warning Acura TSX 2011 Owner's Guide

Gauges and Multi-Information Display
Multi-Information Display
76Instrument Panel
Multi-Information DisplayThe multi-information display shows the odometer, trip meter, outside temperature
indicator, and other gauges.
It also displays important messages such as warnings and other helpful information.
Switching the Display
Press the
(information) button or the SEL /RESET button to change the
display.
* Not available on all models

Button
SEL/RESET Button
OdometerEngine Oil Life
Outside Temperature Trip B Trip A
: Press the
button. Trip Computer
: Press the SEL/RESET button.
Shown when Bluetooth
®
HandsFreeLink
® is activated.Tire Pressure
for each tireHFL
*

Opening and Closing the Windows
100Controls
Opening/Closing the Power WindowsThe power windows can be opened and closed when the ignition switch is in ON II
, using the switches on the doors. The driver's side switch can be used to open
and close all of the windows.
The main switch on the driver's side must be switched off (not pushed in, indicator
off) to open and close the windows from anywhere other than the driver's seat.
When the main switch is turned on (pushed in, indicator on), you can only operate
the windows from the driver's seat. Turn the main switch on when children are in
the vehicle.
Opening/Closing the Power Windows
WARNING
Closing a power window on someone's
hands or fingers can cause serious injury.
Make sure your passengers are away from
the windows before closing them.
Opening/Closing Windows with Auto-Open/Close Function
The power windows can be operated for up to 10
minutes after you turn the ignition switch off.
Opening either front door cancels this function.
Auto Reverse
If a power window senses resistance when closing
automatically, it will stop closing and reverse
direction.
The driver’s window auto reverse function is
disabled when you continuously pull up the switch.
The auto reverse function stops sensing when
the window is almost closed to ensure that it fully
closes.
Automatic operation
To o p e n : Push the switch down firmly
To close: Pull the switch up firmly.
The window opens or closes completely. To
stop the window at any time, push or pull the
switch briefly. Manual operation
To open: Push the switch down lightly.
To close: Pull the switch up lightly.
Release the switch when the window reaches
the desired position.
ONOFF
Main Switch
Driver’s Window Switch
Indicator
Front Passenger’sWindow Switch

103
Opening and Closing the Moonroof
Controls
Opening/Closing the Moonroof
You can only operate the moonroof when the ignition switch is in ON
II
. Use the
switch in the front of the ceiling to open and close the moonroof.
Automatic operation
To open: Pull the switch back firmly, then
release.
To close: Push the switch forward firmly,
then release.
The moonroof will automatically open or
close all the way. To stop the moonroof
midway, touch the switch briefly. Manual operation
To open: Pull the switch back, and hold it
until the desired position is reached.
To close: Push the switch forward, and hold
it until the desired position is reached. Tilting the moonroof up
To tilt: Push on the center of the moonroof
switch.
To close: Push the switch forward firmly,
then release.
WARNING
Opening or closing the moonroof on
someone's hands or fingers can cause
serious injury.
Make sure all hands and fingers are clear
of the moonroof before opening or
closing it. Opening/Closing the Moonroof NOTICE Opening the moonroof in below freezing
temperature or when it is covered with snow or ice
can damage the moonroof panel or motor.
The power moonroof can be operated for up to 10
minutes after you turn the ignition switch off.
Opening either front door cancels this function.
When resistance is detected, the auto reverse
function causes the moonroof to change directions,
then stop. Auto reverse stops sensing when the
moonroof is almost closed to ensure that it fully
closes. Make sure that all objects, including fingers,
are clear of the moonroof.

Operating the Switches Around the Steering Wheel
104Controls
0 LOCK: Insert and remove the key in this
position.
I ACCESSORY: Operate the audio system and
other accessories in this position.
II ON: This is the position when driving.

III
START: This position is for starting the engine.
The switch returns to ON
II when you let go of
the key.
Ignition Switch
Ignition Switch Manual transmission models
Automatic transmission models You cannot take the key out unless the shift lever is
in
P.
All models If you open the driver's door when the key is in
LOCK
0 or ACCESSORY
I , a warning buzzer will
sound to remind you to take the key out.
When this happens, the following messages appear
on the multi-information display:
In LOCK
t
0 : "REMOVE KEY."
In ACCESSORY
t
I : "REMOVE KEY" The buzzer
will stop when you take the key out.
If the key won't turn from LOCK
0 to ACCESSORY
I, turn the key while moving the steering wheel
left and right. The steering wheel will unlock,
allowing the key to turn.
WARNING
Removing the key from the ignition switch
locks the steering. If you do this while the
vehicle is in motion, you can lose control
of the vehicle.
Only remove the key from the ignition
switch when parked.

