oil AUDI A4 1997 B5 / 1.G AWM Engine Crankshaft Remove And Install Workshop Manual
Page 1 of 12
13-67
Crankshaft, removing and
installing Note:
When working on the engine, it should be secured
to the engine stand using the engine bracket VW
540 Page 10
-27
.
1 -
Bearing shell
For cylinder block with oil grooveDo not interchange used bearing shells
(mark). Install new bearing plates for cylinder block
with the correct color coding Fig. 2
,
Page 13
-72
2 -
Chain sprocket
For oil pump drive chainReplacing Page 13
-77
Pa
ge 1 of 12 Crankshaft, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.3
Page 2 of 12
13-68
3 -
Bearing shell
For bearing cap without oil grooveDo not interchange used bearing shells
(mark). The crankshaft bearing plates in the
bearing covers are supplied as spare part
with the color coding "yellow"
4 -
Thrust washers For bearing 3Different types for cylinder block and
bearing cap Note locating arrangement
5 -
65 Nm +
1/4 turn (90 ) further
Always replaceWhen measuring radial clearance of
crankshaft, tighten to 65 Nm but do not turn
further.
Pa
ge 2 of 12 Crankshaft, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.3
Page 11 of 12
13-77
Chain sprocket, removing and installing
Special tools and equipment
Removing
Sleeve 30-100Two-arm puller, commercially available.Protective gloves
- Remove oil pan Page 17
-11
.
- Removing front sealing flange Page 13
-56
.
- Disconnect chain wheel of oil pump, remove chain tensioner and chain
-Item 5 -, Page 17
-3 .
- Pull chain sprocket off crankshaft with puller -2- (Use a suitable washer
-1- to protect end of crankshaft).
Pa
ge 11 of 12 Crankshaft, removin
g and installin
g
11/21/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.GE06.13.3