window Alfa Romeo 8C 2009 Owner handbook (in English)
Page 84 of 223
82
4
A
B
REAR WINDOWThe rear window can be opened from the inside 
or outside of the vehicle. Press button 
A on 
the centre console to open it from the inside. 
The rear window may only be opened when 
the vehicle is stationary. The button can be 
deactivated after the doors have been locked.
To open the rear window from the outside, press 
the button 
B on the ignition key for at least 2 
seconds, thus releasing the lock.
To prevent accidental activation while driving, 
the rear window can only be opened when the 
vehicle is stationary.Raising the rear window is facilitated by the 
action of the gas struts. The struts are calibrated 
to ensure proper operation with the weights 
specified by the manufacturer. Arbitrary additions 
of objects (e.g. spoilers, trunk racks, etc.) can 
jeopardise proper operation and safety in the use 
of the rear window. 
CAUTION
To close the rear window push 
it down taking care not to crush your 
hands when the gas struts invert 
resistance.
CAUTION
When using the luggage 
compartment, never exceed the 
maximum loads allowed (see 
section on “Capacities and Technical 
Specifications”). Also check that 
the objects contained in the luggage 
compartment are arranged properly.
CAUTION
It is extremely dangerous and 
moreover prohibited by law to travel 
on the luggage shelf behind the seats. 
In the event of an accident, persons 
travelling in this position are more 
exposed to the risk of serious injury. 
Passengers must only travel seated in 
the vehicle seats, with the seat belts 
fastened properly. Always check that 
you and your passengers have your 
seat belts fastened correctly. 
Page 85 of 223
83
4
A
C
BEFORE YOU DRIVE
EMERGENCY OPENING
If necessary, the rear window can be opened by 
pulling the cable 
C positioned underneath the 
luggage shelf behind the seats.The cap is linked to the filler neck with a strap, to 
prevent it from being lost while refuelling.
The fuel tank door must be re-closed manually.
Before closing the fuel tank door, check that the 
fuel filler cap is fully tightened.
CAUTION
Do not bring open flames or lit 
cigarettes close to the tank filler neck: 
risk of fire!
Also avoid putting your face close to the filler so 
as not to inhale noxious fumes. 
FUEL TANK DOOR The fuel tank door is found on the right-hand rear 
side of the vehicle. To open the door, press on it 
as shown in the figure.
It may only be opened after deactivating the 
central door locking.
The cap’s hermetic seal may result in a slight 
pressure increase in the tank. Any hissing noise 
whilst the cap is being released is therefore 
completely normal.
When refuelling, the cap must remain attached 
to the door by means of the hook provided 
A. 
Page 86 of 223
84
4
B
OPERATION
Each time the ignition key is removed from 
position STOP the protection system activates 
the engine immobilizer.
Upon starting the engine, when the key is turned 
to MAR:
1)  If the code is recognised, the CODE 
 
