lock Acura TL 2009 Owner's Manual

Here are some guidelines f or using
voice control:Adjust the airflow from both the
dashboard and side vents so they
do not blow against the
microphone on the ceiling.
Close the windows and the
moonroof .
To enter a command, press and
release the HFL Talk button. After
the beep, say your command in a
clear, natural tone.
When voice commands are used,
the fan speed will be automatically
adjusted to low. However, for
better voice recognition, lowering
the f an speed may be necessary. If the microphone picks up voices
other than yours, the system may
not interpret your voice
commands correctly.
If HFL does not recognize a
command, its response is ‘‘Pardon.’’
If it doesn’t recognize the
command it plays an appropriate
Help prompt. Response time may
vary depending on the voice
command.
To hear a list of available options
at any time, press the HFL Talk
button, wait f or the beep, and say
‘‘Hands f ree help’’ or ‘‘Help.’’
When you are at the main menu,
you can hear general HFL
inf ormation such as pairing or
setting up the system. Press the
HFL Talk button, wait f or the beep,
and say ‘‘Tutorial.’’Many commands can be spoken
together. For example, you can
say, ‘‘Dial 123-456-7891.’’
To enter a string of numbers in a
Call or Dial command, you can say
them all at once, or you can
separate them in blocks of 3, 4, 7,
10, and 11.
To skip a voice prompt, press the
HFL Talk button while HFL is
speaking. HFL will then begin
listening f or your next command.
BluetoothHandsFreeL ink(Models without navigation system)
Using Voice Control
396
\f—\f—y
y
) \f\fy\f\f
y
2009 TL

You can select or change some
settings for the HFL system. Here
are the settings you can select or
change. To do this, make sure your
vehicle is parked safely, with your
phone on and the ignition switch in
the ACCESSORY (I) or ON (II)
position.You can set a f our-digit security
passcode to lock the HFL system
f or security purposes.
If you f orget your passcode, you
cannot activate HFL. Consult your
dealer to cancel the passcode.
You can also select a ‘‘System
Clear’’ command to reset HFL
(see page ).
You can change the security
passcode. The incoming notif ication can be
set to a ring tone, a prompt, or no
notif ication. The def ault setting is
aprompt.
Press and release the Talk button.
Af ter the beep, say ‘‘System setup.’’
HFL responds ‘‘System setup
options are security, change
passcode, call notif ication, auto
transf er, and clear. Press the Talk
button and say a command.’’
Press and release the Talk button.
Af ter the beep, say ‘‘Security.’’
HFL responds ‘‘Security is
disabled. Would you like to enable
security? Press the Talk button
and say Yes or No.’’
Press and release the Talk button.
Af ter the beep, say ‘‘Yes.’’
HFL responds ‘‘What is the f our-
digit number you would like to set
as your security passcode? Press
the Talk button and say the
number.’’
If you say ‘‘No,’’ HFL returns to
idle.
Press and release the Talk button.
Af ter the beep, say the f our-digit
passcode you want to use. For
example,say‘‘1,2,3,4.’’
HFLresponds‘‘1,2,3,4.Isthis
correct? Press the Talk button and
say Yes or No.’’
3.
1.
2. 4.
417
To set a security passcode, do this:
Setting Up the System
Setting a security passcode
Changing a security passcode Selecting the incoming
notif ication
BluetoothHandsFreeL ink(Models without navigation system)
404
\f—\f—y
y
) \f\fy\f\fy
2009 TL

HFL responds ‘‘Security is on.
Each time the vehicle is turned on,
the passcode will be required to
use the system. If you f orget this
passcode, you must either go to
the dealer to have it reset, or clear
the entire system using the
System Clear command.’’
Once a passcode is set, HFL will
prompt you f or your passcode each
time the ignition switch is turned to
the ON (II) position and you press
the Talk button. You will only be
askedforthepasscodeonceper
ignition cycle. Press and release the Talk button.
Af ter the beep, HFL prompts ‘‘The
system is locked. What is the f our-
digit passcode?’’
Press and release the Talk button.
Af ter the beep, say your f our-digit
passcode.Forexample,say‘‘1,2,3,
4.’’
If thepasscodeiscorrect,HFL
responds ‘‘System is unlocked.’’
If thepasscodeisnotcorrect,please
try again according to the HFL’s
guidance.
You can also select a ‘‘System Clear’’
command to reset HFL (see page ). Press and release the Talk button.
Af ter the beep, say ‘‘System setup.’’
HFL responds ‘‘System setup
options are security, change
passcode, call notif ication, auto
transf er, and clear. Press the Talk
button and say a command.’’
Press and release the Talk button.
Af ter the beep, say ‘‘Change
passcode.’’
HFL responds ‘‘What is the f our
digit number you would like to set
as your security passcode? Press
the Talk button and say the
number.’’
Press and release the Talk button.
Af ter the beep, say your f our digit
passcode,forexample,say‘‘1,2,3,
4.’’
Press and release the Talk button.
Af ter the beep, say ‘‘Yes.’’
1.
2.
3.
5.
1.
2.
3.
417
To enter your passcode, do this; To change your security passcode, do
this:
CONT INUED
BluetoothHandsFreeL ink(Models without navigation system)
Features
405
\f—\f—y
y
) \f\fy\f
\fy
2009 TL

