Acura TL 2014 Owners Manual

Î
Î
This shows the estimated distance
you can travel on the fuel remaining
in the f uel tank. This distance is
estimated f rom the f uel economy
you received over the last several
miles (U.S.) or kilometers (Canada),
so it will vary with changes in speed,
traf f ic, etc. This shows the accumulated
traveling time since you last reset it.
When you turn the ignition switch
to the ON (II) position, ELAPSED
TIME is reset.
Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. ON Mode
is the equivalent of ON (II). For
more inf ormation, see pagesand .
You can customize the ELAPSED
TIME reset conditions on the multi-
inf ormation display (see page ). This shows the average speed you
are traveling in miles per hour (mph)
forU.S.modelsorkilometersper
hour (km/h) f or Canadian models.
:
187
184
106
Multi-Inf ormation Display
RA NGE EL A PSED T IMEA VG. SPEED
Inst rument s and Cont rols
85
12/08/03 20:55:17 31TK4640_090

This shows the outside Fahrenheit
temperature in U.S. models, and
Celsius temperature in Canadian
models.In certain weather conditions,
temperature readings near f reezing
(32°F, 0°C) could mean that ice is
f orming on the road surf ace.
You can adjust the outside
temperature display (see page ). The temperature sensor is in the
f ront bumper. The temperature
reading can be affected by heat
ref lection f rom the road surf ace,
engine heat, and the exhaust f rom
surrounding traf f ic. This can cause
an incorrect temperature reading
when your vehicle speed is under
19 mph (30 km/h). When you start
your trip, the sensor is not f ully
acclimatized, theref ore it may take
several minutes until the proper
temperature is displayed.
This shows the remaining engine oil
lif e. It shows 100% af ter the engine
oil is replaced and the display is reset.
The engine oil lif e is calculated
based on engine operating conditions.
For more inf ormation, see page .
104 531
Outside Temperature Engine Oil Lif e
Multi-Inf ormation Display
86
OUTSIDE TEMPERATURE
ENGINE OIL LIFE
U.S.
U.S. model is shown.
Canada
12/08/03 20:55:25 31TK4640_091

You can see the pressure of each tire
in this monitor. If one or more tires
are low, inflate them to the correct
pressure. For more inf ormation, see
page .This monitor shows how much
torque is being delivered to each
wheel. For more inf ormation, see
page .
515
504
SH-AWD models only
T ire Pressure Monitor SH-A WD T orque Distribution
Monitor
Multi-Inf ormation Display
Inst rument s and Cont rols
87
U.S. Canada
U.S. model is shown.
Example:
Example:
Technology Package is
shown. Technology Package is
shown.
12/08/03 20:55:32 31TK4640_092

You can receive or make phone calls
f rom your cell phone through your
vehicle’s
HandsFreeLink
(HFL) system without touching your
cell phone.To use the system, your cell phone
and the HFL system must be linked.
Not all cell phones are compatible
with this system. Ref er to page
for instructions on how to link
your cell phone to HFL and how to
receive or make phone calls, or visit
the acura.com/handsf reelink
website. In Canada, visit , or call (888) 528-
7876.
YoucanseeHFLinformationonthe
navigation screen (see page ). 412
427
Bluetooth
On models without navigation system www.
handsf reelink.ca
On models with navigation system
Multi-Inf ormation Display
Bluet oot hHandsFreeL ink
88
U.S. model is shown.
12/08/03 20:55:38 31TK4640_093

ÛÝÛÝ
ÛÝ
If there is a problem with your
vehicle, f or example the engine oil
level is low or a door is not f ully
closed, the multi-inf ormation display
will show you the problem. It does
this by interrupting the current
display with one or more messages. The system message(s) triggers the
appropriate indicator(s) on the
instrument panel, including the
system message indicator, to come
on. The system message indicator
does not go of f until the problem(s)
is corrected.
You will also hear a beep when the
system message comes on f or the
first time.
Most of the messages are displayed
f or about 5 seconds, and then the
normal display returns. If there are
several system messages to be
shown, the display switches these
messages every 5 seconds.
To switch the message(s) bef ore 5
seconds have elapsed, press the
INFO( / )buttononthesteering
wheel.
Even if you press the INFO ( / )
button, some messages stay on or
come on again at regular intervals
until the problem is corrected.
If the system message indicator
remains lit on the instrument panel,
you can see the corresponding
message(s) again by pressing the
INFO ( / ) button repeatedly.
On the next page is a list of all
messages:
CONT INUED
System Messages
Multi-Inf ormation Display
Inst rument s and Cont rols
89
A/T model is shown.
SYSTEM MESSAGE INDICATOR
12/07/20 10:41:04 31TK4640_094

See page33
See page
20
See page 20
See page 33
See page
12 See page212
See page 553
See page 598 See page
596
See page 597
See page 595
See page 508
See page 510
See page 510
Multi-Inf ormation Display
90
U.S.
Canada U.S.
Canada
Canada U.S.
Canada U.S.
SH-AWD model only
12/07/20 10:41:16 31TK4640_095

CONT INUED
See page70
Seepage488
Seepage490 See pages
75 and 526
See pages
75 and 526
See page
77
See page 142
See page 516 See page
517
See page 516
See page 517
See page
515
See page494
See page
577
See page73
See page 505
See page 505
On models without
keyless accesssystem
On models withkeyless accesssystem
A/T model
Multi-Inf ormation Display
Inst rument s and Cont rols
91
U.S. model shown U.S. model shown
U.S.
Canada
SH-AWD model only
SH-AWD model only
12/08/03 20:55:52 31TK4640_096

See page196
See page 196
See page 193
See page 194
See page 198
See page
471
See page 548 See page
151
See page
532
See page 533
See page 534
Multi-Inf ormation Display
On models wit h keyless access
syst em
92
On models without
keyless access system
Canadian models only
12/08/03 20:56:01 31TK4640_097

See page189
See page 188
See page 191
See page
200
See page 199
See page 188
See page 190
See page 191
See page 188
Multi-Inf ormation Display
Inst rument s and Cont rols
93
A/T model only
A/T model only
A/T model only
M/T model only
12/07/20 10:41:51 31TK4640_098

ÎÎ
Î
You can customize some vehicle
control settings. To change the
settings, the ignition switch must be
in the ON (II) position, and the
vehicle must be stopped with the
transmission in Park (automatic) or
with the parking brake set (manual). If you try to enter the customizing
mode while the vehicle is moving,
you will see a ‘‘MUST STOP AND
SHIFTTOPARKTOCHANGE
SETTINGS’’ (automatic) or ‘‘MUST
STOP AND SET PARK BRAKE TO
CHANGE SETTINGS’’ (manual)
message and you cannot change the
settings.
You can customize some vehicle
control settings f or ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately.
To have the driver’s ID detected,
make sure the driver’s door is
unlocked with a corresponding
remote transmitter/keyless access
remote.
Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. VEHICLE
OFF (LOCK) Mode is the
equivalent of LOCK (0),
ACCESSORY Mode is the
equivalent of ACCESSORY (I),
and ON Mode is the equivalent
of ON (II). For more
information, see pages and
.
If you turn the ignition switch to the
ACCESSORY (I) or the LOCK (0)
position, move the shif t lever out of
Park (automatic) or release the
parking brake (manual), the display
will change to the normal screen. :
187 184
Multi-Inf ormation Display
Customized Settings
94
12/07/20 10:41:58 31TK4640_099