key Acura TSX 2011 User Guide

Locking and Unlocking the Doors
Locking/Unlocking the Doors from the Outside
92Controls
Fully insert the key and turn it.
If you are using the master key, make sure it
is fully extended.
Locking/Unlocking the Doors Using a Key
Locking the driver's door
Pull the lock tab rearward
or push the
master door lock switch in the lock direction
, and close the door. Locking the passenger's doors
Pull the lock tab rearward and close the door.
Locking a Door Without Using a Key
Locking/Unlocking the Doors Using a Key
When you lock the driver's door with a key, all of
the other doors, trunk, and fuel fill door lock at the
same time. When unlocking, the driver's door and
fuel fill door unlock first. Turn the key a second time
within a few seconds to unlock the remaining doors
and the trunk. Locking a Door Without Using a Key
When you lock the driver's door, all the other doors,
trunk, and fuel fill door lock at the same time.
Make sure you have the key in your hand before
locking the door to prevent it from being locked in
the vehicle.
Lockout prevention system
The doors cannot be locked when the key is in the ignition switch, and any door is
open.
Unlock
Lock

Opening and Closing the Trunk
Trunk Main Switch
97Controls
Trunk Main Switch
Trunk Main Switch
If you need to give the key to someone else, give
them the valet key.
The trunk release button on the remote transmitter
is always enabled, even when the trunk main switch
is off.
The trunk main switch disables the trunk
opener on the driver's side and the trunk
release button on the trunk lid to protect
luggage in the trunk.
1. Make sure the rear seat-backs are not
folded down.
2. Turn off the trunk main switch in the glove
box.
3. Lock the glove box.
Emergency Trunk Opener
The trunk release lever allows you to open
the trunk from inside for your safety.
Slide the release lever in the direction of the
arrow.
Emergency Trunk Opener
Parents should decide if their children should be
shown how to use this feature.
ONOFF
Main Switch
Lever

Security System
98Controls
Immobilizer SystemThe immobilizer system prevents a key that has not been pre-registered from
starting the engine. Each key contains electronic transmitters that use electronic
signals to verify the key.
Pay attention to the following when inserting the key into the ignition switch.
Do not allow objects that emit strong radio waves near the ignition switch. t
Make sure the key is not covered by or touching a metal object. t
Do not bring a key from another vehicle's immobilizer system near the ignition t
switch.
Immobilizer System NOTICE Leaving the ignition key in the vehicle can result in
theft or accidental movement of the vehicle.
Always take the ignition key with you whenever you
leave the vehicle unattended.
Do not alter the system or add other devices to it.
Doing so may damage the system and make your
vehicle inoperable. Security System Alarm
The security alarm continues for a maximum of two
minutes until the security system deactivates.
Security System AlarmThe security system alarm activates when the doors, trunk, or hood are opened
without the key, or remote transmitter. It also activates if you turn the ignition
switch to ON
II
after locking the doors with the remote transmitter.
When the security system alarm activates
The horn sounds intermittently, and all of the exterior lights flash. To deactivate the security system alarm
Unlock the vehicle using the key, or remote transmitter. The system, along with
the horn and flashing lights, are deactivated.

Security System
Security System Alarm
99Controls
Setting the security system alarm
The security system alarm automatically sets when the following conditions have
been met:
The ignition switch is in LOCK t
0
, and the key has been removed from the
ignition switch.
The hood is closed. t
All doors are locked. t
When the security system alarm sets
The security system indicator in the instrument panel blinks. When the blinking
interval changes after about 15 seconds, the security system is set. To cancel the security system alarm
The security system is canceled when the vehicle is unlocked using the key or
remote transmitter. The security system indicator goes off at the same time.
Security System Alarm
Do not set the security system alarm when someone
is in the vehicle or a window is open. The system
can accidentally activate when:
Unlocking the door with the lock tab or the tmaster door lock switch.
Opening the trunk with the release button on the tdriver's door or the emergency trunk opener.

If the battery goes dead after you have set the
security system alarm, the security alarm may go off
once the battery is recharged or replaced.
If this occurs, deactivate the security system alarm
by unlocking a door using the key or remote
transmitter.
Do not attempt to alter this system or add another
device to it.
The panic button on the remote
transmitter
If you press the panic button for
approximately one second, the following will
occur:
The horn sounds. t
Some exterior lights flash for about 30 t
seconds.
Panic Mode Canceling panic mode
Press any button on the remote transmitter, or turn the ignition switch to ON
II
.
Panic
Button

Opening and Closing the Windows
Opening/Closing the Power Windows
101
Continued
Controls
Opening/Closing Windows without Auto-Open/Close Function Opening Windows and Moonroof with the Remote
Tra n s m i t t e r
To o p e n : Press the UNLOCK button twice
within 10 seconds and hold it down for the
second time. If the windows stop midway,
repeat the procedure.
Opening Windows and Moonroof with the Remote Transmitter
You cannot operate the power windows with the
remote transmitter when the key is in the ignition
switch.
To open: Push the switch down.
To close: Pull the switch up.
Release the switch when the window reaches
the desired position.
Unlock
Button
Close
Open

Opening and Closing the Windows
Opening/Closing the Power Windows
102Controls
Opening/Closing the Windows/Moonroof with the Key
To open: Unlock the driver's door with the
key. Within 10 seconds of returning the key
to the central position, turn the key in the
unlock direction and hold it there.
To close: Lock the driver's door with the key.
Within 10 seconds of returning the key to
the central position, turn the key in the lock
direction and hold it there.
Release the key to stop the windows/
moonroof at the desired position. If you
want further adjustment, repeat the same
operation.
Opening/Closing the Windows/Moonroof with the Key
You cannot close the power windows with the key
when the door is open.
Close
Open

Operating the Switches Around the Steering Wheel
104Controls
0 LOCK: Insert and remove the key in this
position.
I ACCESSORY: Operate the audio system and
other accessories in this position.
II ON: This is the position when driving.

