display AUDI A4 1998 B5 / 1.G Airbag Service OBD Workshop Manual
Page 7 of 74
01-8
      
Airbag system On Board Diagnostic 
(OBD), initiating
 
     
Requirements 
     
Power supply and fuses for relevant system 
OK 
     
       Electrical Wiring Diagrams, Troubleshooting & 
Component Locations binder   
     
VAG1551 Scan Tool (ST) connected   page 01
-1 
     
Ignition switched on 
     
Notes:  
     Malfunctions which have only occurred briefly 
are classified as "Sporadic malfunctions" and 
are identified by the "/SP" on the right side of 
the display. 
     To eliminate these sporadic malfunctions, erase 
DTC memory before starting repair work. 
     Additional operating instructions can be 
Pa
ge 7 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2 
Page 9 of 74
01-9
 
Rapid data transfer 
HELP
Insert address word XX
    
Indicated on display  
Address word for the airbag system: 15  
-  Press buttons -1- and -5- to insert "Airbag" address word 15.
Rapid data transfer 
Q
15 - Airba
g
    
Indicated on display  
-  Press -Q- button to confirm input.
Rapid data transfer Scan Tool sends address word 15
    
Indicated on display  
Vehicles  1997:  
8A0959655D 
Airbag V AUDI  
D02 
Coding 00766 
WSC 06812
    
Indicated on display after about 5 seconds  
Vehicles 1997   up to 1999: VIN 8DXA 200 000  
8D0959655C 
Airbag 7  
AUDI D00 
Codin
g 00102 
WSC 06812
    
Vehicles 1999  : from VIN 8D XA 200 001   -  Indicated on display after approx. 5 seconds
8D0959655J 
Airbag Front+Side 
0004 
Coding 01106 
WSC 06812
    
-  Indicated on display after approx. 5 seconds:
   Front and side airbag or front and side curtain airbag
Pa
ge 9 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2 
Page 10 of 74
01-10
      
All vehicles  
     
- 
Press   button to advance through program 
sequence. Rapid data transfer 
HELP
Select function XX
    
Indicated on display  
Note:  
A list of available functions is printed out when the HELP button is 
pressed. 
On Board Diagnostic (OBD) functions  
The following functions are possible:  
01 - Check Control Module Versions   page 01
-41
   
02 - Check DTC Memory   page 01
-11
   
03 - Output Diagnostic Test Mode (vehicles 1997   1998 only   page 
01
-44
 ) (vehicles 1999   only   page 01
-46
 )  
05 - Erase DTC Memory   page 01
-137
   
06 - End Output   page 01
-139
   
07 - Code Control Module   page 01
-51
   
08 - Read Measuring Value Block   page 01
-57
   
Note:  
Pa
ge 10 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2 
Page 12 of 74
01-11
      
Check DTC Memory (scan tool function 
02)
 
     
Note:  
     The DTC display information is updated only 
when initiating the On Board Diagnostic (OBD) or 
"Erase DTC Memory" function 05. 
     
-  Switch printer on by pressing PRINT button 
(indicator lamp in button lights up). 
     
Carrying out "Check DTC Memory" function 
02  
Rapid data transfer 
HELP
Select function XX
    
Indicated on display  
-  Press buttons -0- and -2- to select "Check DTC Memory" function 02.
Rapid data transfer 
Q
02 - Check DTC Memor
y
    
Indicated on display  
-  Press -Q- button to confirm input.
X DTC recognized 
    
Indicated on display (number of stored Diagnostic Trouble Codes, DTCs).  
or:  
No DTC recognized 
    
If the message "No DTC recognized" is displayed, the program can be 
returned to the starting point by pressing the   button.  
Pa
ge 12 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2 
Page 13 of 74
01-12
 
Rapid data transfer  
HELP
Select function XX
    
Indicated on display  
If something else is displayed:  
 Scan tool operating instructions   -  Erase DTC Memory (function 05)   page 01
-137
 .
-  End Output (function 06)   page 01
-139
 .
-  Disconnect VAG1551 Scan Tool (ST) from Data Link Connector (DLC).
Pa
ge 13 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2 
Page 14 of 74
01-13
 Diagnostic Trouble Code (DTC) table, airbag system
 
Notes:  
 
