clock Acura MDX 2003 Owner's Manua

Page 347 of 420

Remove the bulb by turning it
approximately one-quarter turn
counterclockwise.
Your car uses halogen f og light
bulbs. See page f or inf ormation
on replacing a halogen bulb.
Remove the electrical connector
fromthebulbbysqueezingthe
connector to unlock the tab, then
slide the connector of f the bulb.
Push the electrical connector onto
the new bulb.
Use a wrench to loosen the light
assembly’s mounting bolt.
Remove the light assembly f rom
the bumper.
1.
2.
3.
4.
5.
341
CONT INUED
ReplacingaFogLightBulb
Lights
Maint enance343
BOLT
CONNECTOR

Page 348 of 420

Turn on the headlights to test the
new bulb. Insert the new bulb into the hole
and turn it one-quarter turn clock-
wise to lock it in place.
Put the light assembly into the
bumper. Tighten the mounting
bolt.Remove the socket by turning it
one-quarter turn counterclockwise.
Open the tailgate. Use a
screwdriver protected with a cloth
to pry open the two covers.
Remove the two screws and
remove the rear light assembly
f rom the rear pillar.
Determine which of the f our bulbs
is burned out: brake/taillight, turn
signal/hazard lights, side marker
light, or back-up light. Remove the burned out bulb. To
remove the brake/taillight, back-
up or side marker light bulb, pull
the bulb straight out of its socket.
To remove the turn signal/hazard
light bulb, push it in and turn it
counterclockwise until it unlocks.
1.
2.
3.
4.
8. 6.
7.
5.
Replacing Rear Bulbs
Lights
Maint enance344

Page 349 of 420

Put the socket back into the light
assembly and turn it clockwise to
lock it in place. Test the light to make sure the
new bulb is working. Pull the bulb straight out of its
socket.
Push the new bulb straight into
the socket until it bottoms.
Install the new bulb into the
socket.
Push the socket into the light
assembly and turn it clockwise
until it locks.
Testthelightstomakesurethe
new bulb is working.
Install the rear light assembly in
the body.Tighten the two screws.
Snap the covers back into position.
Remove the light assembly cover
by prying caref ully with a cloth-
covered screwdriver in the
notches along the top edge.Then
pivot the cover out and down.
Remove the socket f rom the light
assembly by turning it one-quarter
turn counterclockwise.Place the cover back into the light
assembly. Push it up until it locks
in place.
1. 4.
5.
6.
2. 3.
6.
7.
8.
9. Replacing a High-mount Brake
Light Bulb
Lights
Maint enance345

Page 366 of 420

Open the tailgate.Take the tools out of the storage
compartment.
Turn the jack’s end bracket
counterclockwise to loosen it, then
remove the jack.
Thetoolsandjackarebehinda
cover in the cargo area on the
driver’s side. Remove the cover by
pushing the top of the cover. The spare tire is stored
underneath the rear cargo area.
Remove the plastic cover on the
cargo area lining to access the
shaft for the spare tire hoist.
3.
4.
5.
6.7.
Changing a Flat T ire
T aking Care of t he Unexpect ed362
COVER
COVER

Page 367 of 420

Loosen the f ive wheel nuts 1/2
turn with the wheel wrench.
Put the wheel nut wrench on the
hoist shaf t. Turn the wrench
counterclockwise to lower the
spare tire to the ground. Keep turning the wheel wrench to
create slack in the cable.
Remove the bracket from the
spare tire.11.
10.
8.
9.
CONT INUED
Changing a Flat T ire
T aking Care of t he Unexpect ed363
SPARETIREWRENCH BRACKET

Page 368 of 420

ÚUse the extension and wheel
wrench as shown to raise the
vehicle until the f lat tire is of f the
ground. Remove the wheel nuts, then
remove the f lat tire. Temporarily
place the f lat tire on the ground
with the outside surface of the
wheel f acing up. You could scratch
the wheel if you put it f ace down.
Locate the jacking point nearest
thetireyouneedtochange.Itis
pointed to by a mark molded
into the underside of the body.
Place the jack under the jacking
point. Turn the end bracket
clockwise until the top of the jack
contacts the jacking point. Make
sure the jacking point tab is
restinginthejacknotch.
12.
13. 14.
Changing a Flat T ire
T aking Care of t he Unexpect ed364
JACKING POINT WHEEL WRENCHEXTENSION

Page 370 of 420

Tighten the wheel nuts securely in
the same crisscross pattern. Have
the wheel nut torque checked at
the nearest automotive service
f acility.
Tighten the wheel nuts to:
Remove the center cap from the
flat tire.Place the f lat tire f ace up under
the hoist.
Slowly turn the wheel wrench
clockwisetotakeuptheslackof
the hoist cable. Make sure the
bracketisseatedinthecenter
hole of the spare tire.
Turn the wheel wrench clockwise
until the f lat tire rests against the
underbody of the vehicle and you
hear the hoist click.
Insert the hoist bracket into the
center hole of the f lat tire.
18.
19. 20.
21.
22.
23.
Changing a Flat T ire
T aking Care of t he Unexpect ed366
80 lbf·ft (108 N·m , 11 kgf·m)

