hood Acura TSX 2006 Owner's Manual

Your Vehicle at a Glance
4
POWER WINDOW
SWITCHESAUDIO SYSTEM
AUTOMATIC
TRANSMISSION
MANUAL
TRANSMISSION
DRIVING POSITION
MEMORY SYSTEM
MASTER DOOR LOCK
SWITCH CLIMATE CONTROL
SYSTEM
MASTER DOOR
LOCK SWITCH
(P.142)
(P.146)
(P.128)
(P.147)
(P.242) (P.244)(P.160)(P.170)
Vehicle without navigation system is shown. (P.135)
FUEL FILL DOOR RELEASE
HANDLE (P.229)
HOOD RELEASE
HANDLE
(P.230)
PARKING BRAKE LEVER(P.151) PASSENGER’S FRONT AIRBAG (P.11,28)
(P.129)
DRIVER’S FRONT AIRBAG (P.11,28) INSTRUMENT PANEL (P.61)
GAUGES (P.68)
TRUNK RELEASE LEVER MIRROR CONTROLS
——yy
(yy

CONT INUED
If a label comes of f or becomes hard
to read (except for the U.S.
dashboard label which may be
removed by the owner), contact your
dealer f or a replacement. These labels are in the locations
shown. They warn you of potential
hazards that could cause serious
injury. Read these labels caref ully.
U.S. modelsCanadian models U.S. models only
Saf ety L abels
Driver and Passenger Saf ety
57
DASHBOARD
HOOD RADIATOR CAP
——y
y
(yy

Control L ocations
60
AUDIO SYSTEM
HOOD RELEASE HANDLE AUTOMATIC
TRANSMISSION
MANUAL
TRANSMISSION
PARKING BRAKE LEVER
POWER WINDOW
SWITCHES INSTRUMENT PANEL
MASTER DOOR
LOCK SWITCH MIRROR CONTROL AUTO BUTTON
DRIVING POSITION
MEMORY SYSTEM
CLIMATE CONTROL
SYSTEM
FUEL FILL DOOR RELEASE
HANDLE
Vehicle without navigation system is shown. (P.142)
(P.128)
(P.147)
(P.229) (P.230) (P.151) (P.242) (P.244)
(P.160) (P.170)
(P.
145 )
(P.61)
GAUGES (P.68)
MIRRORS CONTROLS
(P.146)
TRUNK RELEASE LEVER (P.135)
——y
y
(yy

The security system will not set if
the hood, trunk, or any door is not
f ully closed. Bef ore you leave the
vehicle, make sure the doors, trunk,
and hood are securely closed.
The security system helps to protect
your vehicle and valuables f rom thef t.
The horn sounds and a combination
of headlights, parking lights, side
marker lights and taillights f lash if
someone attempts to break into your
vehicleorremovetheradio.This
alarm continues f or 2 minutes, then
the system resets. To reset an
alarming system before the 2
minutes have elapsed, unlock the
driver’s door with the key or use the
remote transmitter.
The security system automatically
sets 15 seconds (depending on the
‘‘SECURITY RELOCK TIMER’’
setting) after you lock the doors,
hood, and trunk. For the system to
activate, you must lock the doors
from the outside with the key, lock
tab, door lock switch, or remote
transmitter. The security system
indicator in the instrument panel
starts blinking immediately to show
you the system is setting itself . To change the ‘‘SECURITY
RELOCK TIMER’’ setting, see page
.
Once the security system is set,
opening any door (without using the
key or the remote transmitter), the
hood, or the trunk will cause it to
sound. It also sounds if the radio is
removed f rom the dashboard or the
wiring is cut. With the system set, you can still
open the trunk with the remote
transmitter without triggering the
alarm. The alarm will sound if the
trunk lock is f orced, or the trunk is
opened with the trunk release handle
or the emergency trunk opener.
Do not attempt to alter this system
or add other devices to it.
To see if the system is set
af ter you exit the vehicle, press the
LOCK button on the remote
transmitter within 5 seconds. If the
system is set, the horn will beep
once.
114
Security System
Features
203
NOTE:
SECURITY SYSTEM INDICATOR
——y

y
(yy

Bef ore you begin driving your
vehicle, you should know what
gasoline to use and how to check the
levels of important f luids. You also
need to know how to properly store
luggage or packages. The
inf ormation in this section will help
you. If you plan to add any
accessories to your vehicle, please
read the information in this section
first..............................
Break-in Period .228
.................
Fuel Recommendation .228
.........
Service Station Procedures .229
....................................
Ref ueling .229
OpeningandClosingthe .......................................
Hood .230
...................................
Oil Check .232
.............
Engine Coolant Check .232
...............................
Fuel Economy .233
........
Improving Fuel Economy .233
...
Accessories and Modif ications .234
................................
Accessories .234
...........
Modif ying Your Vehicle .235
.............................
Carrying Cargo .236
................................
Load Limits .237
Carrying Cargo in the Trunk .................
or on a Roof Rack .238
Carrying Items in the .....
Passenger Compartment .238
Bef ore Driving
Bef ore Driving
227
——yy
(yy

