low oil pressure Alfa Romeo 4C 2015 Owner handbook (in English)
[x] Cancel search | Manufacturer: ALFA ROMEO, Model Year: 2015, Model line: 4C, Model: Alfa Romeo 4C 2015Pages: 199, PDF Size: 7.67 MB
Page 65 of 199
KNOWING THE INSTRUMENT PANEL
This section of the booklet gives you all
the information you need to
understand, interpret and use the
instrument panel correctly.CONTROL PANEL AND
INSTRUMENTS ............................... 62
SETUP MENU ................................. 64
MENU OPTIONS ............................. 66
TRIP COMPUTER ........................... 70
WARNING LIGHTS AND
MESSAGES .................................... 73
- LOW BRAKE FLUID / HANDBRAKE
ENGAGED .......................................... 73
- EBD FAILURE .................................. 74
- AIRBAG FAILURE ............................. 74
- SEAT BELTS NOT FASTENED .......... 74
- ABS FAILURE ................................... 75
- PASSENGER AIRBAG
DEACTIVATED .................................... 76
- INJECTION/EOBD SYSTEM
FAILURE ............................................. 77
- TPMS ............................................... 78
- ELECTRONIC STABILITY CONTROL
(ESC) SYSTEM ................................... 79
- ASR FUNCTION DEACTIVATED
WARNING LIGHT ............................... 79
- SIDE LIGHTS AND DIPPED
HEADLIGHTS ..................................... 80
- FOLLOW ME HOME ........................ 80
- LEFT DIRECTION INDICATOR .......... 81
- RIGHT DIRECTION INDICATOR ....... 81
- MAIN BEAM HEADLIGHTS .............. 81
- LOW ENGINE OIL PRESSURE ......... 82
-ENGINE OIL DETERIORATED ........... 82
- ENGINE COOLANT TEMPERATURE
TOO HIGH .......................................... 83
- ALTERNATOR FAILURE ................... 83
- GEARBOX FAILURE ......................... 84
-INCOMPLETE DOOR LOCKING ........ 84
-WORN BRAKE PADS ........................ 84
- ALFA ROMEO CODE SYSTEM
FAILURE ............................................. 84- FUEL RESERVE/LIMITED RANGE .... 85
- FUEL RESERVE/LIMITED RANGE
SENSOR FAULT ................................. 85
- CRUISE CONTROL .......................... 85
- DOOR MIRROR
DEMISTING/DEFROSTING ................. 85
- EXTERIOR LIGHTS FAULT ............... 86
- SERVICE
................ 86
- GENERAL FAILURE ......................... 87
- FUEL CUT-OFF ................................ 87
- LUGGAGE COMPARTMENT OPEN . 88
- POSSIBLE ICE ON ROAD ................ 88
- BRAKE LIGHTS FAILURE ................. 88
- PARKING SENSOR FAILURE ........... 88
- DISPLAY OF SELECTED DRIVING
MODE (“Alfa DNA” system) ................. 88
61
(SCHEDULED SERVICING)
Page 86 of 199
WARNING LIGHTS ON DISPLAY
Warning lights on
displayWhat it means What to do
redLOW ENGINE OIL PRESSURE
When the key is turned to MAR-ON, the digital warning light switches on,
but it should switch off as soon as the engine is started.
The digital warning light switches on constantly together with the
message in the display when the system detects that the engine oil
pressure is insufficient.
6)
ENGINE OIL DETERIORATED
(for versions/markets, where provided)
The digital warning light will flash and a specific message will appear on
the display (for versions/markets, where provided).
The digital warning light may flash in the following ways, depending on
the versions:
- for 1 minute every two hours;
- for 3 minute cycles with the warning light off for intervals of 5 seconds
until oil is changed.
After the initial warning, each time the engine is started up, the digital
warning light will continue to flash in the same mode, until the oil is
changed. A specific message will appear on the display (for versions/
markets, where provided) in addition to the warning light. If the digital
warning light flashes, this does not mean that the car is defective, but
simply informs the driver that it is now necessary to change the oil as a
result of regular vehicle use. Remember that the deterioration of engine
oil is accelerated by using the car for short drives, preventing the engine
from reaching operating temperature.Contact the dedicated
Alfa Romeo Dealership as
soon as possible.
62)
82
KNOWING THE INSTRUMENT PANEL
Page 91 of 199
Warning lights on
displayWhat it means What to do
GENERAL FAILURE
(for versions/markets, where provided)
The symbol lights up in the display in the
circumstances indicated below.