III
START: This position is for starting the engine.
The switch returns to ON
II when you let go of
the key.
Ignition Switch
Ignition Switch Manual transmission models
Automatic transmission models You cannot take the key out unless the shift lever is
in
P.
All models If you open the driver's door when the key is in
LOCK
0 or ACCESSORY
I , a warning buzzer will
sound to remind you to take the key out.
When this happens, the following messages appear
on the multi-information display:
In LOCK
t
0 : "REMOVE KEY."
In ACCESSORY
t
I : "REMOVE KEY" The buzzer
will stop when you take the key out.
If the key won't turn from LOCK
0 to ACCESSORY
I, turn the key while moving the steering wheel
left and right. The steering wheel will unlock,
allowing the key to turn.
WARNING
Removing the key from the ignition switch
locks the steering. If you do this while the
vehicle is in motion, you can lose control
of the vehicle.
Only remove the key from the ignition
switch when parked.

105
Continued
Controls
Operating the Switches Around the Steering Wheel
Turn Signals
Light Switches
Turn Signals
The turn signals can be used when the
ignition switch is in ON
II
.
Rotating the light switch turns the lights on
and off, regardless of the position of the
ignition switch.
High beams
Push the lever forward until you hear a click. Low beams
When in high beams, pull the lever back to
return to low beams. Flashing the high beams
Pull the lever back, and release it.
Manual Operation
Light Switches
If you remove the key from the ignition switch while
the light is on, a chime sounds when the driver’s
door is opened.
When the lights are on, the lights on indicator in
the instrument panel will be on.
Indicators


P. 6 4
Repeatedly turning the headlights on and off
reduces the life of the HID headlight bulbs.
If you sense that the level of the headlights is
abnormal, have the vehicle inspected by a dealer.
Do not leave the lights on when the engine is off
because it will cause the battery to discharge.
Light Switches
Right Turn
Left Turn
High Beams
Low BeamsFlashing the
high beams
Turns on side marker, tail and
license plate lights Turns on headlights, parking,
side marker, tail, and license
plate lights

Operating the Switches Around the Steering Wheel
Light Switches
106Controls
Automatic Operation (automatic lighting control)
Automatic lighting control can be used when
the ignition switch is in ON
II
.
When you turn the light switch to
AUTO
,
the headlights and other exterior lights will
switch on and off automatically depending
on the ambient brightness.
Automatic Operation (automatic lighting control)
We recommend that you turn on the lights manually
when driving at night, in a dense fog, or in dark
areas such as long tunnels or parking facilities.
The light sensor is in the location shown below.
Do not cover this light sensor with anything;
otherwise, the automatic lighting system may not
work properly.Light SensorYou can change the AUTO light sensitivity and
automatic lighting off timer setting using the multi-
information display.
Customization Procedure


P. 8 0
Automatic lighting off feature
The headlights, all other exterior lights, and the instrument panel lights turn off
within 15 seconds after you remove the key and close the driver's door.
If you turn the ignition switch to LOCK
0 with the headlight switch on, but do
not open the door, the lights turn off after 10 minutes (3 minutes, if the switch is
in the
AUTO
position).
The lights turn on again when you unlock or open the driver's door. If you unlock
the door, but do not open it within 15 seconds, the lights go off. If you open the
driver's door, you will hear a lights on reminder chime.

125
Interior Lights/Interior Convenience Items
Controls
Interior Lights
ON
The interior lights come on regardless of
whether the doors are open or closed. Door activated
The interior lights come on in the following
situations:
When any of the doors are opened. t
You unlock the driver's door. t
You remove the key from the ignition t
switch. OFF
The interior lights remain off regardless of
whether the doors are open or closed.
Interior Light Switches
In the door activated position, the interior lights
fade out and go off about 30 seconds after the
doors are closed.
The lights go off after 30 seconds in the following
situations:
When you unlock the driver's door but do not topen it.
When you remove the key from the ignition tswitch but do not open a door.
You can change the interior lights dimming time.
Customized Features


P. 8 0
The interior lights go off immediately in the
following situations:
When you lock the driver's door.
tWhen you close the driver's door with the key in tthe ignition switch.
When you turn the ignition switch to ON t
II.
If you leave any of the doors open without the key
in the ignition switch, the interior lights go off after
about 15 minutes.
Interior Light Switches Map Lights
The map lights can be turned on and off by
pressing the lenses.
Map Lights
When the ceiling light switch is in the door activated
position and any door is open, the map light will
not go off when you press the lens.
FrontRear
On
On
Door Activated PositionDoor Activated Position
Off
Off