engine coolant AUDI A4 1995 B5 / 1.G 01W Transmission Remove And Install Workshop Manual
Page 2 of 20
34-19
Vehicles with 1.8T four-cylinder engine
- Disconnect wires/and harness connectors as follows:
1 - At solenoid valve for wastegate bypass regulator valve -N75-
2 - At Evaporative Emission (EVAP) canister purge regulator valve -N80-
3 - At power output stage -N122-
4 - At Mass Air Flow (MAF) sensor -G70-
- Disconnect hoses and remove air cleaner housing (arrows).
- Remove coolant expansion tank from bracket and lay to side.
Repair Manual, Engine Mechanical, Repair Group 26
Note:
Do not bend flex pipe on front exhaust pipe more than 10 . - Disconnect harness connector for Heated Oxygen Sensor (HO2S)
(arrow) and move wiring clear.
- Remove nuts securing turbocharger to front exhaust pipe.
Pa
ge 2 of 20 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.2
Page 3 of 20
34-20
Vehicles with 2.8 liter six-cylinder engine
All models - Remove intake air duct -A- (arrows).
- Unbolt coolant expansion tank -B- (arrows) and lay to one side.
- Remove Heated Oxygen Sensors (HO2S) on left and right exhaust
pipes using 3337 ring spanner 7-piece set and move clear to side.
- Remove engine/transmission mounting bolts accessible from above.
- Remove noise insulation panel (arrows).
Pa
ge 3 of 20 Transmission, removin
g and installin
g
11/19/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.TM01.34.2