Stop f illing the tank af ter the f uel
nozzle automatically clicks of f . Do
not try to ‘‘top off’’ the tank. Leave
some room f or the f uel to expand
with temperature changes.
even though the tank is not f ull,
there may be a problem with your
vehicle’s fuel vapor recovery
system. The system helps keep
f uel vapors f rom going into the
atmosphere. Try f illing at another
pump. If this does not f ix the
problem, consult your dealer.To Open the Hood:
Park the vehicle, and set the
parking brake. Pull the hood
release handle located under the
lower lef t corner of the dashboard.
The hood will pop up slightly.
Screw the fuel fill cap back on
until it clicks at least once. If you
do not properly tighten the cap,
the malf unction indicator lamp
maycomeon(seepage ).You
will also see a ‘‘TIGHTEN FUEL
CAP’’ message in the inf ormation
display.
Push the f uel f ill door closed until
it latches.
1.
6.
4.
5.
324
If the f uel nozzle keeps clicking of f
Service Station Procedure
Opening and Closing the Hood
230
HOOD RELEASE HANDLE
——yy
(yy

Lif t it up slightly to remove the
support rod f rom the hole. Put the
support rod back into its holding clip.
Lower the hood to about a f oot
(30cm)abovethefender,thenletit
drop. Make sure it is securely
latched. To Close the Hood:
Put your f ingers under the f ront
edge of the hood near the center.
Slide your hand to the lef t until
you f eel the hood latch handle.
Push this handle up to release it.
Lif t up the hood.
If the hood latch handle moves stif f ly,
or if you can open the hood without
lif ting the handle, the mechanism
should be cleaned and lubricated. Pull the support rod out of its clip
by holding the grip, and insert the
end into the designated hole in the
hood.
3.
2.
Service Station Procedure
Bef ore Driving
231
LATCH
SUPPORT ROD
GRIP
CLIP
——yy
(yy

Youshoulddothefollowingchecks
and adjustments bef ore you drive
your vehicle.Make sure all windows, mirrors,
and outside lights are clean and
unobstructed. Remove f rost, snow,
or ice.
Make sure the doors are securely
closed and locked.
Fasten your seat belt. Check that
your passengers have f astened
their seat belts (see page ). Check the steering wheel
adjustment (see page ).
Check that the hood is f ully closed.
Check that the trunk is f ully
closed.
Visually check the tires. If a tire
looks low, use a gauge to check its
pressure.
Check that any items you may be
carrying are stored properly or
f astened down securely. Check the adjustment of the
inside and outside mirrors (see
pages and ).
When you start the engine, check
the gauges and indicators in the
instrument panel and the
messages in the multi-inf ormation
display (see pages and ).
Check the seat adjustment (see
pages and ).
3. 2. 1.
4.
5. 6.
7.
8.
9.
11.
10. 17
145 146
124 61 76
139
138
Preparing to Drive
240
——yy
(yy

Remove the oil f ilter and let the
remaining oil drain. A special
wrench (available from your
dealer) is required. Remove the oil drain bolt and
washer from the bottom of the
engine. Drain the oil into an
appropriate container.
Always change the oil and f ilter
according to the maintenance
messages shown on the multi-
inf ormation display. The oil and f ilter
collect contaminants that can
damage your engine if they are not
removed regularly.
Changing the oil and f ilter requires
special tools and access f rom
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lif t f or this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
mechanic.
Run the engine until it reaches
normal operating temperature,
then shut it off.
Open the hood and remove the
engine oil f ill cap.
Remove the bolt located on the
underside of the body with a
wrench, then remove the
maintenance cover.
2. 1.
3. 4.
5.
Changing the Oil and Filter
280
WASHER
OIL DRAIN BOLT
BOLT MAINTENANCE COVER
——yy
(yy

Open the hood. To change a bulb
on the driver’s side, undo the
three fasteners and remove the air
intake cover.Remove the electrical connector
f rom the bulb by pulling the
connector straight back.
Remove the rubber weather seal
by pulling on the tab.Unclip the end of the hold-down
wire f rom its slot. Pivot it out of
the way, and remove the bulb
socket.
Pull the burned out bulb straight
out of its socket.
Push the new bulb straight into
the socket until it bottoms.
Insert the socket back into the
headlight assembly. Make sure
the bulb is installed correctly by
looking through the headlight lens.
Pivot the hold-down wire back in
place, and clip the end into the slot.
Install the rubber weather seal
over the back of the headlight
assembly.Makesureitisright
side up; it is marked with an arrow.
1.
2.
3.6. 4.
5.
7.
Lights
292
FASTENER
AIR INTAKE COVER
HOLD-DOWN WIREBULB
CONNECTOR
RUBBER WEATHER SEAL
SOCKET
——yy
(yy