Engine oil pressure sensor failure
The symbol lights up when the engine oil pressure
sensor is faulty. The display shows the dedicated
message.In these case contact the dedicated Alfa Romeo
Dealership to have the fault fixed as soon as
possible.
"Clutch overheating" message
The
symbol, along with a message on the
display, lights up to indicate clutch overheating.
If the driver continues, the
symbol will switch
off and the
warning light will light up (on some
versions together with a message on the display)
to indicate a transmission failure.If the
symbol lights up along with a message
on the display, reduce gear shifting and/or
change usage conditions, until the normal
operating conditions are restored.
If the
warning light lights up (a message will
appear on the display, on some versions) stop
immediately, operate the handbrake, stop the
engine and wait 5 minutes: after this, normal
transmission operating conditions will be
restored.
Should the transmission failure condition persist,
contact the dedicated Alfa Romeo Dealership
FUEL CUT-OFF
The symbol and the corresponding message are
shown on the display in the following cases:
❒fuel cut-off system intervention: the yellow
symbol lights up;
❒fuel cut-off system failure: the red symbol lights
up.For the fuel cut-off system reactivation procedure,
refer to the "Fuel Cut-Off System" section of the
"Controls" paragraph, in the "Knowing your car"
chapter. If it is still not possible to restore the fuel
supply, contact the dedicated Alfa Romeo
Dealership.
87
Page 148 of 199
PERIODIC CHECKS
Every 1,000 km or before long
journeys, check and, if necessary, top
up the following:
❒engine coolant level;
❒brake fluid;
❒screen washer fluid;
❒tyre inflation pressure and condition;
❒operation of lighting system
(headlamps, direction indicators,
hazard warning lights, etc.);
❒operation of screen washing/wiping
system and positioning/wear of
wiper blade.
Every 3,000 km, check and top up if
required: engine oil level.
HEAVY-DUTY USE OF
THE CAR
If the car is used mainly under one of
the following conditions:
❒if the car is used under demanding
conditions, e.g. on track;
❒dusty roads;
❒short, repeated journeys (less than
7–8 km) at sub-zero outside
temperatures;
❒engine often idling or driving long
distances at low speeds or long
periods of inactivity;
the following checks must be carried
out more often than indicated in the
Scheduled Servicing Plan:
❒check of front and rear disc brake
pad condition and wear;
❒check cleanliness of tailgate locks,
cleanliness and lubrication of linkage;
❒visually inspect conditions of: engine,
gearbox, transmission, pipes and
hoses (exhaust - fuel system -
brakes) and rubber elements (boots -
sleeves - bushes - etc.);
❒check battery charge and battery
fluid level (electrolyte);
❒visually inspect condition of the
accessory drive belts;❒check and, if necessary, change
engine oil and replace oil filter;
❒check and, if necessary, replace air
cleaner.
Using the car on track should be
regarded as an exception. The car has
been designed and produced for road
use.
144
SERVICING AND MAINTENANCE
Page 162 of 199
❒tighten the screws with folding ring A
fig. 132 in the housings on the floor;
❒unite the Velcro fabric strips of the
mats with those on the floor, taking
care to apply light pressure and
ensure that the fastening is efficient.
139)
SEATS AND FABRIC OR
MICROFIBRE PARTS
Remove dust with a soft brush or a
vacuum cleaner. For better cleaning of
microfibre trim (including the steering
wheel, for versions/markets, where
provided) we advise you to moisten the
brush. Rub the seats with a sponge
moistened with a solution of water and
neutral detergent.LEATHER SEATS
(for versions/markets, where provided)
Remove the dry dirt with a chamois
or slightly damp cloth, without exerting
too much pressure. Remove any liquid
or grease stains using an absorbent
dry cloth, without rubbing. Then clean
with a soft cloth or chamois moistened
with water and mild soap. If the stain
persists, use specific products and
observe the instructions carefully.
IMPORTANT Never use alcohol. Make
sure that the cleaning products used
contain no alcohol or alcohol
derivatives, even in small quantities.PLASTIC, CARBON AND
COATED PARTS
Clean interior plastic and visible carbon
parts with a damp cloth (if possible
made from microfibre), and a solution of
water and neutral, non-abrasive
detergent. To clean oily or persistent
stains, use specific products free from
solvents and designed to maintain
the original appearance and colour of
the components.
Remove any dust using a microfibre
cloth, if necessary moistened with
water. The use of paper tissues is not
recommended as these may leave
residues.
IMPORTANT Do not use alcohol,
petrols or derivatives to clean
the instrument panel display.
158
SERVICING AND MAINTENANCE
To reposition, proceed as follows: