cooling Alfa Romeo 4C 2018 User Guide

NOTE:
•Mixing of engine coolant (antifreeze) other than
specified Organic Additive Technology (OAT) engine
coolant (antifreeze), may result in engine damage
and may decrease corrosion protection. Organic Ad-
ditive Technology (OAT) engine coolant is different
and should not be mixed with Hybrid Organic
Additive Technology (HOAT) engine coolant (anti-
freeze) or any “globally compatible” coolant (anti-
freeze). If a non-OAT engine coolant (antifreeze) is
introduced into the cooling system in an emergency,
the cooling system will need to be drained, flushed,
and refilled with fresh OAT coolant (conforming to
MS.90032), by an authorized dealer as soon as pos-
sible.
• Do not use water alone or alcohol-based engine
coolant (antifreeze) products. Do not use additional
rust inhibitors or antirust products, as they may not
be compatible with the radiator engine coolant and
may plug the radiator.
• This vehicle has not been designed for use with
propylene glycol-based engine coolant (antifreeze).
Use of propylene glycolbased engine coolant (anti-
freeze) is not recommended. •
Some vehicles require special tools to add coolant
properly. Failure to fill these systems properly could
lead to severe internal engine damage. If any coolant
is needed to be added to the system please contact
your local authorized dealer.
Adding Coolant
Your vehicle has been built with an improved engine
coolant (OAT coolant conforming to MS.90032) that
allows extended maintenance intervals. This engine
coolant (antifreeze) can be used up to ten years or
150,000 miles (240,000 km) before replacement. To pre-
vent reducing this extended maintenance period, it is
important that you use the same engine coolant (OAT
coolant conforming to MS.90032) throughout the life of
your vehicle.
Please review these recommendations for using Or-
ganic Additive Technology (OAT) engine coolant (anti-
freeze) that meets the requirements of FCA Material
Standard MS.90032. When adding engine coolant (anti-
freeze):
• We recommend using Mopar Antifreeze/Coolant 10
Year/150,000 Mile (240,000 km) Formula OAT (Or-
ganic Additive Technology) that meets the require-
ments of FCA Material Standard MS.90032.
8
SERVICING AND MAINTENANCE 209

•Mix a minimum solution of 50% OAT engine coolant
that meets the requirements of FCA Material Stan-
dard MS.90032 and distilled water. Use higher con-
centrations (not to exceed 70%) if temperatures below
34°F (37°C) are anticipated. Please contact an
authorized dealer for assistance.
• Use only high purity water such as distilled or
deionized water when mixing the water/engine
coolant (antifreeze) solution. The use of lower quality
water will reduce the amount of corrosion protection
in the engine cooling system.
NOTE:
• It is the owner’s responsibility to maintain the proper
level of protection against freezing according to the
temperatures occurring in the area where the vehicle
is operated.
• Some vehicles require special tools to add coolant
properly. Failure to fill these systems properly could
lead to severe internal engine damage. If any coolant
is needed to be added to the system, please contact a
local authorized dealer.
• Mixing engine coolant (antifreeze) types is not rec-
ommended and can result in cooling system damage. If HOAT and OAT coolant are mixed in an emer-
gency, have a authorized dealer drain, flush, and
refill with OAT coolant (conforming to MS.90032) as
soon as possible.
Cooling System Pressure Cap
The cap must be fully tightened to prevent loss of
engine coolant (antifreeze), and to ensure that engine
coolant (antifreeze) will return to the radiator from the
coolant expansion bottle/recovery tank if so equipped.
The cap should be inspected and cleaned if there is any
accumulation of foreign material on the sealing sur-
faces.
WARNING!
•
Do not open hot engine cooling system. Never
add engine coolant (antifreeze) when the engine
is overheated. Do not loosen or remove the cap to
cool an overheated engine. Heat causes pressure
to build up in the cooling system. To prevent
scalding or injury, do not remove the pressure cap
while the system is hot or under pressure.
(Continued)
210 SERVICING AND MAINTENANCE

•If frequent engine coolant (antifreeze) additions are
required, the cooling system should be pressure
tested for leaks.
• Maintain engine coolant (antifreeze) concentration at
a minimum of 50% OAT coolant (conforming to
MS.90032) and distilled water for proper corrosion
protection of your engine which contains aluminum
components.
• Make sure that the coolant expansion bottle overflow
hoses are not kinked or obstructed.
• Keep the front of the radiator clean. If your vehicle is
equipped with air conditioning, keep the front of the
condenser clean.
• Do not change the thermostat for Summer or Winter
operation. If replacement is ever necessary, install
ONLY the correct type thermostat. Other designs
may result in unsatisfactory engine coolant (anti-
freeze) performance, poor gas mileage, and increased
emissions.
Brake System
In order to assure brake system performance, all brake
system components should be inspected periodically. Refer to the “Maintenance Plan” in this section for the
proper maintenance intervals.
WARNING!
Riding the brakes can lead to brake failure and
possibly a collision. Driving with your foot resting
or riding on the brake pedal can result in abnor-
mally high brake temperatures, excessive lining
wear, and possible brake damage. You would not
have your full braking capacity in an emergency.
Brake Master Cylinder
The fluid level in the master cylinder should be checked
when performing under hood services, or immediately
if the “Brake Warning Light” is on.
Be sure to clean the top of the master cylinder area
before removing the cap. If necessary, add fluid to bring
the fluid level up to the requirements described on the
brake fluid reservoir. Fluid level can be expected to fall
as the brake pads wear. The brake fluid level should be
checked when the pads are replaced. However, low
fluid level may be caused by a leak and a checkup may
be needed.
212 SERVICING AND MAINTENANCE