In the following table, all the possible malfunctions that can be recognized by the airbag control module -J234- are listed 
according to their DTC code numbers. Existing malfunctions will be printed with their 5-digit DTC only if the VAG1551 
printer is switched on. 
 If a malfunction occurs persistently, the airbag Malfunction Indicator Lamp (MIL) -K75- will light up and remain lit until the 
malfunction is repaired and the DTC memory has been erased. 
 If a malfunction occurs only occasionally or if the DTC memory is not erased after a malfunction is repaired, the 
malfunction will be displayed as a sporadic malfunction. Such malfunctions are identified by the letters "/SP" to the right on 
the VAG1551 display and will cause -K75- to light up continuously. 
 Before replacing a component shown as malfunctioning, check the wiring to the component for short or open circuit 
according to the wiring diagram. 
 The three digit malfunction type number appearing next to the DTC is a data code which can be disregarded.
Pa
ge 14 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2 
Page 15 of 74
01-14
 
DTC  
  
  
VAG 1551 scan tool 
display  Possible cause  
Corrective action  
00532        
Supply voltage B+  
Supply voltage too low   
Battery discharged or faulty
 Short circuit in vehicle 
electrical system - Recharge or replace battery.
- Repair short circuit in vehicle electrical system.
00588        
Airbag Igniter-Driver 
Side-N95  
Resistance value too 
large   Open circuit in wiring
 Spiral spring faulty
 Driver-side airbag unit faulty
 Airbag control module -J234- 
faulty  Electrical Wiring Diagrams, Troubleshooting & Component 
Locations binder    - Repair wiring according to wiring diagram.
- Check spiral spring.
- Replace driver-side airbag unit.
- Replace airbag control module -J234-.
00588        
Airbag Igniter-Driver 
Side-N95  
Resistance value too 
small   
Short circuit in wiring
 Spiral spring faulty
 Driver-side airbag unit faulty
 Airbag control module -J234- 
faulty  Electrical Wiring Diagrams, Troubleshooting & Component 
Locations binder    - Repair wiring according to wiring diagram.
- Check spiral spring.
Pa
ge 15 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2 
Page 17 of 74
01-15
 
DTC  
  
  
VAG 1551 scan tool display  
Possible cause  
Corrective action  
00588       
Drivers side airbag igniter -N95- 
Short circuit to B+    
Wire damagedAirbag control module -J234- 
malfunctioning   
 Electrical Wiring Diagrams, Troubleshooting & 
Component Locations binder    - Repair wiring according to wiring diagram
- Replace airbag control module -J234-
00588       
Drivers side airbag igniter -N95- 
Short circuit to Ground    
Wire damagedDriver-side airbag unit 
malfunctioning Airbag control module -J234- 
malfunctioning   
 Electrical Wiring Diagrams, Troubleshooting & 
Component Locations binder    - Repair wiring according to wiring diagram
- Replace driver-side airbag unit
- Replace airbag control module -J234-
Pa
ge 17 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2 
Page 18 of 74
01-16
 
DTC  
  
  
VAG 1551 scan tool 
display  Possible cause  
Corrective action  
00589        
Airbag Igniter 1-Passenger 
Side-N131  
Resistance value too large  
  
Open circuit in wiringPassenger-side airbag unit 
faulty Airbag control module -
J234- faulty  Electrical Wiring Diagrams, Troubleshooting & 
Component Locations binder    - Repair wiring according to wiring diagram.
- Replace passenger-side airbag unit.
- Replace airbag control module -J234-.
00589        
Airbag Igniter 1-Passenger 
Side-N131  
Resistance value too small  
Short circuit in wiringPassenger-side airbag unit 
faulty Airbag control module -
J234- faulty  Electrical Wiring Diagrams, Troubleshooting & 
Component Locations binder    - Repair wiring according to wiring diagram.
- Replace passenger-side airbag unit.
- Replace airbag control module -J234-.
Pa
ge 18 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2 
Page 19 of 74
01-17
 
DTC  
  
  
VAG 1551 scan tool display  
Possible cause  
Corrective action  
00589       
Passengers side airbag igniter 1 -
N131- Short circuit to B+  
Wire damagedAirbag control module -J234- 
malfunctioning  Electrical Wiring Diagrams, Troubleshooting & 
Component Locations binder    - Repair wiring according to wiring diagram
- Replace airbag control module -J234-
00589       
Passengers side airbag igniter 1 -
N131- Short circuit to Ground  
Wire damagedPassenger-side airbag unit 
malfunctioning Airbag control module -J234- 
malfunctioning  Electrical Wiring Diagrams, Troubleshooting & 
Component Locations binder    - Repair wiring according to wiring diagram
- Replace passenger-side airbag unit
- Replace airbag control module -J234-
Pa
ge 19 of 74 Airba
g system 
(with and without side airba
g)
 On Board Dia
gnostic 
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.2