Move the interf ace selector down
to select the ‘‘Phone setup’’ screen,
or press the Talk button and say
‘‘Phone setup.’’ HFL responds
‘‘Please select the phone setup
item.’’
Rotate the dial to select ‘‘Search
for next phone’’ and press ENTER,
or press the Talk button and say
‘‘Search f or next phone.’’HFL attempts to connect with
another paired phone, and the
message ‘‘Searching f or a Bluetooth
phone’’ appears.
If the above screen is displayed,
pairing has f inished. You can make calls using any phone
number or by using a name in the
HFL phonebook. You can also redial
f rom an incoming or outgoing
number. During a call, HFL allows
youtotalkupto30minutesafteryou
set the power mode to VEHICLE
OFF (LOCK). Continuing a call
without running the engine may
discharge and weaken the vehicle’s
battery.
For more inf ormation on how to
select the power mode, see page .
3.
178
CONT INUED
BluetoothHandsFreeL ink(Models with navigation system)
Making a Call
Features
433
\f—
—y
\f

y
) \f\fy\fy
2009 TL

Modif ying your vehicle, or installing
some non-Acura accessories, can
make it unsaf e. Bef ore you make any
modif ications or add any accessories,
be sure to read the f ollowing
inf ormation.
Your dealer has Acura accessories
that allow you to personalize your
vehicle. These accessories have
been designed and approved f or your
vehicle, and are covered by warranty.Bef ore installing any accessory:
Make sure the accessory does not
obscure any lights, or interf ere
with proper vehicle operation or
perf ormance.
Although non-Acura accessories may
f it on your vehicle, they may not
meet f actory specif ications, and
could adversely af f ect your vehicle’s
handling and stability. Bef ore installing any electronic
accessory, have the installer
contact your dealer for assistance.
If possible, have your dealer
inspect the f inal installation.
Do not install accessories on the
side pillars or across the rear
windows. Accessories installed in
theseareasmayinterferewith
proper operation of the side
curtain airbags.
Be sure electronic accessories do
not overload electrical circuits
(see page ) or interf ere with
proper operation of your vehicle.
When properly installed, cellular
phones, alarms, two-way radios, and
low-powered audio systems should
not interf ere with your vehicle’s
computer controlled systems, such
as your airbags, anti-lock brakes, and
tire pressure monitoring system. 599
A ccessories
A ccessories and Modif ications
Bef ore Driving
495
Improper accessories or
modifications can affect your
vehicle’s handling, stability, and
performance, and cause a
crash in which you can be hurt
or killed.
Follow all instructions in this
owner’s manual regarding
accessories and modifications.
\f—\f—y
y
) \f\fy\f\f\fy
2009 TL

Some examples are:Larger or smaller wheels and tires
can interf ere with the operation of
your vehicle’s anti-lock brakes and
other systems.
Removing parts f rom your vehicle,
or replacing components with non-
Acura components could seriously
af f ect your vehicle’s handling,
stability, and reliability.
Lowering your vehicle with a
non-Acura suspension kit that
signif icantly reduces ground
clearance can allow the
undercarriage to hit speed bumps
or other raised objects, which
could cause the airbags to deploy.
Raising your vehicle with a non-
Acura suspension kit can af f ect
the handling and stability. Modif ying your steering wheel or
any other part of your vehicle’s
safety features can make the
systems inef f ective.
If you plan to modif y your vehicle,
consult your dealer.
Non-Acura wheels, can cause
excessive stress on suspension
components and may not be
compatible with the tire pressure
monitoring system (TPMS).
Modif ying Your Vehicle
A ccessories and Modif ications
496
\f—\f—y
\fy
) \f\fy\f\f
y
2009 TL

