clutch AUDI A4 1998 B5 / 1.G Brake Pedal Remove And Install Workshop Manual

Page 1 of 10

46-46


Brake pedal, removing and
installing
Removing and installing vacuum servo unit with
brake master cylinder page 47
-34


CAUTION!
Before disconnecting the hydraulic line, protect the plenum chamber
from brake fluid flowing out. - Unbolt hydraulic line -1- for clutch master cylinder.
- Disconnect supply hose from elbow of master cylinder.

- Remove nut -1- at universal joint.
-
Loosen eccentric by turning bolt (Torx T50) clockwise, and remove
bolt.
Pa
ge 1 of 10 Brake
pedal, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.46.7

Page 4 of 10

46-49

Installing

CAUTION!

Do not remove safety wire or other
removal/installation aids from steering
column until after the universal joint has been
re-installed on the steering gear pinion.

- Install pedal assembly onto joint pin.

Note:
Do not tighten hex socket-head bolt (arrow) for attaching pedal assembly
to instrument panel member until after installing the brake servo unit.
After installing: - Install hex socket-head bolt (arrow) for attaching pedal assembly to
instrument panel member and tighten by hand.
- Attach accelerator pedal (AP) cable.
- Install brake servo unit page 47
-37
.
- Bleed brakes page 47
-23
.
- Bleed clutch Repair Manual, Manual Transmission 012 Front
Wheel Drive or Manual Transmission 01A All Wheel Drive, Repair
Group 30. -
Adjust brake light switch ( page 46
-50
) and CCS vent valves (
Pa
ge 4 of 10 Brake
pedal, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.46.7

Page 10 of 10

46-54

Cruise Control System (CCS) vent valve,
adjusting


- Insert vent valve into clip and push through to
stop.

- Push back valve by pulling back brake pedal or
clutch pedal to stop.

Note:
Only install the valve one time, otherwise an
adequately tight fit cannot be assured.

Version with spring clip for the vent valve

- Same procedure as for the brake light switch
page 46-53
.
Pa
ge 10 of 10 Brake
pedal, removin
g and installin
g
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.SU03.46.7