Acura TL 2007 Repair Manual

The instrument panel has many
indicato rs to give you important
info rmation about your vehicl e. If
you continue driving without
fastening your seat belt, the beeper
sounds and the indicator flashes
again at regular intervals, and you
will also see a ‘‘FASTEN SEAT
BELT’’ or ‘‘FASTEN PASSENGER
SEAT BELT’’ message on the multi-
inf ormation display (see page ).
For more inf ormation, see page .
This indicator reminds you and your
passengers to f asten your seat belts.
If you turn the ignition switch to the
ON (II) position bef ore f astening
your seat belts, the beeper sounds,
and the indicator f lashes. If you do
not fasten your seat belts before the
beeper stops, the indicator stops
f lashing but remains on.
If your f ront passenger does not
f asten their seat belt, the indicator
comes on about 6 seconds af ter the
ignition switch is turned to the ON
(II) position. 68
18
Instrument Panel Indicators
Seat Belt Reminder
Indicator
58
——
y
y
(%yy

The engine can be severely damaged
if this indicator flashes or stays on
wh en the engine is running. For
more information, see page .
If this indicator comes on when the
engine is running, the battery is not
being charged. For more information,
see page .
See page . This
indicator has two functions: If
it stays on after you have fully
released the parking brake while
the engine is running, or if it
comes on while driving, it can
indicate a problem in the brake
system. For more information, see
page .
This
indicator comes on when you
turn the ignition switch to the ON
(II) position. It is a reminder to
check the parking brake. A beeper
sounds if you try to drive with the
parking brake not fully released.
Driving with the parking brake not
fully released can damage the
brakes and tires.
If you drive without releasing the
parking brake, a beep er will sound,
and you will also see a ‘‘RELEASE
PARKING BRAKE’’ message on the
multi-info rmation display (see page
).
1.
2.
324
324 325 326
68
Instrument Panel Indicators
L ow Oil Pressure
Indicator
Charging System
Indicator
Malf unction Indicator
Lamp Parking Brake and
Brake System
Indicator
Inst rument s and Cont rols
59
Canada
U.S.
——
y
y
(%yy

This indicator comes on when you
turn the ignition switch to the ON
(II) position. If it comes on at any
other time, it indicates that the
passenger’s side airbag has
automatically shut off. For more
info rmation, see page .
This
indicator comes on briefly when
you turn the ignition switch to the
ON (II) position. If it comes on at
any other time, it indicates a
poten tial problem with your front
airbags. This indica tor will also alert
you to a poten tial problem with your
side airbags, passenger’s side airbag
automatic cutoff system, side curtain
airbags, automatic seat belt
tensioners, driver’s seat position
sensor, or the front passenger’s
weight sensors. For more
info rmation, see page .
This
indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. If it comes on at any other
time, there is a problem with the
ABS. If this happens, have your
vehicle checked at a dealer. With
this indicator on, your vehicle still
has normal braking ability but no
an ti-lock function. For more
info rmation, see page .
29 30
262
Anti-lock Brake System
(A BS) Indicator
Supplemental Restraint
System Indicator
Side A irbag Of f
Indicator
Instrument Panel Indicators
60
U. S. Canada
——
yy
(%yy

This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. This
indicator has three functions:
Itcomesonasareminderthatyou
have turned off the vehicle
stability assist (VSA) system.
It flashes when VSA is active (see
page ).
It comes on along with the VSA
system indicator if there is a
problem with the VSA system.
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. See page for more
info rmation on the VSA system. This
indicator comes on when you
set the cruise control. See page
for information on operating the
cruise control.
Ifitcomesonandstaysonatany
other
time, or if it does not come on
wh en you turn the ignition switch to
the ON (II) position, there is a
problem with the VSA system. Take
your vehicle to a dealer to have it
checked. Without VSA, your vehicle
still has normal driving ability, but
will not have VSA traction and
stability enhancement. See page
for more information on the
VSA system. This
indicator comes on when you
turn on the cruise control system by
pressing the CRUISE button (see
page ).
1.
2.
3.
264 264
264 184
184
Vehicle Stability Assist
(VSA ) System Indicator
VSA A ctivation Indicator
Cruise Main Indicator
Cruise Control Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
61
——
yy
(%yy

The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see page ). Replace
the bulb as soon as possible, since
other drivers cannot see that you are
signaling.
When you press the hazard warning
button, both turn signal indicato rs
blink. All turn signals on the outside
of the vehicle should flash. If
this indicator comes on when the
ignition switch is turned to the ON
(II) position and the parking brake is
rele ased, it means there is a problem
in the circuit. Have your vehicle
checked by your dealer.
This indicator comes on with the
high beam headlights. See page f or inf ormation on the headlight
controls. This indicator reminds you that the
exterior lights are on. It comes on
when the light switch is in either the
or position. This indicator
will also come on when the light
switch is in AUTO and the lights
turn on automatically. If you turn the
ignition switch to the ACCESSORY
(I) or the LOCK (0) position without
turning of f the light switch, this
indicator will remain on. A reminder
chime will also sound when you open
the driver’s door.
294
86
Turn Signal and
Hazard Warning
Indicators
‘‘Daytime Running
Lights’’ Indicator
Lights On Indicator
High Beam Indicator
Instrument Panel Indicators
62
——
yy
(%yy