Page 376 of 420

If the temperature gauge stays at
the red mark, turn of f the engine.
Wait until you see no more signs
of steam or spray, then open the
hood.
If you don’t f ind an obvious leak,
check the coolant level in the
radiator reserve tank (see page). If the level is below the
MIN mark, add coolant to halfway
between the MIN and MAX marks.
If there was no coolant in the
reserve tank, you may also have to
add coolant to the radiator. Let the
engine cool down until the pointer reaches the middle of the tempera-
ture gauge, or lower, bef ore check-
ing the radiator.
Using gloves or a large heavy
cloth, turn the radiator cap
counterclockwise, without pushing
down, to the f irst stop. This
releases any remaining pressure in
the cooling system. After the
pressure releases, push down on
the cap and turn it until it comes
off.
Look f or any obvious coolant leaks,
such as a split radiator hose.
Everything is still extremely hot,
so use caution. If you f ind a leak, it
must be repaired bef ore you
continue driving (see
on page ). Start the engine and set the
temperature control dial to
maximum (climate control to
FULL AUTO at 90°F/32°C). Add
coolant to the radiator up to the
base of the f iller neck. If you do
not have the proper coolant
mixture available, you can add
plain water. Remember to have
the cooling system drained and
ref illed with the proper mixture as
soon as you can.
If the temperature stays normal,
check the coolant level in the
radiator reserve tank. If it has
gone down, add coolant to the
MAX mark. Put the cap back on
tightly. Put the radiator cap back on
tightly. Run the engine and watch
the temperature gauge. If it goes
back to the red mark, the engine
needs repair. (See
on page .)
4.
5.
6.
7.
8. 9.10.
11.
12.
385
241 385
T aking Care of t he Unexpect ed
If Your Engine Overheats
Emergency
Towing
Emergency
Towing
372
Removing the radiator cap
while the engine is hot can
cause the coolant to spray out,
seriously scalding you.
Always let the engine and
radiator cool down before
removing the radiator cap.

Page 388 of 420

ÎÎ


No.
Amps.
No. Amps.
Circuits Protected Circuits Protected
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
15 A
10 A
7.5 A
7.5 A 10 A
15 A
7.5 A
7.5 A 10 A
7.5 A 15 A
30 A
7.5 A
1
2
3
4
5
6
7
8
9
10
11
12
13
On Canadian models 30 A
20 A
20 A
20 A
20 A
10 A
20 A
20 A
15 A
15 A
10 A
20 A
7.5 A 20 A20 A
20 A
Fuel Pump
SRS
Heater Control, A/C Clutch
Relay, Cooling Fan Relay
Power Mirror
Daytime Running Light /
Rear Wiper
ECU(PCM),CruiseControl
OPDS
ACC Relay
Back-up Lights, Instrument
Lights
Turn Signals
IG Coil
Front Wiper
Starter Signal
Moonroof
Driver’s Power Seat Sliding
Passenger’s Power Seat
Reclining
Daytime Running Light
Driver’s side Rear Power
Window
Front Passenger’s Power
Window
Front Accessory Socket
Small Light
Interior Light
Power Door Lock
Back Up, Clock
Heated Seat
Driver’s Power Window
Passenger’s Side Rear
Power Window
Canadian models
:
Driver’s Power Seat Reclining
Passenger’s Power Seat Sliding
Fuses
T aking Care of t he Unexpect ed384
Driver’s Side INTERIOR FUSE BOX
Passenger’s Side
Front Front
:

Page 413 of 420

CONT INUED
............................
Fabric, Cleaning .355
...................................
Fan, Interior .138
Features, Comfort and ..............................
Convenience .133
....................
Filling the Fuel Tank . 237
Filters ...............................................
Air .321
.......................
Air Conditioning .331
...............................................
Oil .309
............
Def ects, Reporting Saf ety . 404
................
Def ogger, Rear Window . 88
..............
Def rosting the Windows . 140
..........................
Dif f erential Fluid .318
..........................
Digital Clock .150, 190
....................................
Dimensions .390
...............
Dimming the Headlights . 79
Dipstick ..........
Automatic Transmission . 317
..................................
Engine Oil .240
..........................
Directional Signals .83
........
Disc Brake Wear Indicators . 262
.....................
Disposal of Used Oil .310
Doors ..............
Locking and Unlocking . 93
....................
Lockout Prevention . 94
......................
Power Door Locks .93
..........
DOT Tire Quality Grading . 392
.....................................
Drive Belts .331
...........
Driver and Passenger Safety . 5
...........................................
Driving .249
....................................
Economy .242
.........................
In Bad Weather .269
................
In Foreign Countries . 396
Driving Position Memory ........................................
System .118 ..................
Dust and Pollen Filter . 331
...................................
DVD Player .199
..............................
Economy, Fuel .242
............
Emergencies on the Road . 359
.............
Battery, Jump Starting . 369
...........
Brake System Indicator . 377
................
Changing a Flat Tire . 361
.....
Charging System Indicator . 374
..................
Checking the Fuses . 380
.....
Low Oil Pressure Indicator . 373
...
Malf unction Indicator Lamp . 375
..................
Overheated Engine . 371
.........................
Emergency Brake .117
......................
Emergency Flashers .87
......................
Emergency Towing .385
.......................
Emissions Controls .397
Engine ....
Coolant Temperature Gauge . 75
.................................
Drive Belts .331
Malf unction Indicator ................................
Lamp .68, 375
........
Oil Pressure Indicator . 68,373
..............
Oil, What Kind to Use . 307...............................
Overheating .371
............................
Specif ications .391
............................
Speed Limiter .257
.......................................
Starting .252
......................
Ethanol in Gasoline .395
.
Evaporative Emissions Controls . 397
...............................
Exhaust Fumes .62
Exhaust Gas Recirculation ........................................
System .398
Expectant Mothers, Use of Seat ........................................
Belts by .19
..................
Exterior, Cleaning the . 354
Index
E
F
III

Page:   < prev 1-10 11-20 21-30