sensor AUDI A4 1998 B5 / 1.G 01V Transmission Front Final Drive Service Workshop Manual
Page 4 of 37
39-8
 
  
23 - 
Seal 
For left drive flangeAlways replace   page 39
-13
24 - 
Drive gear 
For Speedometer Vehicle Speed Sensor 
(VSS) -G22- Installed position   page 39
-20
25 - 
Left drive flange 
Removing and installing   page 39
-13
26 - 
Mounting bracket for drive flange 
27 - 
Grooved ball bearing for drive flange 
Always replace   page 39
-13
28 - 
Snap ring 
29 - 
O-ring 
Square cross sectionRemove and install left drive flange to 
replace  page 39
-13
 
Pa
ge 4 of 37 Front final drive, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.2 
Page 11 of 37
39-15
      
Remove left drive flange  
     
-  Loosen bolt drive axle/wheel hub while the 
vehicle is still standing on its wheels. 
     
- Remove wheel.
     
-  Removing left drive axle: 
     
       Repair Manual, Suspension, Wheels, 
Steering, Repair Group 40; Drive axle, removing and installing
   
     
-  Place VAG1306 drip tray underneath.
    
Note:  
Oil must be syphoned from final drive, otherwise there is a risk that the 
gear oil could mix with the ATF.  -  Remove oil filler plug (arrow) and syphon off at least 0.5 L gear oil from 
final drive using VAG1358A. 
-  Remove heat shield for left drive axle.
-  Remove Speedometer Vehicle Speed Sensor (VSS)   page 38
-35
. 
- 
Remove harness connector bracket from mounting bracket for drive 
Pa
ge 11 of 37 Front final drive, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.2 
Page 17 of 37
39-20
      
Installing seal  
     
-  Coat outer edge and sealing lip of oil seal with 
gear oil. 
    
-  Drive in new seal to stop, without canting.
 
Installation position: The open side of the seal faces the 
transmission. 
    
Note:  
If necessary, coat contact surface with grease to affix drive wheel in 
installation position.  -  Set Speedometer Vehicle Speed Sensor (VSS) -G22- on drive flange 
(arrow). 
 
Installation position: The carriers at drive wheel must engage in 
grooves of drive flange 
Pa
ge 17 of 37 Front final drive, servicin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.AT01.39.2