This indicator is in the fuel gauge. It
comesonasareminderthatyou
must refuel soon. When the indicator
comes on, there is about 1.2 U.S. gal
(4.5
) of fuel remaining in the tank
before the needle reaches E. There
is a small reserve of fuel remaining
in the tank when the needle does
reach E.
This
indicator comes on briefly when
you turn the ignition switch to the
ON (II) position. It will then go off if
you have inserted a properly-coded
ignition key. If it is not a properly-
coded key, the indicator will blink,
and the engine’s fuel system will be
disabled. (see page ). This
indicator comes on when you
turn on the fog lights. See page
for information on fog light
operation.
You will also see a ‘‘FUEL LOW’’
message on the multi-information
display (see page ).
This indicator also blinks several
times when you turn the ignition
switch f rom the ON (II) position to
the ACCESSORY (I) or LOCK (0)
position.
94
6886
Immobilizer System
Indicator
L ow Fuel Indicator
Fog L ight Indicator
Instrument Panel Indicators
Inst rument s and Cont rols
63
LOW FUEL INDICATOR
——
yy
(%yy

This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position. If it comes on while driving,
it means that one or more of your
vehicl e’s tires are extremely low on
pressure. You will also see a
‘‘CHECK TIRE PRESSU RE’’
message on the multi-information
display. The multi -information
display will show you which tire has
lost the pressure and how much
pressure it has lost (see page ).If
this happens, pull to the side of the
ro ad when it is safe, check which tire
has lost the pressure on the multi-
info rmation display, and determine
the cause. If it is because of a flat tire,
replace the flat tire with the compact
spare (see page ), and have the
flat tire repaired as soon as possible.
If two or more tires are underinflated,
call a professional towing service.
For more information, see page .This
indicator comes on when there
is a system message on the multi-
information display. Press the INFO
button on the steering wheel (see
page ) to see the message (see
page ).
Most of the time, this indicator
comes on along with other indicators
in the instrument panel such as the
seat belt reminder indicator, SRS
indicator, VSA system indicator, etc.
268 313
26666
68
Low Tire Pressure
Indicator
Message Indicator
Instrument Panel Indicators
64
——
yy
(%yy

This shows the temperature of the
engine’s coolant. During normal
operation, the pointer should rise to
about the middle of the gauge. In
severe driving conditions, the pointer
may rise to the upper zone. If it
reaches the red (hot) mark, pull
safely to the side of the road. Turn to
page f or instructions and
precautions on checking the engine’s
cooling system.
This shows how much f uel you have.
It may show slightly more or less
than the actual amount. Driving
uphill or making turns can cause the
needle to f luctuate or the low f uel
indicator to come on early. The
needle returns to the bottom after
you turn of f the ignition. 322
Temperature Gauge
Fuel Gauge
Gauges
Inst rument s and Cont rols
65
TEMPERATURE GAUGE
TACHOMETER SPEEDOMETER
FUEL GAUGE
Avoid driving with an extremely low f uel level. Running out of f uel could cause
the engine to misf ire, damaging the catalytic converter.
——
yy
(%yy

ÛÝÛÝ
The
multi -information display in the
instrument panel displays various
inform ation and messages when the
ignition switch is in the ON (II)
position. Some of the messages help
you operate your vehicle more
comfortably.
Others help to keep you aware of the
periodic maintenance your vehicle
needs for continued trouble-free
driving.
When you open the driver’s door, a
‘‘Welcome’’ message is shown on the
multi-info rmation display. To
change the display, press the
INFO( / )buttononthesteering
wheel repeatedly until the main
menu appears (see page ). With
the ignition switch in the ON
(II) position, the multi -information
display changes as shown on page
each time you press the INFO
( / ) button or SEL/RESET
button.
Wh en you turn the ignition switch to
the ON (II) position, what you last
selected is displayed.
In the multi-information display, the
system message is also displayed
(see page ) and you can
cu stomize your vehicle control
settings (see page ).
69 69
6877
Multi-Inf ormation Display
66
SEL/RESET
BUTTON
INFO BUTTONS
——
yy
(%y
y

ÛÝÛÝ
If there is a problem with your
vehicle, f or example, the parking
brake is not f ully released or a door
is not f ully closed, the multi-
inf ormation display will show you the
problem. It does this by interrupting
the current display with one or more
messages. The system message(s) triggers the
appropriate indicator(s) on the
instrument panel, including the
system message indicator, to come
on. The system message indicator
does not go of f until the problem(s)
is corrected.
You will also hear a beep when the
system message indicator comes on
for the first time.
Most of the messages are displayed
f or about 5 seconds, and then the
normal display returns. If there are
several system messages to be
shown, the display switches these
messages every 5 seconds.
To cancel the message(s) bef ore 5
seconds elapsed, press the INFO
( / ) button on the steering wheel.
Even if you press the INFO ( / )
button, some messages stay on or
come on again at regular intervals
until the problem is corrected.
Here is a list of all messages:
CONT INUED
Multi-Inf ormation Display
System Messages
Inst rument s and Cont rols
67
SYSTEM MESSAGE INDICATOR
——
yy
(%yy