FLUID CAPACITIES
U.S.Metric
Fuel (Approximate)
1750 Turbo Engine 10.5 Gallons40 Liters
Reserve Fuel 1.1 Gallons4 Liters
Engine Oil with Filter
1750 Turbo Engine 6.1 Quarts5.8 Liters
Cooling System
1750 Turbo Engine (Mopar
Antifreeze/Engine Coolant 10
Year/150,000 Mile Formula). 11.2 Quarts
10.6 Liters
252 TECHNICAL SPECIFICATIONS

Break-In Recommendations, New Vehicle.......131
Bulb Replacement ....................... .156
Bulbs, Light ........................ .126, 156
Capacities, Antifreeze (Engine Coolant) .........252
Capacities, Fluid ........................ .252
Caps, Filler Oil (Engine) ...................... .195, 201
Radiator (Coolant Pressure) ...............210
Carbon Monoxide Warning ..............123, 251
Car Washes ........................... .241
Cellular Phone ......................... .258
Chains, Tire ........................... .237
Changing A Flat Tire ..................... .216
Chart, Tire Sizing ....................... .218
Check Engine Light (Malfunction Indicator Light) . .78
Checking Your Vehicle For Safety .............123
Checks, Safety ......................... .123
Child Restraint ..........................114
Child Restraints Booster Seats .........................118
Child Restraints .......................114
Child Seat Installation ...................120
Infants And Child Restraints ..............116
Older Children And Child Restraints ........117Clean Air Gasoline
...................... .248
Cleaning Wheels ............................ .236
Windshield Wiper Blades .................204
Climate Control ..........................35
Manual ..............................35
Compact Spare Tire ...................... .233
Contract, Service ........................ .262
Coolant (Antifreeze) ...................252, 253
Coolant Pressure Cap (Radiator Cap) ..........210
Cooling System ......................... .207
Adding Coolant (Antifreeze) ..............209
Coolant Level ..................... .208, 211
Disposal Of Used Coolant ................211
Drain, Flush, And Refill ..................208
Inspection ...........................211
Points

To Remember ....................211
Pressure Cap ........................ .210
Radiator Cap ........................ .210
Selection Of Coolant (Antifreeze) ...........208
Corrosion Protection ..................... .240
Cruise Light .............................76
Cupholders .............................50
Customer Assistance ..................... .260
12
INDEX 267

Daytime Running Lights....................31
Dealer Service .......................... .200
Deck Lid, Release .........................43
Defroster, Windshield .....................124
Delay (Intermittent) Wipers ..................34
Diagnostic System, Onboard .................77
Dimmer Control ..........................33
Disabled Vehicle Towing ...................181
Disposal Antifreeze (Engine Coolant) ...............211
Door Locks Child-Protection Door Lock — Rear Doors .....23
Driver’s Seat Back Tilt ......................24
Driving Through Flowing, Rising, Or Shallow Standing
Water .............................. .153
Electrical Outlet, Auxiliary (Power Outlet) .......50
Electrical Power Outlets ....................50
Electric Remote Mirrors .....................29
Electronic Brake Control System ...............83
Electronic Speed Control (Cruise Control) .......143
Electronic Throttle Control Warning Light ........70
Emergency, In Case Of Hazard Warning Flasher .................156 Jacking
............................ .216
Jump Starting ........................ .176
Overheating ......................... .180
Towing ............................ .181
Emission Control System Maintenance ..........78
Engine ............................... .195
Air Cleaner ......................... .201
Break-In Recommendations ...............131
Checking Oil Level .....................196
Compartment ........................ .195
Cooling ............................ .207
Exhaust Gas Caution ................123, 251
Fails To Start ........................ .130
Flooded, Starting ..................... .130
Fuel Requirements .....................248
Jump Starting ........................ .176
Oil ............................ .200, 252
Oil Filler Cap ..................... .195, 201
Oil Filter ........................... .201
Oil

Selection ......................... .200
Overheating ......................... .180
Starting ............................ .129
Enhanced Accident Response Feature ..........184
Ethanol .............................. .249
268 INDEX