heating Alfa Romeo GT 2006 Owner handbook (in English)

GETTING TO KNOW YOUR CAR
24
POWER WINDOWS
For some versions, the power windows
are fitted with a safety system with crush-
prevention seals. The electronic control
unit that operates the system is capable of
detecting the presence of an obstacle dur-
ing the window closing motion through
the special seals. Should this occur, the
system stops the movement of the win-
dow and reverses it immediately.IMPORTANTIf the crush-prevention
function is operated for 3 times in 1
minute, the system automatically sets to
the “recovery” mode (self-protection). To
reset the correct system operating logic,
press the control button until full window
opening. The logic is reset and if there are
no faults, the window winder automatical-
ly resumes normal operation; if not con-
tact Alfa Romeo Authorised Services.
IMPORTANTWith the ignition key at
STOPor removed, the power windows
remain activated for about 3 minutes and
are deactivated immediately the moment
a door is opened.
Driver’s side (fig. 33)
The driver’s door panel contains the but-
tons that control the following windows,
with the ignition key at MAR:
A- left front window
B- right front window.
Press the button to lower the window.
Pull to raise it. Defrosting/demisting
(fig. 31-32)
The electric mirrors are fitted with heat-
ing coils which come into operation with
rearscreen heating pressing the button
(A) thereby defrosting and/or demisting
the mirrors.
IMPORTANTThe function is timed
and automatically switched off after a few
minutes.
fig. 32
A0A0612b
fig. 31
A0A0042b

GETTING TO KNOW YOUR CAR
29
Pre-tensioning devices
can only be used once. Af-
ter they have been trig-
gered contact Alfa Romeo Autho-
rised Services to have them re-
placed. The validity of the device is
10 years from the date of produc-
tion on the sticker; the pretension-
ers should be changed at an Alfa
Romeo Authorised Service as this
date approaches.
Operations involving
banging, vibrations or
heating (above 100°C for
a maximum of 6 hours) in the area
of the pretensioners may damage
or trigger off the device. Vibrations
from rough road surfaces or acci-
dental jolting caused by mounting
pavements etc. do not have any ef-
fect on the pretensioner. If, how-
ever, you need assistance, go to Al-
fa Romeo Authorised Services.
fig. 40
A0A0675b
LOAD LIMITERS
To increase passengers’ protection in the
event of an accident, the front and rear
(where provided) seat belt reels contain a
load limiter which allows controlled sag in
such a way as to dose the force acting on
the shoulders and chest during the belt
restraining action in case of a crash.
GENERAL INSTRUCTIONS
FOR THE USE OF THE SEAT
BELTS
All the occupants of the car are obliged
to respect the local traffic laws regarding
the wearing of seat belts.
Always fasten the seat belts before start-
ing.
Seat belts are also to be worn by expec-
tant mothers: the risk of injury in the case
of accident is greatly reduced for them
and the unborn child if they are wearing a
seat belt. Pregnant women must of course
position the lower part of the belt very low
down so that it passes under the abdomen
(as illustrated in fig. 40).

GETTING TO KNOW YOUR CAR
52
DASHBOARD
(As concerns right-hand drive versions, see dashboard and instrument panel controls described in the dedicated paragraph at the end of this
manual)
1. Side swivel air vents - 2. Fixed side window air vents - 3. Outer light control lever - 4. Speedometer with mileage recorder and trip recorder and headlamp
aiming display - 5. Fuel level gauge with reserve warning light - 6. Multifunction display - 7. Engine coolant fluid temperature gauge - 8. Rev counter - 9. Tail-
gate release button - 10. Car holder (for versions/markets where applicable) - 11. Radio (for versions/markets where applicable) - 12. Centre swivel air
vents - 13. Fixed upper vent - 14. Glass holder (for versions/markets where applicable) - 15. Fog lamp button - 16. Hazard warning light switch - 17. Rear
fog guard button - 18. Passenger’s front Air bag - 19. Glove-box - 20. Door locking button - 21. Controls for heating, ventilation and climate control - 22. Cig-
ar lighter/ashtray cover - 23. Temperature sensor - 24. Windscreen wiper control lever - 25. Ignition key and switch - 26. Horn - 27. Steering wheel lock-
ing/release lever - 28. Driver’s front Air bag - 29. Set of controls: trip meter reset, headlamp aiming device, trip computer - 30. Bonnet opening lever.
fig. 67
A0A0618b