warning light on the instrument panel turns 
off in one second, while the EOBD   
warning light turns off after about four 
seconds, after the ECU has completed its 
diagnostic cycle. The protection system has 
recognised the key code and deactivates the 
engine immobilizer. With the brake pedal 
depressed, pushing the START button, the 
engine starts.
2)  If the CODE   warning light remains on 
and the EOBD   warning light goes off 
after four seconds (ECU diagnostics) and 
illuminates again immediately afterwards, 
the code has not been recognised and the 
message “Electronic key not recognised” 
is displayed. In this case, it is advisable to 
turn the key back to position STOP and 
then back to MAR; If the immobilizer stays 
on, try with the other keys. If you are still  FUEL TANK DOOR 
EMERGENCY OPENING
If necessary, the fuel tank door can be opened 
by pulling the cable 
B housed in the luggage 
compartment, in the beauty case compartment
KEYSTHE ALFA ROMEO CODE 
SYSTEM 
In order to enhance protection against thefts, 
the vehicle is equipped with an electronic engine 
immobilizer system (Alfa Romeo CODE), which 
is automatically activated when the ignition key 
is removed.
Each starter key contains an electronic device 
which transmits a code signal to the Alfa Romeo 
CODE control unit, and engine ignition is enabled 
only if the key code is recognised by the system.
Two keys are provided with the vehicle. 
The key is used to:
-  start the engine
-  activate the central door locking system
-  deactivate/activate the passenger airbag 
(on vehicles equipped with manual 
deactivation system)
-  open the rear window
-  activate/deactivate the alarm system 
Page 89 of 223
87
4
STOPACC
MAR
A
BEFORE YOU DRIVE
IGNITION SWITCHThe ignition key can be turned to 3 positions:
STOP - Engine off, engine immobilizer and 
steering wheel lock activated, connected devices 
cut-out, except those that are not key-controlled 
(e.g. centralised door lock, rear window opening 
control, etc.). The key is removable.
ACC - Steering lock release position.
MAR - Engine start and driving position. All 
electrical devices can operate.START BUTTON
Hold the brake pedal depressed and press the 
START button 
A to start the engine.
When the engine has started, release the START 
button.
Avoid pressing the START button at length. 
For the starting procedure, see “Starting the 
Engine”.
CAUTION
If the ignition switch has been 
tampered with (e.g. attempted theft) 
have it checked at an authorised 
Service Centre of the Manufacturer’s 
Network before continuing driving.
CAUTION
When you get out of the 
vehicle, always remove the key 
to prevent someone inadvertently 
activating the controls.
Remember to apply the parking brake 
and, if the vehicle is on a hill, engage 
first gear.
If the vehicle is on a downward slope, 
engage reverse gear.
CAUTION
Never leave children 
unattended in the vehicle. 
Page 90 of 223
88
4
A
ELECTRONIC 
ALARM SYSTEMThe electronic alarm system has the following 
functions:
-  remote control of the centralised door 
locking/unlocking system
-  perimeter surveillance, detecting the 
opening of doors, engine/luggage 
compartment lids
-  motion surveillance, detecting intrusion in 
the passenger compartment
-  vehicle movement surveillance.WARNING: The engine immobilizer function is 
ensured by the Alfa Romeo CODE system, which 
is automatically activated when the ignition key 
is removed from the starter switch.
ACTIVATION
Press button 
A on the key to activate the alarm 
system:
-  the direction indicators fl ash once
- the system beeps;
-  the centralised door locking of the vehicle is 
activated and doors are locked.
The alarm system is active after approximately 
25 seconds and the alarm is activated when:
-  a door is opened 
-  the luggage compartment lid is opened
-  the engine compartment lid is opened
-  someone attempts to enter the vehicle from 
a window
-  the power supply is disconnected
-  the siren is disconnected
-  the vehicle is moved.When the alarm is active, the user may request 
the luggage compartment opening; in this 
case, the motion and inclination sensors are 
temporarily deactivated. 
If the luggage compartment is then closed, the 
sensors will be reactivated.
Should the direction indicators flash 9 times 
when you activate the alarm system, this means 
that one of the doors or lids is not properly closed 
and therefore is not protected by the perimeter 
surveillance. Check for correct closing of doors, 
luggage/engine compartment lid and close the 
open one without deactivating the alarm system: 
direction indicators flashing once indicate that 
now the door, luggage/engine compartment 
lid are closed properly and are protected by the 
perimeter surveillance. 
Page 105 of 223
103
4
BEFORE YOU DRIVE
A)  Adjustable central and side vents.B)  Air conditioning and heating system 
controls.C)  Air vents for foot area.D)  Fixed air vents for side windows.E)  Fixed air vents for windscreen.
The vehicle is equipped with an automatic dual-
zone air conditioner/heater,
which adjusts the air temperature, its distribution 
and flow in the passenger compartment in two 
separate zones: driver side and passenger side.OPERATING MODES
Automatic
This mode automatically adjusts humidity 
and ventilation according to the selected 
temperature.
Partially Automatic
This is used to adjust certain parameters 
manually, while others remain automatic.
Manual
This mode allows the user to set different values 
as desired.  
Page 106 of 223
104
4
AB
D
F
H
J
C
E
G
I
Controls A)  Left-hand temperature controlB)  Air conditioning compressor activation/
deactivationC)  Left-hand air distribution controlD) Windscreen defogging/demistingE)  Fan speed adjustmentF) Recirculation functionG)  Right-hand air distribution controlH) 
Rear window and external rear-view mirror 
defogging/demisting
I)  Right-hand temperature settingJ)  Residual heat function. 
Page 108 of 223
106
4
 
Residual heat function J
This function allows the user to maintain the 
temperature set for the passenger compartment 
for a certain time (15 minutes), even after the 
key has been turned to STOP. To activate this 
function, push the “REST” button before turning 
the key to STOP. 
Once selected, this function is activated when 
the key is turned to STOP and sets the following 
features: 
-  bilevel air distribution 
- compressor deactivation 
-  minimum fan speed 
-  air recirculation activation 
-  water recirculation pump activation 
The system is deactivated after 15 minutes or 
when the key is turned to MAR. 
In addition, the REST function will be disabled 
(if active), when the battery voltage is below 
11.5V. When the outside temperature is above 
25°C it will not be possible to activate the 
function. 
 
