engine AUDI A4 1995 B5 / 1.G 01A Transmission Final Driveshaft Service Workshop Manual
Page 5 of 10
39-71
Driveshaft, removing and installing
Special tools and equipment
3298 alignment fixture for all wheel drive
driveshaft
3139/2 adapter
- Observe all cautions Page 39
-68
.
Removing
- Remove crossmember under exhaust system (if
installed).
- Remove rear section of exhaust system located
rearward of exhaust pipe clamp(s).
Repair Manual, Engine Mechanical, Repair
Group 26
Pa
ge 5 of 10 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.8
Page 10 of 10
39-76
- Align exhaust system free of stress.
Repair Manual, Engine Mechanical, Repair
Group 26
Tightening torques
Component
Tightening
torque
Driveshaft to transmission 55 Nm (41 ft
lb)
Driveshaft to final drive 55 Nm (41 ft
lb)
Center driveshaft bearing to
body 23 Nm (17 ft
lb)
Heat shield for driveshaft to
transmission
23 Nm (17 ft
lb)
Front cross-piece below
exhaust system to body
25 Nm (18 ft
lb)
Nuts for exhaust pipe clamp 40 Nm (30 ft
lb)
Pa
ge 10 of 10 Driveshaft, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.39.8