maintenance Alfa Romeo 4C 2016 Owner handbook (in English)

unknown origin;
if a tyre is changed, also change the
inflation valve.
WARNING
131)The road holding qualities of the car
also depend on the correct inflation
pressure of the tyres.
132)If tyre pressure is too low, the tyre
may overheat and be severely damaged as
a result.
133)Do not switch tyres from the left to
the right side and vice versa, in order to
prevent inversion of the rotation direction.
134)Do not repaint alloy wheel rims at
temperatures higher than 150°C. The
mechanical characteristics of the wheels
might be compromised.
135)The car is always equipped with front
and rear wheels of different dimensions. It
is not therefore possible to move the
wheels from the front to the back and vice
versa.
It is advisable to replace the blade
about once a year.
136)
A few simple precautions can reduce
the possibility of damage to the blade:
if the temperature falls below zero,
make sure that ice has not frozen the
rubber to the glass. Use an antifreeze
product to release it if required;
remove any snow from the glass;
do not operate the windscreen wiper
on dry glass.
IMPORTANT Do not lift the arm of the
windscreen wiper when it is in its initial
rest position. Refer to the following
instructions to lift the windscreen wiper
blade correctly.
Lifting blade
If it is necessary to lift the blade from
the windscreen (e.g. in the event of
snow or if the blade needs
replacement) proceed as follows:
turn ring nut A fig. 132 to(wiper
off);
turn the ignition key to MAR-ON and
then to STOP;
after turning the ignition key to
STOP, within 2 minutes move the right
stalk upwards, into unstable
("anti-panic") position, for at least half a
second. The windscreen wiper then
executes part of a stroke; at each
command, approximately 1/3 of a
normal wiper stroke is triggered.
the previous operation can be
repeated up to 3 times, in order to
move the blade to the most suitable
position;
lift the blade from the windscreen
and proceed with the required
operation;
lower the blade, bringing it into
contact with the windscreen;
bring the blade to the initial rest
position, turning the ignition key to
MAR-ON.
29)
132A0L0021
140
SERVICING AND MAINTENANCE

Replacing the
windscreen wiper blade
Proceed as follows:lift the windscreen wiper blade,
following the instructions given
preciously;
press tab A fig. 133 of the
attachment spring and remove the
blade from the arm;
fit the new blade, inserting the tab in
the dedicated housing in the arm and
checking that it is locked;
lower the wiper arm onto the
windscreen.
NOZZLES
Screen washer
The windscreen washer nozzles are
adjustable fig. 134. They are originally
adjusted at the factory. Should it be
necessary to adjust them again,
contact a dedicated Alfa RomeoDealership.
If there is no jet of fluid, firstly check that
there is some fluid in the reservoir (see
paragraph "Checking fluid levels" in this
chapter).
Then check that the nozzle holes are
not clogged; use a needle to unblock
them if necessary.
WARNING
136)Driving with a worn wiper blade is a
serious hazard, because visibility is
reduced in bad weather.
IMPORTANT
29)Do not operate the screen wiper with
the blades lifted from the windscreen.
BODYWORK
PROTECTION AGAINST
ATMOSPHERIC AGENTS
The car features advanced
technological solutions for effective
protection of the exterior bodywork and
structure.
The best products and best painting
systems lend the exterior bodywork
particularly high resistance to
atmospheric agents (solar radiation,
acid rain, etc.) and gravel, through
specific protections.
The chassis too, in light,
corrosion-resistant alloy, is treated to
prevent the formation of surface
oxidation.
CAR CORROSION
WARRANTY
Your car is covered by warranty against
perforation, due to rust, of any original
element of the structure. For the
general terms of this warranty, refer to
the Warranty Booklet.
PRESERVING THE
BODYWORK
Paintwork5)30)
Touch up abrasions and scratches
immediately.
Maintenance of paintwork consists of
washing the car: the frequency
depends on the conditions and
environment where the car is used. For
example, in highly polluted areas, or if
133A0L0086
134A0L0087
141
31)

