning it
one-quarter turn counterclockwise. Open the trunk.
Using a small screwdriver, pop up
the pin in the center of the
f astener, then remove the f astener.
Unscrew and remove the cargo
net hook f rom the f ender. Pull
back the trunk lining.
Push the inner f ender cover in
place. Install the holding clips, and
lock them in place by pushing on
their center. Turn on the f og lights to test the
new bulb. Push the electrical connector back
onto the bulb. Make sure it is on
all the way. Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place. Remove the bulb by turning it
about one-quarter turn
counterclockwise. Remove the electrical connector
f rom the bulb by pushing on the
tab and pulling the connector
down.
Use a f lat-tipped screwdriver to
remove the holding clips f rom the
edge of the inner f ender cover,
and pull the inner f ender cover
back. 3.
2. 4.
5.
6.
7.
8.
1.
2. Replacing the Rear Turn Signal
Bulb (in Fenders)
Lights
296
Halogen bulbs get very hot when lit. Oil,
perspiration, or a scratch on the glass
can cause the bulb to overheat and
shatter.
——
y

y
(%y
y

Insert the fastener into the hole on
the side of the trunk lining, and
push in the head of the f astener.
Screw the cargo net hook into the
f ender.Determine which back-up light
is out (lef t or right), then open
the trunk.
Reinstall the trunk lining. Make
sure it is installed under the edge
of the trunk seal.
Testthelightstomakesurethe
new bulb is working. Reinstall the socket into the light
assembly by turning it clockwise
until it locks. Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
3.
4.
5. 6.
7.
1a.
CONT INUED
Replacing the Back-up L ight Bulb
(in T runk L id)
Lights
Maint enance
297
RIGHT STOPCORNER
FASTENER
LEFT STOP
TRUNK LID
INNER
HANDLE
LEFT SIDE FASTENER
CORNER
FASTENER
——
y
y
(%yy

Popupthepininthecenterof
the lef t or right corner f astener
with a small screwdriver, and
remove the fastener.Remove the lef t side
f astener the same way.
Pull out the outside edge of the
rubber stop, then push the stop
outward, and pull it to remove it.
Remove the screw from the
trunk lid inner handle, and
removethehandletrim.
Pull back the corner of the
trunk lid lining.Remove the socket by turning it
one-quarter turn counterclockwise.
Pull the bulb straight out of its
socket. Push the new bulb straight
into the socket until it bottoms.
c. b.
2.
3.
d.
e.
Lef t side
only:
Lights
298
——
y
y
(%yy

Insert the socket into the light
assembly. Turn it clockwise to
lock it in place.
Testthelightstomakesurethe
new bulb is working.
Reinstall the trunk lid lining. Make
sure it is installed under the edge
of the trunk seal.
Install all removed parts.If your seat belts get dirty, use a sof t
brush with a mixture of mild soap
and warm water to clean them. Do
not use bleach, dye, or cleaning
solvents. Let the belts air-dry bef ore
you use the vehicle. Dirt build-up in the loops of the seat
belt anchors can cause the belts to
retract slowly. Wipe the insides of
the loops with a clean cloth
dampened in mild soap and warm
water, or isopropyl alcohol.
4.
5.
6.
7. Cleaning the Seat Belts
Lights, Cleaning the Seat Belts
Maint enance
299
LOOP
——
y
y
(%yy

Turn on the hazard warning lights,
and turn the ignition switch to the
LOCK (0) position. Have all
passengers get out of the vehicle
while you change the tire.Open the trunk. Raise the trunk
f loor by lif ting up on the back edge.
Take the tool case out of the spare
tire.
Unscrew the wing bolt and take
the spare tire out of its well.
Park the vehicle on f irm, level, and
non-slippery ground. Put the
transmission in Park (automatic)
or reverse (manual). Apply the
parking brake.
If you have a f lat tire while driving,
stop in a saf e place to change it.
Drive slowly along the shoulder until
you get to an exit or an area that is
far away from the traffic lanes.
5. 4.
3.
2. 1.
CONT INUED
Changing a Flat Tire
T aking Care of t he Unexpect ed
313
TOOL CASE
JACK
SPARE TIRE TRUNK FLOOR
The vehicle can easily roll off
the jack, seriously injuring
anyone underneath.
Follow the directions for
changing a tire exactly, and
never get under the vehicle
when it is supported only by the
jack.
——
y
y
(%y
y

Diagnosing why the engine won’t
start falls into two areas, depending
on what you hear when you turn the
ignition switch to the START (III)
position: You hear nothing, or almost
nothing. The engine’s starter
motor does not operate at all, or
operates very slowly.
You can hear the starter motor
operating normally, or the starter
motor sounds like it is spinning
faster than normal, but the engine
does not start up and run. When
you turn the ignition switch to
the START (III) position, you do not
hear the normal noise of the engine
trying to start. You may hear a
clicking sound, a series of clicks, or
nothing at all. Turn
the ignition switch to the
START (III) position. If the
headlights do not dim, check the
condition of the fuses. If the fuses
are OK, there is probably
something wrong with the
electrical circuit for the ignition
switch or starter motor. You will
need a qualified technician to
determine the problem. See
on page .
If the headlights dim noticeably or
go out when you try to start the
engine, either the battery is
discharged or the connections are
corroded. Check the condition of
the battery and terminal connec-
tions (see page ). You can
then try jump starting the vehicle
from a booster battery (see page
).
Turn
the ignition switch to the ON
(II) position. Turn on the
headlights, and check their
brightness. If the headlights are
very dim or do not come on at all,
the battery is discharged. See
on page .
Check the transmission interlock.
If you have a manual transmission,
the clutch pedal must be pushed
all the way to the f loor or the
starter will not operate. With an
automatic transmission, the shif t
lever must be in Park or neutral.
Check these things:
320 331
308
320
If theEngineWon’tStart
Nothing Happens or the Starter
Motor Operates Very Slowly
Emergency T owing
Jump Starting
318
——
y
y
(%yy

