light Acura TSX 2004 Owner's Guide

Between 8,000 miles (12,800 km)
and 10,000 miles (16,000 km), this
indicator will light f or two seconds
when you first turn the ignition
switch to ON (II), and then flash for
ten seconds.
If you exceed 10,000 miles (16,000
km) without having the scheduled
maintenance perf ormed, this
indicator will remain on as a constant
reminder.Your dealer will reset this indicator
af ter completing the scheduled
maintenance. If this maintenance is
done by someone other than your
Acura dealer, reset the indicator as
f ollows.
Turn of f the engine.
Press and hold the Select/Reset
knob in the instrument panel, then
turn the ignition switch to ON (II).
Hold the knob f or about ten sec-
onds until the indicator resets.
1.
2.
3.
Gauges
Inst rument s and Cont rols68
SELECT/RESET KNOB

Î
Î
The steering wheel adjustment lever
on the underside of the steering
column allows you to tilt and
telescope the steering wheel. The controls under the lef t air vent
are f or the moonroof and the VSA
System.To use the horn, press the pad
around the ‘‘A’’ logo.
Thetwoleversonthesteering
column contain controls f or the
driving f eatures you use most of ten.
The lef t lever controls the turn
signals, headlights, and high beams.
The right lever controls the
windshield washers and wipers.
Inst rument s and Cont rols
Controls Near the Steering Wheel
69
TILT/TELESCOPIC
ADJUSTMENT
HORN
REMOTE AUDIO
CONTROLS
CRUISE
CONTROLS
WINDSHIELD
WIPERS/WASHERS
HAZARD
WARNING
LIGHTS
REAR WINDOW
DEFOGGER
MOONROOF
SWITCH HEADLIGHTS/
TURN SIGNALS
(P.
70/ 73)
(P. 171)
(P. 101)
VEHICLE STABILITY
ASSIST SYSTEM
OFF SWITCH
(P.217) (P.
76) (P.
75, 76)
(P.
75)
(P.
73, 75)
(P. 174)

To change f rom low beams to high
beams, push the turn signal lever
f orward until you hear a click. The
blue high beam indicator will light
(see page ). To return to low
beams, pull the turn signal lever
back.
The rotating switch on the lef t lever
controls the lights. Turning this
switch to the ‘‘ ’’ position turns
on the parking lights, taillights, and
rear license plate light. Turning the
switch to the ‘‘ ’’ position turns
on the headlights. When the light switch is in either of
these positions, the Lights On
indicator comes on as a reminder.
If you leave the lights on with the
key removed f rom the ignition
switch, you will hear a reminder
chime when you open the driver’s
door.
64
Controls Near the Steering Wheel
Inst rument s and Cont rols
Headlights
70

The Automatic Lighting Of f f eature
turns of f the headlights, parking
lights, taillights, and license plate
light within 15 seconds of removing
the key from the ignition switch and
closing the driver’s door.The lights will turn on again when
you unlock or open the driver’s door.
If you unlock the door, but do not
open it within 15 seconds, the lights
will go of f . With the driver’s door
open, you will hear a lights-on
reminder chime.
The high beams will stay on f or as
long as you hold the lever back, no
matter what position the headlight
switch is in. To f lash the high beams, pull the
turn signal lever back lightly, then
release it. The high beams will come
on and go off. This feature activates if you leave
the headlight switch in the ‘‘ ’’
or ‘‘ ’’ position, remove the key,
then open and close the driver’s door.
If you remove the key f rom the
ignition switch with the headlight
switch on, but do not open the door
and get out, the lights will turn of f
af ter ten minutes.
Controls Near the Steering Wheel
Inst rument s and Cont rols
Automatic Lighting Of f Feature
71

With the headlight switch off, the
high beam headlights and the high
beam indicator come on with
reduced brightness when you turn
the ignition switch to ON (II) and
release the parking brake. They
remain on until you turn the ignition
of f , even if you set the parking brake.
The headlights revert to normal
operation when you turn them on
with the switch.The instrument panel will illuminate
with reduced brightness when you
unlock and open the driver’s door.
The brightness will increase slightly
when you insert the key in the
ignitionswitch,thengotonormal
brightness when you turn the
ignition switch to ON (II).
Turntheknobontherightsideof
the instrument panel to adjust the
instrument panel brightness. There
are six brightness levels. When you
turn the knob, the odometer display
changes to circles that show you the
current level. The display returns to
the odometer values f ive seconds
af ter you stop adjusting the knob. If you do not insert the key in the
ignition switch af ter opening and
closing the driver’s door, the
illumination turns of f in about 30
seconds.
If you insert the key but do not turn
the ignition switch to ON (II), the
illumination turns of f in about 10
seconds.
Controls Near the Steering Wheel
Inst rument s and Cont rols
Daytime Running L ights
(Canadian Models)
Instrument Panel Brightness
72

