light Acura TSX 2004 Owner's Guide

µ
The ignition switch is on the right
side of the steering column. It has
f our positions:
LOCK(0)
 ACCESSORY (I)
 ON (II)
 START (III) You can insert or
remove the key only in this position.
To switch f rom ACCESSORY to
LOCK, you must push the key in
slightly as you turn it. If your car has
an automatic transmission, the shif t
lever must also be in Park. The anti-
thef t lock will lock the steering
column when you remove the key.
If the f ront wheels are turned, the
anti-thef t lock may sometimes make
it difficult to turn the key from
LOCK to ACCESSORY. Firmly turn
the steering wheel to the lef t or to
the right as you turn the key.
Ignition Switch
L OCK (0)
Keys and Locks
Inst rument s and Cont rols80
Removing the key from the
ignition switch while driving
locks the steering. This can
cause you to lose control.
Remove the key from the
ignition switch only when
parked.

µ
µ
µ In this position,
you can operate the audio system
and the accessory power socket.
This is the normal key
position when driving. All f eatures
and accessories on the car are usable.
Several of the lights on the instru-
ment panel come on as a test when
you turn the ignition switch f rom
ACCESSORY to ON.
Use this position
only to start the engine. The switch
returns to ON (II) when you let go of
the key. You will hear a reminder beeper if
you leave the key in the ignition
switch in the LOCK (0) or
ACCESSORY (I) position and open
thedriver’sdoor.Removethekeyto
turn of f the beeper. The engine will not start if the
Immobilizer System does not
recognize the key’s coding (see page
).
Each f ront door has a master door
lock switch. Either switch locks and
unlocks all doors and the trunk. On
the driver’s door, push the top of the
master door lock switch to lock all
doors and the trunk, and push the
bottom to unlock them.
79
CONT INUED
A CCESSORY (I)
ON (II)
ST A RT (III)
Power Door L ocks
Keys and Locks
Inst rument s and Cont rols81
MASTER DOOR LOCK SWITCH

CONT INUED
You can lock and unlock your car
with the remote transmitter. When
you push the LOCK button, all doors
and the trunk lock. The parking
lights, side marker lights, taillights,
and instrument panel lights f lash
once.When you push the UNLOCK button
once, only the driver’s door unlocks.
The remaining doors and the trunk
unlock when you push the button a
second time. The parking lights, side
marker lights, taillights, and
instrument panel lights f lash twice
each time you push the button.
If you f orget and leave the key in the
ignition switch, Lockout Prevention
will not allow you to lock the driver’s
door. With the driver’s door open
andthekeyintheignition,both
master door lock switches are
disabled. However, if the driver’s
door is not open, the master door
lock switches are not disabled. If you
try to lock an open driver’s door by
pushinginthelocktab,thetabson
all doors pop out. Pushing in the lock
tab on a passenger’s door only locks
that door. When you push the LOCK button a
second time within 5 seconds after
locking the doors, you will hear a
beep to verify that the doors are
locked and the security system has
set.
You can open and close all power
windows from outside the car with
the key. With the remote transmitter,
you can open the windows. Ref er to
Power Windows on page .
100
L ockout Prevent ionRemote Transmitter
Keys and Locks
Inst rument s and Cont rols83
TRUNK
RELEASE
BUTTON
LOCK
BUTTON
UNLOCK
BUTTON PANIC
BUTTON
LED

To open the trunk, push the Trunk
Release button f or approximately
one second.
The trunk will not open if the key is
in the ignition switch.
The ceiling light (if the ceiling light
switch is in the center position) and
the spotlights (if the switch is in the
Door position) will come on when
you press the UNLOCK button. If
you do not open any door, the lights
stay on f or about 30 seconds, then
f ade out. If you relock the doors with
theremotetransmitterbefore30
seconds have elapsed, the lights will
go of f immediately.
You cannot lock the doors with the
remote transmitter if any door is not
f ully closed or the key is in the
ignition switch. If you unlock the doors with the
remote transmitter, but do not open
any of the doors within 30 seconds,
the doors automatically relock and
the security system sets.
Keys and Locks
Inst rument s and Cont rols84

When the remote transmitter’s
battery begins to get weak, it may
take several pushes on the button to
lock or unlock the doors, and the
LED will not light. Replace the
battery as soon as possible.
Panic mode allows you to remotely
activate your car’s horn and exterior
lights to attract attention. The horn
sounds and the exterior lights f lash
f or about 30 seconds. To activate
panic mode, press and hold the
PANIC button f or about two seconds.
To cancel Panic mode bef ore 30
seconds, press any button on the
remote transmitter. You can also
turn the ignition switch to ON (II).
Panic mode will not activate if the
ignition switch is in the ON (II)
position.
To replace the battery, place a cloth
on the edge of the transmitter and
remove the upper half by carefully
prying on the edge with a small f lat-
tip screwdriver.
Battery type: CR2025
CONT INUED
Replacing the Battery
Panic Mode
Keys and Locks
Inst rument s and Cont rols85