In addition, the total weight of the
vehicle, all occupants, accessories,
cargo, and trailer tongue load must
not exceed the Gross Vehicle
Weight Rating (GVWR) or the Gross
Axle Weight Rating (GAWR). Both
areonalabelonthedriver’s
doorjamb.Store or secure all items that could
be thrown around and hurt
someone during a crash.
Do not put any items on top of the
trunk panel. They can block your
view and be thrown around the
vehicle during a crash.
Example 1
Example 2
Example 3
CONT INUED
Carrying Cargo in the Passenger
Compartment
Carrying Cargo
Bef ore Driving
499
Max Load (850 lbs)
Cargo Weight
(550 lbs)
Max Load (850 lbs)
Max Load (850 lbs) Cargo Weight
(250 lbs)
Cargo Weight
(100 lbs)
Passenger Weight
(150 lbs x 2 = 300 lbs)
Passenger Weight
(150 lbs x 4 = 600 lbs)
Passenger Weight
(150 lbs x 5 = 750 lbs)
\f—\f—y
\f
y
) \f\fy\f\fy
2009 TL

This section gives you tips on
starting the engine under various
conditions, and how to operate the
automatic transmission. It also
includes important inf ormation on
parking your vehicle, the braking
system, the Super Handling-All
Wheel Drive (SH-AWD
)system,
vehicle stability assist (VSA
), aka
electronic stability control (ESC),
system and the tire pressure
monitoring system (TPMS). ........................
Preparing to Drive .502
Starting the Engine (Models without Keyless .....................
Access System) .503
Starting the Engine (Models with Keyless .....................
Access System) .505
..............
Automatic Transmission .507
Driving with the Paddle
.......................................
Shif ters .512
Super Handling-All Wheel ...
Drive (SH-AWD
) System .517
...........................................
Parking .519
.............................
Braking System .520
...............
Anti-lock Brakes (ABS) .521
Vehicle Stability Assist (VSA
),
aka Electronic Stability ........
Control (ESC), System .523
Tire Pressure Monitoring ........................
System (TPMS) .526
...........................
Towing a Trailer .531
...................
Towing Your Vehicle .531
Driving
Driving
501
TM
TM
\f—\f—y
\fy
) \f\fy\f\fy
2009 TL

Make sure all windows, mirrors,
and outside lights are clean and
unobstructed. Remove f rost, snow,
or ice.Check the seat adjustment (see
page ).
Check the adjustment of the
inside and outside mirrors (see
page ).
Check the steering wheel
adjustment (see page ).
Make sure the doors are securely
closed and locked.
Fasten your seat belt. Check that
your passengers have f astened
their seat belts (see page ).When you start the engine, check
the gauges and indicators in the
instrument panel, and the
messages on the multi-inf ormation
display (see pages , and
).
Youshoulddothesechecksand
adjustments bef ore you drive your
vehicle:
Check that the hood is f ully closed.
Check that the trunk is f ully
closed.
Visually check the tires. If a tire
looks low, use a gauge to check its
pressure.
Check that any items you may be
carrying are stored properly or
f astened down securely.
3.
2.
1.
7.
8.
9.
4.
5. 6.
155
63 75
77
16
161
140
10. 11.
Preparing to Drive
502
——y
y
) yy
2009 TL

µ
Î
Î
This position mechani-
cally locks the transmission. Use
Park whenever you are turning of f or
starting the engine. To shif t out of
Park, you must press on the brake
pedal and have your f oot of f the
accelerator pedal. Press the release
buttononthefrontof theshiftlever
to move it.
To shif t f rom Park to any position,
pressfirmlyonthebrakepedal,and
pressthereleasebuttononthefront
of the shift lever, then move the
lever. You cannot shift out of Park
when the ignition switch is in the
LOCK (0) or ACCESSORY (I)
position. Models equipped with the
keyless access system have an
engine start/stop button instead
of an ignition switch. VEHICLE
OFF (LOCK) Mode is the
equivalent of LOCK (0) and
ACCESSORY Mode is the
equivalent of ACCESSORY (I).
For more inf ormation, see pages
and .
178180
:
Do this:
Press the brake pedal and
press the shift lever release
button.
Press the shift lever release
button.
Move the shift lever.
To shift from:
PtoR
RtoP
NtoR DtoS
StoD
DtoN
NtoD RtoNShif ting
Park (P)
Automatic Transmission
508
RELEASE BUTTON
\f—
—y
\f\f\fy
) \f\fy\f
y
2009 TL