check engine AUDI A4 1995 B5 / 1.G 01A Transmission Remove And Install Workshop Manual
Page 16 of 21
34-32
Installing
Install in reverse order of removal, note the
following:
- Clean input shaft splines and (in case of used
clutch plates) hub splines. Remove corrosion
and apply only very thin coating of lubricant G
000 100 on splines. Do not grease guide sleeve.
- Check clutch release bearing for wear, replace if
necessary.
- Coat contact surface of clutch slave cylinder
pivot rod with thin layer of copper grease, e.g.
381 351 TE.
- Threaded holes for mounting clutch slave
cylinder to transmission and shift lever to shift
rod must be cleaned of locking compound
residue using thread tap before installation .
- Make sure dowel sleeves for aligning
engine/transmission are installed in cylinder
block, install if necessary.
- Always replace self locking nuts.
Pa
ge 16 of 21 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.2
Page 17 of 21
34-33
- Lift up transmission until clutch slave cylinder with mounting bracket for
line/hose can be installed (arrow).
- Install intermediate plate (if applicable) between transmission and
engine onto appropriate engine dowel sleeves.
- Make sure intermediate plate is correctly positioned on engine.
- Install lower engine/transmission and starter mounting bolts, and install
starter Repair Manual, Electrical Equipment, Repair Group 27
- Before installing, use tap to clean threads in flange shaft for driveshaft
on transmission to remove traces of locking compound.
- Replace gaskets on drive axles and on front of driveshaft Page 39
-
69
.
- Install driveshaft Page 39
-71
.
- Check adjustment of shift rod and pivot rod, re-adjust if necessary
Page 34
-12
.
Pa
ge 17 of 21 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.2
Page 18 of 21
34-34
- Align exhaust system free of stress.
Repair Manual, Engine Mechanical, Repair
Group 26
- Check transmission oil level Page 34
-38
.
- After
connecting
battery,
enter anti-
theft code
for radio
Repair Manual,
Electrical Equipment, Repair Group 91
- Run power windows fully up by pressing
switches.
- Operate all power window switches again and
hold for at least one second in "close" position to
activate automatic one-touch function.
- Set clock to correct time.
Pa
ge 18 of 21 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM02.34.2