´´
Although this seems like a simple
procedure, you should take several
precautions.
You cannot start a vehicle with an
automatic transmission by pushing
or pulling it.
Open the hood, and check the
physical condition of the battery.
In very cold weather, check the
condition of the electrolyte. If it
seems slushy or like ice, do not try
jump starting until it thaws.
The numbers in the illustration
show you the order to connect the
jumper cables.
Connect one jumper cable to the
positive ( ) terminal on your
battery. Connect the other end to
the positive ( ) terminal on the
booster battery.
Turn of f all the electrical
accessories: heater, A/C, audio
system, lights, etc. Put the
transmission in neutral (M/T) or
Park (A/T), and set the parking
brake.
1.
2.
3.
Jump Starting
To Jump Start Your Vehicle:
320
A battery can explode if you do
not follow the correct procedure,
seriously injuring anyone
nearby.
Keep all sparks, open flames,
and smoking materials away
from the battery.If a battery sits in extreme cold, the
electrolyte inside can f reeze.
Attempting to jump start with a f rozen
battery can cause it to rupture.
——
y

y
(%yy

Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are off.
Remove the cover from the fuse
box.
The vehicle’s fuses are contained in
two fuse boxes. The interior fuse
box is on the driver’s lower left side.
To remove the fuse box lid, put your
finger in the notch on the lid, pull it
toward you, and take it out of its
hinges.
The under-hood fuse box is on the
driver’s side next to the air cl
eaner
housing. Check each of the large fuses in
the under-hood fuse box by
looking through the top at the wire
inside. Remove the screws with a
Phillips-head screwdriver.
If something electrical in your
vehicle
stops working, check for a
blown fuse first. Determine from the
chart on pages and , or the
diagram on the f use box lid, which
f uses control that device. Check
those fuses first, but check all the
f uses bef ore deciding that a blown
f use is the cause. Replace any blown
f uses, and check if the device works. 1.
2.
3.
329 330
CONT INUED
Checking and Replacing Fuses
Fuses
T aking Care of t he Unexpect ed
327
UNDER-HOOD
INTERIOR
FUSE
BLOWN
——
y


y
(%yy

No.No. Amps.
Circuits Protected Circuits Protected
Amps.
1
2
3
4
5
6
7
8
9 10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
337.5 A
30 A
7.5 A 20 A
20 A
20 A
20 A
20 A
15 A
15 A
15 A
7.5 A 10 A
7.5 A 20 A
20 A
30 A
30 A
20 A
7.5 A
7.5 A
7.5 A
7.5 A
7.5 A
DBW
IG1 Coil
Daytime Running Light
LAF
Radio
Interior Lights
Back Up
Door Lock
Accessory Socket IG1 OPDS
IG1 Wiper
TPMS
Driver’s Power Seat (Slide)
Seat Heater
Driver’s Power Seat (Recline)
Passenger’s Power Seat (Slide)
IG1 ACG
IG1 Fuel Pump
Washer
Meter
SRS
IGP
Rear Left Power Window
Rear Right Power Window
Front Right Power Window
Front Left Power Window
Moonroof
VBSOL
HAC
OP2
ACC
HAC OP
15 A
15 A
15 A
15 A
20 A
7.5 A
7.5 A 20 A
15 A
Passenger’s Power Seat (Recline)
Fuse Locations
330
INTERIOR FUSE BOX
——
y



y
(%yy

µ µ
Î
Î Î
Î
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
µ
Î
ÎÎ
Î
Î
Î
Specifications
T
echnical Inf ormat ion
339
Tires Alignment Engine
Battery
Fuses Lights 3.50 x 3.39 in (89.0 x 86.0 mm)
Water
cooled 4-stroke
SOHC VTEC 6-cylinder (V6),
gaso line engine
12 V 21 W/2.2 CP
12
V 60 W (HB3)
12
V 35 W (HID)
Size
Pressure
Toe-in
Camber
Caster
60 psi (420 kPa , 4.2 kgf/cm
)
235/45R17
93W
P235/45R17
93W
3°17’
1°00’ 0°30’
0.00
in (0.0 mm)
0.00
in (0.0 mm)
11.0
: 1
195.9
cu-in (3,210 cm
)
IZFR6K-11
SKJ20DR-M11
Type
BorexStroke
Displacement
Compression
ratio
Spark plugs
12
V
4CP 5W
2CP
5W
5W
3CP
21 CP
51
W (HB4)
21 W
32 psi (220 kPa , 2.2 kgf/cm
)
35
psi (240 kPa , 2.4 kgf/cm)
33
psi (230 kPa , 2.3 kgf/cm)
Capacity
12 V 72 AH/20 HR
Interior
Under-hood 12
V 3.50
x 3.66 in (89.0 x 93.0 mm)
211.8 cu-in (3,471 cm
)
12 V
12 V
12 V
12 V
12 V
12 V
12 V
Headlight
(High
beam/Low beam)
DRL
Front turn signal/parking
lights
Front Fog lights
Rear turn signal
Back-up lights
License plate light
Ceiling light
Trunk light
Door courtesy lights
Vanity mirror lights
Map lights
See page 330 or the fuse label
attached to the inside of the fuse
box door on each side of the
dashboard.
See page 329 or the fuse box
cover. T145/70R17 106M T135/80R16 101M
Front
Rear
Front
Rear
Front NGK:
DENSO:
Front/Rear
Spare
Front
Rear
Spare
Summer tire
1:
2:
3:
All season tire
Type S
Type S
:
1
3
3
2
——
y
y
(%yy