light AUDI A4 1998 B5 / 1.G ATQ Engine Ignition System Checking Workshop Manual
Page 12 of 65
28-10
Checking Ground (GND) supply of power
output stage
If LED does not light up:
Electrical Wiring Diagrams, Troubleshooting & Component Locations
binder - Connect VAG1527B voltage tester as follows:Harness connector
Terminal
Measure to
2 B+
LED must light up.
- Check the wire connection for open circuit:
- Repair open circuit if necessary.
Pa
ge 12 of 65 I
gnition s
ystem, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.28.1
Page 13 of 65
28-11
Checking voltage supply to ignition coils
Note:
Voltage is supplied to ignition coils via Fuel
Pump (FP) relay.
Test requirement:
Fuse for ignition coils OK
Electrical Wiring Diagrams, Troubleshooting &
Component Locations binder
If LED does not light up: - Connect VAG1527B voltage tester as follows:Harness connector
Terminal
Measure to
1 Engine Ground (GND)
- Operate starter.
LED must light up.
- Check the wire connection for open circuit:
Pa
ge 13 of 65 I
gnition s
ystem, checkin
g
11/23/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.FU05.28.1