Signal a turn or lane change with this
lever. Push down on the lever to
signal a lef t turn, and up to signal a
right turn. If you push it up or down
all the way, the turn signal continues
to blink even when you release the
lever. It shuts off automatically as
you complete the turn.To signal a lane change, push lightly
on the turn signal lever in the proper
direction and hold it. The lever will
return to the center position as soon
as you release it.
This lever controls the windshield
wipers and washers. It has five
positions:MIST: mist
OFF: off
INT: intermittent
LO: low speed
HI: high speed
To select a position, push the lever
up or down.
CONT INUED
T urn Signals Windshield Wipers
Controls Near the Steering Wheel
Inst rument s and Cont rols73
TURN SIGNAL LEVER

To operate the wipers in mist mode,
push the control lever up f rom the
OFF position. The wipers run at high
speed until you release the lever.
This gives you a quick way to clear
the windshield.
In intermittent, the wipers operate
every f ew seconds. The sweep
interval will change slightly with
speed; getting shorter as you drive
f aster. While the car is stopped and
in gear, the wipers sweep the
windshield whenever you remove
your f oot f rom the brake pedal. In
low speed and high speed, the wipers
run continuously.
You can vary how of ten the wipers
sweep the windshield by turning the
INT TIME ring on the lever.
If you turn the INT TIME ring to the
shortest delay, the wipers will
change from intermittent to low
speed operation when car speed
exceeds 12 mph (20 km/h).
Controls Near the Steering Wheel
Inst rument s and Cont rols74

To clean the windshield, pull back on
the wiper control lever. The washers
spray until you release the lever. The
wipers run at low speed while you’re
pulling the lever, then complete one
more sweep of the windshield af ter
you release it.Push the button between the center
vents to turn on the hazard warning
lights (f our-way f lashers). This
causes all f our outside turn signals
and both turn indicators in the
instrument panel to f lash. Use the
hazard warning lights if you need to
park in a dangerous area near heavy
traf f ic, or if your car is disabled.The rear window def ogger will clear
fog, frost, and thin ice from the
window. Push the def ogger button to
turn it on and of f . The light above
the button lights to show the
def ogger is on. It also shuts of f when
you turn off the ignition. You have to
turn it on again when you restart the
car.
CONT INUED
Windshield Washers
Hazard WarningRear Window Def ogger
Controls Near the Steering Wheel
Inst rument s and Cont rols75
With navigation

Push the lever up to lock the
steering wheel in that position.
Move the steering wheel up or
down, and in or out to the desired
position, making sure the wheel
points toward your chest, not
toward your f ace. Make sure you
can see the instrument panel
gauges and the indicator lights. Make sure you have securely
locked the steering wheel in place
by trying to move it up, down, in,
and out.
Your car comes with two master
keys and a valet key.
The master key fits all the locks on
your car:
 Ignition
 Driver’s door
Glovebox
 Trunk release handle
 Rear seat trunk access
3. 4.
5.
CONT INUED
Keys
Controls Near the Steering Wheel, K eys and L ocks
Inst rument s and Cont rols77
VALET KEY
(LIGHT GREY)
MASTER
KEY
(BLACK)
KEY
NUMBER
TAG

The valet key works only in the
ignition and the driver’s door lock.
You can keep the trunk release
handle, rear seat trunk access, and
glove box locked when you leave
your car and the valet key at a
parking f acility.
Youshouldhavereceivedakey
number tag with your keys. You will
need this key number if you ever
have to get a lost key replaced. Keep
the tag stored in a safe place. If you
need to replace a key, use only an
Acura-approved key blank.These keys contain electronic
circuits that are activated by the
Immobilizer System. They will not
work to start the engine if the
circuits are damaged.
Protect the keys f rom direct
sunlight, high temperature, and
high humidity.
Donotdropthekeysorsetheavy
objects on them.
Keep the keys away f rom liquids.
If they get wet, dry them
immediately with a sof t cloth.
The keys do not contain batteries.
Do not try to take them apart. Your car also comes with two remote
transmitters; see page for an
explanation of the operation.
80Remote Transmitter
Keys and Locks
Inst rument s and Cont rols78