GETTING TO KNOW YOUR CAR
102
Below is a brief description of the manu-
al heating system.
To obtain best performance from manual
heater, set the knob pointer as shown in the
different figures.
For more detailed information about the
system and how to make the best use of
it, read the instructions given in the follow-
ing pages.
MANUAL HEATER
QUICK DEMISTING/DEFROSTING
MAXIMUM HEATING POWERA0A0730b
A0A0731b
fig. 93
fig. 94

GETTING TO KNOW YOUR CAR
103
CONTROLS(fig. 95)
1- Air temperature adjustment knob
2- Fan speed adjustment knob
3- Air distribution selector knob
4- Inside air re-circulation on /off button
v
5- Rearscreen heating on/off button (.
fig. 95
A0A0732b

GETTING TO KNOW YOUR CAR
104
AIR TEMPERATURE
ADJUSTMENT KNOB
Turn the ring of knob (1-fig. 95) clock-
wise or counter-clockwise respectively to
higher or lower the temperature of the air
admitted to the passenger compartment.
AIRDISTRIBUTION KNOB
Turning the knob ring (3-fig. 95), the
following positions are selected in sequence:
Air flow towards the upper centre,
front centre vents and from the front
and rear outlets with the possibility of ad-
justment using the controls on the actual
vents.
Splitting of air flow between the pre-
vious vents and the lower part of the
passenger compartment.
Air flow to the lower part of the pas-
senger compartment (front and rear).
Splitting of air flow between the
windscreen/front side windows and
the lower part of the passenger compart-
ment.
Air flow towards the windscreen and
front side windows for demist-
ing/defrosting.
Flow air to allow quick demist-
ing/defrosting of the windscreen
and front side windows, turning on
rearscreen heating for defrosting/demisting
(function called
MAX-DEF).
μ
w
≤
y
-
¥
FAN SPEED ADJUSTMENT
KNOB
Turning the ring of knob (2-fig. 95) it is
possible to select one of the fan speeds to per-
sonalise the amount of air admitted to the pas-
senger compartment.
Position0turns off the fan and automati-
cally engages inside air re-circulation (shown
by the lighting up of the led next to the but-
ton4
v) thereby shutting off the inlet of
outside air to the car.
To switch off inside air re-circulation, press
button (4)
v.

GETTING TO KNOW YOUR CAR
105
INSIDE AIR RE-CIRCULATION
ON/OFF BUTTON
Pressing button (4-fig. 95)vacti-
vates inside air re-circulation and the led next
to the button lights up.
In this case the climate control system di-
rectly treats the air contained in the pas-
senger compartment, the fan is on.
To switch the air re-circulation feature off
and withdraw air from outside, press the but-
ton again.The inside air- re-circula-
tion system makes it pos-
sible to reach the required
“heating” or “cooling” conditions
faster. It is however inadvisable to
use it on rainy/cold days as it
would considerably increase the
possibility of the windows misting
inside, especially if the climate con-
trol system is off.
It is advisable to turn on
the inside air re-circulation
system
vin queues or
tunnels to avoid admitting pollut-
ed air from outside. The prolonged
use of this function should howev-
er be avoided, especially with sev-
eral persons on board, to avoid the
possibility of the windows misting
inside.
REARSCREEN HEATING
ON/OFF BUTTON
Pressing the button (5-fig. 95) turns on
demisting/defrosting of the rearscreen, and
if present, the wing mirror heating coils; si-
multaneously the led next to the button
turns on. This function is timed and switched
off automatically after 20 minutes. To turn
off earlier, press the button again.
IMPORTANTThe system automatically
turns on rearscreen heating if the tempera-
ture is below 3
°C.
IMPORTANTDo not apply stickers on
the inside of the rearscreen over the heat-
ing filaments to avoid damage which might
cause it to stop working properly.
When cleaning the inside
of the rearscreen, take
care not to damage the
heating filaments.

