oil pressure Alfa Romeo 4C 2020 Owner handbook (in English)

41
WARNING LIGHTS ON PANEL
Warning lights on panelMeaningWhat to do
LOW ENGINE OIL PRESSURE
When the key is turned to MAR, the digital warning light
switches on, but it should switch off as soon as the engine
is started. The digital warning light switches on constantly
together with the message in the display when the system
detects that the engine oil pressure is insufficient.
DETERIORATED ENGINE OIL
(where provided)
The digital warning light will turn on flashing and (on some
versions) with a specific message on the display.
The digital warning light may flash in the following ways,
depending on the versions:
– for 1 minute every two hours;
– for 3 minute cycles with the warning light off for
intervals of 5 seconds until oil is changed.
After the initial warning, each time the engine is started
up, the digital warning light will continue to flash in the
same mode, until the oil is changed. In addition to the
warning light the display will also show an associated
message (on some versions). If the digital warning light
flashes, this does not mean that the car is defective, but
simply informs the driver that it is now necessary to
change the oil as a result of regular vehicle use.
Remember that the deterioration of engine oil is
accelerated by using the car for short drives, preventing
the engine from reaching operating temperature.
4)
Contact a dedicated
Alfa Romeo Dealership as soon as possible to have the
problem corrected.
23)

KNOWING THE INSTRUMENT PANEL TOOLS
46
Warning lights on panelMeaningWhat to do
GENERIC FAILURE INDICATION
(where provided)
The symbol appears on the display together with the
events shown below.
Engine oil pressure sensor
The symbol appears when a failure is detected in the
engine oil pressure sensor. The display shows the
dedicated message.In this case, go to a dedicated
Alfa Romeo Dealership as soon as possible to have the
fault corrected.
Clutch overheating message
The
symbol, together with a message on the display,
lights up to indicate clutch overheating.
If you continue driving, the symbol
will disappear and
the warning light will come on (on some versions
together with a message on the display) to indicate a
gearbox fault.
If the symbol comes on together with a message on
the display, limit the gear shifting and/or change the
condition of use, until normal operating conditions are
restored.
If the warning light lights up (a message will appear on
the display, on some versions) stop immediately, operate
the handbrake, switch off the engine and wait 5 minutes:
after this, normal transmission operating conditions will
be restored.
Should the transmission failure condition persist, contact
the dedicated Alfa Romeo Dealership.
FUEL CUT-OFF SYSTEM
The symbol and the corresponding message are shown on
the display in the following cases:
❒ fuel cut-off system intervention:
the yellow symbol lights up;
❒ fuel cut-off system failure:
the red symbol lights up.For reactivating the fuel cut-off system, refer to the
description in the
“Fuel cut-off system” section in the “In an emergency”
chapter. If it is not possible to restore the fuel supply,
contact a dedicated Alfa Romeo Dealership.
s è

105
PERIODIC CHECKS
Every 1,000 km or before long journeys,
check and, if necessary, top up the
following:
❒ engine coolant level;
❒ brake fluid;
❒ windscreen washer fluid;
❒ tyre inflation pressure and condition;
❒ operation of lighting system
(headlights, direction indicators, hazard
warning lights, etc.);
❒ operation of windscreen
washing/wiping system and
positioning/wear of wiper blade.
Every 3,000 km check and top up if
required: engine oil level.
IMPORTANT To find out the correct oil
quantity, always check using the dipstick.
Carry out the check with the vehicle
parked on level ground.
DEMANDING USE OF THE CAR
If the vehicle is used mainly under one of
the following conditions:
❒ trailer or caravan towing;
❒ dusty roads;
❒ short repeated distances (less than
7-8 km) and with external temperatures
below zero;
❒ engine often idling or driving long
distances at low speeds or long periods
of inactivity;
❒ you should perform the following
inspections more frequently than shown
in the Scheduled Servicing Plan:
❒ check front disk brake pad conditions
and wear;
❒ check cleanness of locks, bonnet and
boot and lever cleanness and lubrication;
❒ visually inspect condition of: engine,
gearbox, transmission, pipes and hoses
(exhaust - fuel system - brakes) and
rubber elements (gaiters - sleeves -
bushes - etc.);
❒ check battery charge and battery fluid
level (electrolyte);❒ visually inspect conditions of the
accessory drive belts;
❒ check and, if necessary, change engine
oil and replace oil filter;
❒ check air cleaner and replace it, if
required.
Using the car on track should be regarded
as an exception. The car has been
designed and produced for road use.