Air recirculation switch F
Released
the air flow comes from the outside.
When outside temperatures exceed 35 °C, 
the air recirculation option remains on with a 
120-second pause every twenty minutes, to 
refresh the air.
Pressed (LED on)
The air flow comesfrom inside the passenger 
compartment. 
The recirculation speeds up air heating or 
cooling.
Prolonged use is not advisable.
 
Windscreen defogging/
demisting switch D
Press this switch (LED on) to activate 
windscreen defogging/demisting.
To deactivate this function, press the switch.
 
Defogging/demisting switch 
H for rear window and 
external rear-view mirrors
It is activated by operating the switch 
H and 
activation is signalled by the LED.
If it is not deactivated within thirty minutes 
after activation, this function deactivates 
automatically. 
It is however advisable to deactivate it once the 
defogging/demisting process is complete.
Once the internal temperature has stabilised at 
the desired level, you are advised not to change 
the position of the selector unless the external 
temperature changes drastically.
A change in the position of the temperature 
selection switch will involve a difference 
between temperature inside the passenger 
compartment and the air coming out of the 
vents. This difference will gradually decrease as 
the system works at full, stabilised speed. 
Page 116 of 223
114
5
MAR
STARTING THE 
ENGINE
CAUTION
Hold the brake pedal depressed 
when starting the engine.
CAUTION
It is dangerous to operate the 
engine in an enclosed space. The engine 
consumes oxygen and discharges 
carbon dioxide, carbon monoxide and 
other toxic gases.
WARNING: Before start-up, switch off the 
electrical devices with a high power consumption 
(air-conditioning and heating system, heated 
rear window, headlights, etc.).
WARNING: Do not start the engine if the fuel 
level in the tank is low.
1)  Make sure that the parking brake is applied 
and that the doors are closed.
2)  Hold the brake pedal depressed when 
starting the engine.
3)  Do not depress the accelerator pedal.
4)  Set the gear to neutral by pulling both 
paddles UP and DOWN towards the 
steering wheel and check that the gear 
display indicates N not fl ashing.
5)  Turn the ignition key to MAR.
6) press button START button and release it as 
soon as the engine starts.
Do not hold the START button for a long time.If the engine does not start, turn the key back to 
position STOP and wait for the gear display to go 
off before retrying.
The engine can also be started with a gear 
engaged; turning the key to position MAR, with 
the brake pedal depressed, press the START 
button. The system allows the clutch to open and 
the gearshift to engage neutral gear; then the 
starter motor receives clearance for start-up. This 
procedure usually requires one second. At very 
low temperatures, the procedure could take a 
slightly longer time.
If the gearbox is instead in the N position, 
starting is immediate.
If the engine does not start after turning the key 
to position STOP, wait for the gear display to go 
off and then repeat the entire procedure. 
Page 165 of 223
163
6
IN AN EMERGENCY
Relays in the passenger compartment, to the left of the steering wheelPos. Type Function
T01 Micro-relay 30A Low-beams
T11 Micro-relay 30A Heated rear window
T12 Micro-relay 30A Connected devices 1 
T13 Maxi-relay 50A Connected devices 2 
Fuses inside the passenger compartment, to the left of the steering wheel 
Pos. Amp. Colour System / Component
F12 15A Light blue +30 Right-hand low beam
F13 15A Light blue +30 Left-hand low beam
F31 7.5A Brown INT/A For A.C. unit NBC (Body Computer Node)
F32 10A Red +30 dome lights, step lights, CAV, driver- and passenger-side footwell lights
F33 20A Yellow Position available
F34 20A Yellow Position available
F35 7.5A Brown +15 engine signals, coils R5, R6, R9, R24, SCC, door locking/unlocking control
F36 10A Red +30 NQS
F37 10A Red +15 NQS, left-hand and right-hand headlights
F38 15A Light blue Rear window lock