Operating the Switches Around the Steering Wheel
Adjusting the Steering Wheel
113
Controls
Adjusting the Steering WheelThe steering wheel height and distance from your body can be adjusted so that
you can comfortably grip the steering wheel in an appropriate driving posture.
1. Pull the steering wheel adjustment lever
up.
The steering wheel adjustment lever is
under the steering column.
2. Move the steering wheel up or down, and
in or out. Make sure you can see the instrument
panel gauges and indicators.
3. Push the steering wheel adjustment
lever down to lock the steering wheel in
position. After adjusting the position, make sure
you have securely locked the steering
wheel in place by trying to move it up,
down, in, and out.
Adjusting the Steering Wheel
Make any steering wheel adjustments before you
start driving.
WARNING
Adjusting the steering wheel position
while driving may cause you to lose
control of the vehicle and be seriously
injured in a crash.
Adjust the steering wheel only when the
vehicle is stopped.
To lock
Lever To a d j u s t

Adjusting the Seats
116Controls
Adjusting the Seat Positions

 
 




Adjust the driver's seat as far back as possible
while allowing you to maintain full control of
the vehicle. You should be able to sit upright,
well back in the seat and be able to
adequately press the pedals without leaning
forward, and grip the steering wheel
comfortably. The passenger's seat should be
adjusted in a similar manner, so that it is as
far back from the front airbag in the
dashboard as possible.
Adjusting the Seats
The National Highway Traffice Safety Administration
and Transport Canada recommend that drivers
allow at least 10 inches (25 cm) between the center
of the steering wheel and the chest.
Always make seat adjustments before driving.
WARNING
Sitting too close to a front airbag can
result in serious injury or death if the
front airbags inflate.
Always sit as far back from the front
airbags as possible while maintaining
control of the vehicle.
Horizontal Position
Adjustment
Height Adjustment
(Driver's seat only)
Driver's seat is shownSeat-back Angle
Adjustment

Adjusting the Seats
Adjusting the Seat Positions
117
Continued
Controls
Adjusting the Seat-Backs
Adjusting the Seat-Backs
Adjust the driver's seat-back to a
comfortable, upright position, leaving ample
space between your chest and the airbag
cover in the center of the steering wheel.
The front seat passenger should also adjust
their seat-back to a comfortable, upright
position.
Reclining a seat-back so that the shoulder part of the belt no longer rests against
the occupant's chest reduces the protective capability of the belt. It also increases
the chance of sliding under the belt in a crash and being seriously injured. The
farther a seat-back is reclined, the greater the risk of injury.
WARNING
Reclining the seat-back too far can result
in serious injury or death in a crash.
Adjust the seat-back to an upright
position, and sit well back in the seat. Do not put a cushion, or other object, between the
seat-back and your back.
Doing so may interfere with proper seat belt or
airbag operation.
If you cannot get far enough away from the steering
wheel and still reach the controls, we recommend
that you investigate whether some type of adaptive
equipment may help.

Adjusting the Seats
Adjusting the Seat Positions
118Controls
Adjusting the Head Restraints Adjusting the front and rear outer head restraint positionsYour vehicle is equipped with head restraints.
Head restraints are most effective for
protection against whiplash and other rear-
impact crash injuries when the center of the
back of the occupant's head rests against
the center of the restraint. The tops of the
occupant's ears should be level with the
center height of the restraint.Position head in the center
of the head restraint.
Adjusting the Head Restraints
The driver's and front passenger's seats have active
head restraints.
Active Head Restraints


P.12 2
WARNING
Improperly positioning head restraints
reduces their effectiveness and increases
the likelihood of serious injury in a crash.
Make sure head restraints are in place and
positioned properly before driving.
To raise the head restraint: Pull it upward.
To lower the head restraint: Push it down
while pressing the release button.

Adjusting the Seats
Adjusting the Seat Positions
119
Continued
Controls
A passenger sitting in the center back seating
position should adjust the height of their
head restraint to an appropriate position
before the vehicle begins moving.
To raise the head restraint:
Pull it upward.
To lower the head restraint:
Push it down while pressing the release
button.
Removing and Reinstalling the Head Restraints
Head restraints can be removed for cleaning or repair.
To remove a head restraint:
Pull the restraint up as far as it will go. Then push the release button, and pull the
restraint up and out.
To reinstall a head restraint:
Insert the legs back in place, then adjust the head restraint to an appropriate
height while pressing the release button. Pull up on the restraint to make sure it is
locked in position.
Removing and Reinstalling the Head Restraints
WARNING
Failure to reinstall the head restraints can
result in severe injury during a crash.
Always replace the head restraints before
driving.
Changing the Center Rear Seat Head Restraint Position

Adjusting the Seats
Adjusting the Seat Positions
121
Continued
Controls
Maintain a Proper Sitting Position
After all occupants have adjusted their seats and head restraints, and put on their
seat belts, it is very important that they continue to sit upright, well back in their
seats, with their feet on the floor, until the vehicle is safely parked and the engine
is off.
Sitting improperly can increase the chance of injury during a crash. For example,
if an occupant slouches, lies down, turns sideways, sits forward, leans forward or
sideways, or puts one or both feet up, the chance of injury during a crash is greatly
increased.
In addition, an occupant who is out of position in the front seat can be seriously or
fatally injured in a crash by striking interior parts of the vehicle or being struck by
an inflating front airbag.
WARNING
Sitting improperly or out of position can
result in serious injury or death in a crash.
Always sit upright, well back in the seat,
with your feet on the floor. Maintain a Proper Sitting Position