warning AUDI A3 1995 8L / 1.G ATW Engine Diagnostic Trouble Code Table Workshop Manual

Page 1 of 40

01-19
Diagnostic Trouble Code (DTC) table Note:

When malfunctions occur in monitored sensors or components, Diagnostic Trouble Codes (DTCs) are stored in DTC
memory with a description of the malfunction type.
"E-Gas"-relevant malfunctions are also indicated in the instrument cluster by the warning lamp for Electronic Power
Control ("EPC warning lamp"); Notes for E-gas system Page 24
-113
.
Malfunctions that worsen emissions are also indicated by an exhaust warning lamp (MIL) that is also located in the
instrument cluster. There are malfunctions that cause the exhaust warning lamp to light up immediately after recognition.
Malfunctions can also occur that do not cause the exhaust MIL to light up immediately, but only if malfunction is
recognized again after repeated engine starts. Meaning of exhaust MIL Page 01
-3 .
The DTC table is organized by the 5 digit code at left.
If a stored DTC does not recur within the next 40 warm-up cycles, the DTC will be erased automatically.
Malfunctions that occur only sporadically (temporary malfunctions) are are identified by the letters "SP" (sporadic
malfunction) on the VAG1551 scan tool display. The word sporadic means "appearing or occurring at irregular intervals,
occasional".
Do not immediately replace components that the VAG1551/VAS5051 suggests are faulty, instead: Check wire
connections and harness connectors to these components according to wiring diagram. Also check Ground (GND)
connections according to wiring diagram. This is particularly valid when malfunctions are displayed as "sporadically
occurring" (SP).
Pa
ge 1 of 40 Dia
gnostic Trouble Code
(DTC
) table
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.01.3

Page 37 of 40

01-46

DTC
DTC text
Corrective action
SAE
VAG


P1612 18020 Engine Control Module (ECM)
incorrectly coded
1) - Code Engine Control Module (ECM) Page 01
-62
P1624 18032 Request for warning lamp on
active
1)
Repair Manual, 5 Spd. Automatic Transmission 01V On Board
Diagnostic (OBD), Repair Group 01
- Exhaust related malfunction of Transmission Control Module
(TCM)
- Check DTC memory of Transmission Control Module (TCM)
P1626 18034 Powertrain databus
Missing message from Transmission
Control Module (TCM) - Check data transfer between Engine Control Module (ECM) and
other CAN capable control modules Page 24
-169

1) The Transmission Control Module (TCM) recognized a malfunction that worsens engine emissions. The Transmission
Control Module (TCM) sends the DTC to the Engine Control Module (ECM), which then switches on the Malfunction Indicator
Lamp (MIL) -K83-. Check Malfunction Indicator Lamp (MIL) -K83- Page 01
-3 . The message P1624 is simultaneously
stored in the Engine Control Module (ECM) as evidence that the Malfunction Indicator Lamp (MIL) -K83- was not switched on
due to an engine problem but rather a transmission problem.
Pa
ge 37 of 40 Dia
gnostic Trouble Code
(DTC
) table
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.01.3

Page 40 of 40

Implausible message from ABS
control module
Note:
Fault light for power accelerator activation -K132- (in wiring diagrams, referred to as: fault light for e-gas activation -K132-) is
also called the EPC warning lamp.
Pa
ge 40 of 40 Dia
gnostic Trouble Code
(DTC
) table
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU06.01.3