start AUDI A4 1995 B5 / 1.G APB Engine Ignition System Checking

28-48
If all specifications are reached but the diode test
lamp does not flash (measurement taken
between terminals 1 and 2 without unplugging
connector and while operating starter):

- Replace relevant Hall sensor.
If specifications are obtained:

- Check wiring.

Checking wiring between hall sensor and
engine control module

- Connect VAG1598/31 test box to wiring harness
for engine control module. Do not connect to the
engine control module itself Page 24
-20
.

- Check wiring connection from Hall sensor to engine control module for
open circuit and/or short circuit to B+ or Ground (GND).
Pa
ge 55 of 64 I
gnition s
ystem, checkin
g
11/22/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU04.28.1