width AUDI A4 1997 B5 / 1.G APB Engine Cylinder Block Crankshaft And Flywheel Assembly Manual

13-39

Connecting rods and connecting rod
bearings, installing


Note:

Only replace complete sets of connecting
rods
Do not interchange connecting rod bearings.

Checking radial clearance - Before removing, mark positions of connecting rod bearing caps with a
felt pen or similar.
- Remove connecting rod bearing cap. Clean bearing cap and bearing
journal.
- Place a length of Plastigage corresponding to width of bearing on
bearing journal or bearing shell.
- Install connecting rod bearing cap and tighten to 20 Nm. Do not rotate
crankshaft.
- Remove connecting rod bearing cap again.
- Compare width of Plastigage with calibrated scale.Clearance when new
Wear limit
0.015 ... 0.062 mm 0.12 mm - Install new connecting rod bearing bolts.
Pa
ge 26 of 26 C
ylinder block, crankshaft and fl
ywheel, disassembl
y and assembl
y
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE05.13.2