ECO mode AUDI A4 1998 B5 / 1.G Interior Monitor Workshop Manual
Page 6 of 44
01-111
- Switch ignition on.
- Switch printer on by pressing PRINT button
(indicator lamp in button lights up).
- Press button -1- to select "Rapid data transfer"
operating mode 1. Rapid data transfer
HELP
Insert address word XX
Indicated on display
Address word for interior monitoring: 45
- Press buttons -4- and -5- to insert "Int. Monitoring" address word 45.
Rapid data transfer
Q
45 - Int. Monitoring
Indicated on display
- Press -Q- button to confirm input.
4B0951173 Int. Monitoring
D00
Coding 00101
WSC 06812
Indicated on display after about 5 seconds
Note:
A list of available functions is printed out when the HELP button is
pressed. -
Press button.
Pa
ge 6 of 44 Ultrasonic interior monitorin
g On Board Dia
gnostic
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.4
Page 28 of 44
01-128
Testing alarm signal
- Switch ignition off and remove ignition key.
- Connect VAG1551 Scan Tool (ST) ( page 01
-
1 ), and press buttons -4- and -5- to select "Int.
Monitoring" address word 45.
- Close all doors and open one side window.
- Lock vehicle by reaching through open window.
The anti-theft system horn confirms this, but
warning lamps do not light up.
- Wait 30 seconds until anti-theft system is
armed.
- Perform Output Diagnostic Test Mode ( page
01
-124
) and select control element test "Create
active alarm."
Notes:
It is also possible to test the alarm activation
signal without using the VAG1551 Scan Tool
(ST). To do this, carry out the first, third, fourth
and fifth procedure steps listed above.
Pa
ge 28 of 44 Ultrasonic interior monitorin
g On Board Dia
gnostic
(OBD
)
11/20/2002 htt
p://127.0.0.1:8080/audi/servlet/Dis
play?action=Goto&t
yp
e=re
pair&id=AUDI.B5.BD04.01.4