SERVICING AND CARE
118
Proceed as follows to reposition:
❒ tighten the screws with folding ring
1 fig. 103 in the housings on the floor;
❒ unite the Velcro fabric strips 2 of the
mats with those on the floor, taking care
to apply light pressure and ensure that
the fastening is efficient.
132)
SEATS AND FABRIC OR
MICROFIBRE PARTS
Remove dust with a soft brush or a
vacuum cleaner.
For cleaning microfibre upholstery
(on some versions, including steering
wheel).
It is advisable to moisten the brush.
Rub the seats with a sponge moistened
with a solution of water and neutral
detergent.
LEATHER SEATS
(where provided)
Remove the dry dirt with a chamois or
slightly damp cloth, without exerting too
much pressure.
Remove any liquid or grease stains using
an absorbent dry cloth, without rubbing.
Then clean with a soft cloth or buckskin
cloth dampened with water and mild
soap. If the stain persists, use specific
products and observe the instructions
carefully.
IMPORTANT Never use alcohol.
Make sure that the cleaning products
used contain no alcohol or alcohol
derivatives, even in small quantities.
PLASTIC, CARBON AND
COATED PARTS
Clean interior plastic and visible carbon
parts with a damp cloth (if possible made
from microfibre), and a solution of water
and neutral, non-abrasive detergent.
To clean oily or persistent stains, use
specific products free from solvents and
designed to maintain the original
appearance and colour of the
components.
Remove any dust using a microfibre cloth,
if necessary moistened with water.
The use of paper tissues is not
recommended as these may leave
residues.
26)
LEATHER UPHOLSTERY
(for versions/markets, where provided)
Use only water and mild soap to clean
these parts. Never use alcohol or
alcohol-based products.
Before using a specific product for
cleaning interiors, make sure that it does
not contain spirit and/or alcohol based
substances.
130)Never use flammable products, such
as petroleum ether or modified petrol, to
clean the inside of the car. The
electrostatic charges which are
generated by rubbing during the cleaning
operation may cause a fire.
131)Do not keep aerosol cans in the car:
danger of explosion.
Aerosol cans must not be exposed to a
temperature exceeding 50°C.
When the vehicle is exposed to sunlight,
the internal temperature can greatly
exceed this value.
132)It is essential that there is nothing
under the pedals: make sure the mats are
lying flat and do not get in the way of the
pedals.
IMPORTANT
26)Never use alcohol, petrols and
derivatives to clean the dashboard and
instrument panel lens.
WARNING

IMPORTANT INFORMATION AND RECOMMENDATIONS
CIGAR LIGHTER
The cigar lighter gets very hot. Handle it carefully and make sure that children don’t use it: risk of fire and/or burns.
ASHTRAY
Do not use the ashtray as a waste paper basket: it may catch fire in contact with cigarette stubs.
WHEELS AND TYRES
The road holding qualities of the car also depend on the correct inflation pressure of the tyres. If tyre pressure is too low, the tyre may
overheat and be severely damaged as a result.
Do not switch tyres from the left to the right side and vice versa, in order to prevent inversion of the rotation direction.
Do not repaint alloy wheel rims at temperatures higher than 150°C.
The mechanical characteristics of the wheels might be compromised.
The car is always equipped with front and rear wheels of different dimensions. It is not therefore possible to move the wheels from the
front to the back and vice versa.
ACCESSORIES PURCHASED BY THE OWNER
Take care when fitting additional spoilers or non-standard alloy wheels: they could reduce the ventilation of the brakes and affect
efficiency in sharp, repeated braking or on long descents. Make sure that nothing obstructs the pedal stroke (mats, etc.).
CATALYTIC SILENCER
Under operating conditions, the catalytic converter becomes very hot. Therefore, do not park the car on flammable materials
(grass, dry leaves, pine needles etc.) to avoid the risk of fire.
IMPORTANT