GETTING TO KNOW YOUR CAR
106
DEMISTING
AND/OR DEFROSTING THE
WINDSCREEN AND FRONT SIDE
WINDOWS, REARSCREEN AND
WING MIRRORS
(MAX-DEF FUNCTION)(fig. 97)
Proceed as follows:
- turn the ring of the air distribution knob
(3)to the
-symbol.
The climate control activates all the functions
necessary to quicken demisting/defrosting of
the windscreen and side windows with tim-
ing (switching off automatically after 3 min-
utes), as follows:
- switches off air re-circulation, if engaged;
- sets the maximum air temperature;
- operates the fan at a predefined speed;
- directs the flow of air towards the wind-
screen and front side window vents;
- turns on rearscreen heating and, if pre-
sent, the wing mirror coils.When the max def function is on, the fol-
lowing are on: the led next to the rearscreen
heating button (5)
(.
IMPORTANTIf the engine is not hot
enough, the function does not immediate-
ly engage the pre-established fan speed, to
restrict the inlet of air to the passenger com-
partment that is not warm enough to demist
the windows.
After demisting/defrosting, simply use the
controls to maintain the optimum conditions
of vision and comfort.
IMPORTANTThe hotter the engine the
more effective defrosting will be.IMPORTANTIn cases of heavy damp
and/or rain and/or big differences in tem-
perature between inside the car and outside,
it is advisable to proceed as follows to
demist the windows:
- air re-circulation off, led next to button
(4)
voff;
- pointer of knob (2) at fan second speed
at least;
- pointer of knob (3) on symbol
≤with
the possibility of passing to position
yif
more misting is noted;
To defrost/demist the rearscreen, press
button (5)
(, led next to button on.
A0A0733b
fig. 97

GETTING TO KNOW YOUR CAR
107
HEATING (fig. 98)
To obtain the temperature required, pro-
ceed as follows:
- temperature adjustment knob pointer (1)
on the red sector as required;
- air quantity adjustment knob pointer (2)
on the fan speed required to personalise the
amount of air admitted;
- air distribution knob pointer (3) on the
required position.
To obtain the maximum heating power pro-
ceed as follows:
- knob pointer (1) as far as it will go clock-
wise (maximum temperature red sector);
- knob pointer (2) on maximum fan
speed;
- air distribution knob pointer (3) on the
required position (position
w) is recom-
mended.
IMPORTANTTo be able to obtain sat-
isfactory passenger compartment warming,
the engine should have reached normal op-
erating temperature.The filter has the specific capability of com-
bining the mechanical filtering of the air with
an electrostatic effect so that the outside air
admitted to the passenger compartment is
purified and free of particles such as dust,
pollen, etc.
In addition to the above mentioned func-
tions, is also reduces the concentration of
pollutants.
The filtering action is active in all air inlet
conditions and it is clearly more effective
with the windows closed.
Have the conditions of the filter checked
at least once a year, preferably at the on-
set of summer by Alfa Romeo Authorised
Services.If the car is habitually used in dusty or pol-
luted areas, the filter should be checked and
replaced at shorter intervals than those spec-
ified in the Programmed Maintenance
Schedule.
If the filter is not replaced
the efficiency of the cli-
mate control system may
be seriously compromised up to
blocking the air flow at the outlets
and vents.
POLLEN FILTER
(for versions/markets where applicable)
A0A0734b
fig. 98

GETTING TO KNOW YOUR CAR
110
CONTROLS(fig. 100)
1- Inside temperature set display (driver’s
side)
2- Inside temperature adjustment knob
(driver’s side)
3- Fan speed set and system off display
(
OFF)
4- Knob for adjusting the fan speed and
switching the system off
5- Inside temperature set display (pas-
senger’s side)
6- Inside temperature adjustment knob
(passenger’s side)
7- Maximum defrosting/demisting
on/off button for windscreen and front side
windows, rearscreen heating and wing mir-
ror coils (
MAX-DEF FUNCTION)
8- Inside air re-circulation on/off button
v(manual/automatic)
9- Rearscreen heating and wing mirror de-
frosting on/off button
(
10- Air distribution selection buttons11- Inside air temperature sensor
12- Button for aligning the temperature
set on the passenger’s side with that on the
driver’s side
MONO
13- Button for selecting the system au-
tomatic mode
AUTO
14- Climate control compressor on/off
enable button
√
fig. 100
A0A0090b