Open the glove box by pulling the
handle to the lef t. Close it with a f irm
push. Lock or unlock the glove box
with the master key.
The glove box light comes on when
the parking lights are on. Glove Box
Keys and Locks
Inst rument s and Cont rols89
GLOVE BOX
An open glove box can cause
serious injury to your passenger
inacrash,evenifthe
passenger is wearing the seat
belt.
Always keep the glove box
closed while driving.

Do not use the seat heaters, even
on the LO setting, if the engine is
lef t idling f or an extended period.
Thiscanweakenthebattery,
causing hard starting. Use the HI setting only to heat the
seats quickly. Select the LO
setting when the seats f eel warm.
The HI setting draws large
amounts of current f rom the
battery.
Follow these precautions whenever
you use the seat heaters:
Both f ront seats are equipped with
seat heaters. Because of the sensors
f or the side airbag system, there is
no heater in the passenger’s seat-
back. The ignition switch must be
ON (II) to use the heaters. Push the
f ront of the switch, HI, to rapidly
heat up the seat. After the seat
reaches a comf ortable temperature,
select LO by pushing the back of the
switch. This will keep the seat warm. TheHIorLOindicatorcomeson
and remains lit until you turn it of f by
pushing the opposite side of the
switch lightly.
In HI, the heater turns of f when the
seat gets warm, and turns back on
after the seat’s temperature drops. It
continues to cycle as long as you
leave it set on HI. The HI indicator
remains lit as a reminder that you
have the heater on.
In LO, the heater runs continuously.
It does not cycle with temperature
changes.
Seat Heaters
Inst rument s and Cont rols96

µ
The master control panel also con-
tains these extra features:
To open the driver’s
window f ully, push the window
switch f irmly down, then release it.
The window automatically goes
down all the way. To stop the
window f rom going all the way down,
pull back on the window switch
brief ly.
To open or close the driver’s window
partially, push down or pull back on
the window switch lightly and hold it.
The window will stop when you
release the switch. To close the driver’s window f ully,
pull back the window switch f irmly,
then release it. The window
automatically goes all the way up. To
stop the window f rom going all the
way up, push down on the window
switch brief ly. If the driver’s window runs into any
obstacle while it is closing
automatically, it will reverse
direction, and then stop. To close the
window, remove the obstacle, then
use the window switch again.
Auto reverse stops sensing when the
window is almost closed. You should
always check that all passengers and
objects are away from the window
bef ore closing it.
The MAIN switch controls power to
the passengers’ windows. When you
push in the MAIN switch, the
passengers’ windows cannot be
raised or lowered. To cancel this
f eature, push on the switch again.
The MAIN switch does not af f ect
the driver’s window. Keep the MAIN
switch of f when you have children in
the car so they do not injure
themselves by operating the
windows unintentionally.
AUTO
Auto Reverse
Power Windows
Inst rument s and Cont rols98

Keeptheinsideandoutsidemirrors
clean and adjusted f or best visibility.
Be sure to adjust the mirrors bef ore
you start driving.Adjust the outside mirrors with the
adjustment knob on the driver’s door
armrest:
Turn the adjustment knob to L
(driver’s side) or R (passenger’s
side).
The inside mirror can automatically
darken to reduce glare. To turn on
this feature, press the AUTO button
on the bottom of the mirror. The
indicator comes on as a reminder.
When it is on, the mirror darkens
when it senses the headlights of a
vehicle behind you, then returns to
normal visibility when the lights are
gone. Press the OFF button to turn
of f this f eature.
Turn the ignition switch to ON (II).
1.
2.
Adjusting the Power Mirrors
Mirrors
Inst rument s and Cont rols102
ADJUSTMENT KNOB
OFF BUTTON
AUTO SWITCH INDICATOR

When you f inish, turn the
adjustment knob to the center
(of f ) position. This turns of f the
adjustment knob so you can’t
move a mirror out of position by
accidentally bumping the knob. Push or pull the adjustment knob
in the appropriate direction to
move the mirror right, left, up, or
down.The outside mirrors are heated to re-
move fog and frost. With the ignition
switch in the ON (II) position, turn
on the heaters by pressing the but-
ton. The light in the button comes on
as a reminder. Press the button
again to turn the heaters off.
4. 3.
On Canadian models
Inst rument s and Cont rols
Mirrors
103
HEATED MIRROR BUTTON
ADJUSTMENT KNOB