the roads are spread with salt, it is
advisable to wash the car more
frequently.
To correctly wash the car, proceed as
follows:
wash the bodywork using a low
pressure jet of water. Remember that
the build up of water can damage the
car over a period of time;
wipe a sponge with a slightly soapy
solution over the bodywork, frequently
rinsing the sponge;
rinse well with water and dry with a
jet of air or a chamois leather.
Dry the less visible parts (e.g. door
frames, engine cover, headlight frames,
etc.) with special care, as water may
stagnate more easily in these areas.
The car should not be taken to a closed
area immediately, but left outside so
that residual water can evaporate.
Do not wash the car after it has been
left in the sun or with the tailgate hot:
this may alter the shine of the
paintwork.
Exterior plastic parts must be cleaned
in the same way as the rest of the car.
Avoid parking under trees as much as
possible; the resin from trees dulls the
paintwork.
IMPORTANT Bird droppings must be
washed off immediately and thoroughly
as the acid they contain is particularly
aggressive.Windows
Use specific detergents and clean
cloths to prevent scratching or altering
the transparency.
Front headlights
Use a soft cloth soaked in water and
detergent for washing cars.
IMPORTANT Never use aromatic
substances (e.g. petrol) or ketenes (e.g.
acetone) for cleaning the plastic lenses
of the front headlights.
Engine compartment
At the end of the winter the engine
compartment should be carefully
washed, without directing the jet
against any electronic control unit. Have
this operation performed at a
specialised workshop.
IMPORTANT The washing should take
place with the engine cold and the
ignition key in the STOP position. After
the washing operation, make sure that
the various protections (e.g. rubber
caps and guards) have not been
removed or damaged.
IMPORTANT
5)Detergents pollute the environment. Only
wash your vehicle in areas equipped to
collect and treat wastewater from this type
of activity.
IMPORTANT
30)In order to preserve the aesthetic
appearance of the paint abrasive products
and/or polishes should not be used for
cleaning the vehicle.
31)Avoid washing with water cannons,
rollers and/or brushes in washing stations.
Then, wash the car, only by hand, using
pH-neutral detergents; dry it with a wet
chamois leather.
142
SERVICING AND MAINTENANCE

WARNING
137)Never use flammable products, such
as petrol ether or rectified petrol to clean
the inside of the car. The electrostatic
charges which are generated by rubbing
during the cleaning operation may cause a
fire.
138)Do not keep aerosol cans in the car:
they might explode. Aerosol cans must not
be exposed to a temperature exceeding
50°C. When the vehicle is exposed to
sunlight, the internal temperature can
greatly exceed this value.
139)There must be no obstacles on the
floor underneath the pedals; make sure
that mats are always flat and do not
interfere with the pedals.
144
SERVICING AND MAINTENANCE

INDEX
"Alfa DNA" system............44
"All Weather" mode..........45
"Natural" mode............44
“Dynamic” mode...........44
“Race” mode..............45
Driving modes.............44
"Electronic Q2" system ("E-Q2")....42
"Follow Me Home" device........29
ABS.....................41
System intervention..........41
Accessories purchased by the
owner....................5
Air cleaner.................137
Alarm.....................16
Alfa Romeo Code system........14
Alzacristalli elettrici
Funzionamento............37
Ashtray....................35
ASR system (AntiSlip Regulation) . . .42
Backrest pocket.............35
Battery...................138
advice for extending lifetime. . . .138
replacement..............138
Battery (recharging)...........124
Body
body codes..............148
Bodywork
maintenance.............141protection against atmospheric
agents.................141
warranty................141
Bodywork versions...........148
Brakes...................152
brake fluid level............135
bulb replacement.........117 ,118
Bulb replacement
exterior lights.............116
interior lights.............119
Bulbs
types of bulbs............114
Car inactivity...............103
Carrying children safely..........86
CBC (Cornering Brake Control)
system..................41
Central locking...............32
Changing a bulb.............112
General instructions.........112
Changing a wheel............109
Cigar lighter.................34
Cleaning and maintenance
bodywork...............141
car interior...............143
engine compartment........142
front headlights............142
leather parts.............143
leather seats.............143
plastic and coated parts......143seats and fabric parts........143
windows................142
Climate control...............22
Passenger compartment air
diffusers.................23
Climatic comfort..............23
Clutch...................151
CO2 emissions..............167
Conditions of use............101
Control buttons..............60
Control panel and instruments.....58
Controls...................32
Cruise Control...............30
Cup holder.................35
Daytime running lights (DRL)......28
Diffusori aria laterali............22
Dimensions................159
Dipped beam headlights
bulb replacement..........116
Dipped headlights
bulb replacement..........116
Direction indicators............29
“Lane change” function.......29
bulb replacement..........116
Door mirrors
Door mirrors..............20
Doors.....................36
Central door locking/unlocking . . .36

Driver's side front airbag.........90
Driving style................101
DTC (Drag Torque Control) system . .41
EBD system................41
Electric windows..............37
Engine
engine cooling system fluid level......................134
identification codes.........148
marking................147
technical data............149
Engine codes...............148
Engine compartment
checking levels............132
washing................142
Engine coolant indicator.........60
Engine cover
Closing..................39
Opening.................38
Engine oil
consumption.............134
level check..............134
EOBD system...............46
ESC (Electronic Stability Control)
system..................40
Exterior lights................28
Extinguisher.................35
Filling the tank...............54
Fitting "Universal" child restraint
system..................87Fix&Go automatic kit..........106
Flashing...................29
Fluids and lubricants
(specifications)............163
Front airbags................90
Fuel consumption............166
Fuel cut-off system............33
Fuel level gauge..............60
Fuel supply................150
Fuses (replacement)...........120
Gear Shift Indicator...........60
Handbrake.................96
Hazard warning lights...........32
HBA system................42
Headlights..................39
Adjusting the headlights abroad.......................39
bulb replacement..........116
Light beam direction.........39
Heating and ventilation..........24
Hill Holder system.............42
Identification data
bodywork paint plate........147
chassis marking...........146
engine marking............147
identification data plate.......146
Ignition switch...............18
Steering lock..............18
Installing electrical/electronic
devices................5,47Instrument panel..............58
Interior fittings...............33
Interiors (cleaning)............143
Jack....................109
Lavacristallo
livello liquido lavacristallo......134
Light clusters
front light clusters (changing a
bulb)..................116
rear light clusters (changing a
bulb)..................117
Lubricants (specifications).......163
Luce plafoniera
sostituzione lampada........119
Luggage compartment
Opening.................38
Luggage compartment / Engine
cover...................38
Main beam headlights..........28
bulb replacement..........116
Maintenance and care
heavy-duty use of the car.....131
periodic checks...........131
scheduled servicing.........127
scheduled servicing plan......128
Manual climate control..........26
Menu.....................61
Menu options................61
Number plate lights
bulb replacement..........118
INDEX

inflation pressures..........158
reading the tyre code........155
snow tyres...............157
tyres provided............157
Tyres - maintenance...........139
Using the transmission.........96
Warning lights and messages.....67
Weights..................161Wheel rims
reading the rim code........155
Wheels and tyres
changing a wheel..........109
Fix&Go automatic (kit).......106
tyre inflation pressure........158
Wheel repair.............106Wheels and tyres..........139
Window cleaning.............29
Windows (cleaning)...........142
Windscreen washer nozzles......141
Windscreen wiper
blades.................140
replacing blades...........141
INDEX
MOPAR
TECHNICAL SERVICES - SERVICE ENGINEERING
FCA Italy S.p.A. - Largo Senatore G. Agnelli, 3 - 10040 Volvera - Torino (Italia)
Print No. 530.05. 53 - 1 Edition - /2015
All rights reserved. Reproduction, even partial, without written authorisation
from FCA Italy S.p.A. is prohibited12 0